. If diene is used in excess for a Diels-alder reaction of a-phellandrene and malice acid, which side reaction would be expected? Use chemical equations to support your answer. 2. If methanol was used instead of diethyl ether as the reaction solvent and left tp reflux longer than necessary, what side reactions would you expect to happen. in the reaction flask. Use a chemical equation to support your answer.

. If diene is used in excess for a Diels-alder reaction of a-phellandrene and malice acid, which side reaction would be expected? Use chemical equations to support your answer. 2. If methanol was used instead of diethyl ether as the reaction solvent and left tp reflux longer than necessary, what side reactions would you expect to happen. in the reaction flask. Use a chemical equation to support your answer.

Organic Chemistry

8th Edition

ISBN:9781305580350

Author:William H. Brown, Brent L. Iverson, Eric Anslyn, Christopher S. Foote

Publisher:William H. Brown, Brent L. Iverson, Eric Anslyn, Christopher S. Foote

Chapter20: Dienes, Conjugated Systems, And Pericyclic Reactions

Section: Chapter Questions

Problem 20.44P

See similar textbooks

Similar questions

Show a detailed arrow pushing reaction for the Diels-Alder reaction between a-phellandrene and maleic anhydride. Be sure to show the Endo and exo isomers and show how each would be formed.
Draw a detailed arrow pushing reaction for the Diels Alder reaction between alpha-phellandrene and maleic anhydride. Be sure to show the endo and exo isomers and show how each would be formed.
The following excerpt is a commonly used lab procedure for a Diels-Alder reaction. Provide three specific reasons why the one here would not be classified as a green chemistry option compared to ours. Be sure to reference and explain the principles of green chemistry to support your response. excerpt- Place 2 g of maleic anhydride in a 50-mL Erlenmeyer flask and dissolve it in 8 mL of ethyl acetate by warming on a hot plate. Add 8 mL of hexane or petroleum ether, and then cool the solution in an ice bath. Obtain 2 mL freshly cracked cyclopentadiene and add it to the maleic anhydride solution. Swirl to mix. Wait until the product crystallizes from solution, then heat it on the hot plate to redissolve, and allow it to recrystallize. Collect the product by suction filtration, and record the melting point, weight, and percentage yield.
The Diels–Alder Reaction – A [4+2] Cycloaddition Used: - Maleic Anhydride - Furan Summarize the Rf values for the starting material and product. Explain any differences or similarities in the Rf values based on molecular structure. Are the Rf values useful in analyzing the reaction?
Consider the reaction of two compounds ‘A’ and ‘B’ which could make two possible diastereomers ‘AB’ and ‘BA’ (much like this week’s Diels Alder reaction). Hand-write your calculations and responses to the following questions and upload your work as a .jpg or .pdf file. Which of the two products (A or B) will form in greater abundance under thermodynamic control? Which will form in greater abundance under kinetic control? Explain your responses using a sketch of the reaction coordinate diagram for the reactions described above.
Imagine that you used isoprene as diene – in that case you don’t have to worry about assigning endo vs exo. Draw the "endo" and "exo" products of the Diels-Alder reaction between isoprene and maleic anhydride, and explain why the distinction is irrelevant here.
What is the major benefit of refluxing? Why might reflux conditions be required for this reaction (Friedel-Crafts Alkylation)?
If you began an experiment with 5.0 mL of cyclopentadiene and 5.16 g of methyl acrylate, and you then isolated 7.2 g of the Diels-Alder adduct, what would the per cent yield be for that experiment? Make sure that you take the “limiting reagent” into consideration in your calculations.
Please answer both parts to the questions completely. I will rate the answer afterwards. For a diels-alder reaction between anthracene and maleic anhydride, are the exo and endo forms of product 9,10-dihydroanthracene-9,10-ɑ,β-succinic acid anhydride different stereoisomers or are they the same molecule? Explain your answer by drawing the molecule. Would it be favorable to get a 1,4-adduct of anthracene and maleic anhydride? Why or why not? If the 1,4-adduct of anthracene and maleic anhydride had formed, would it have different exo and endo isomers? Yes or no and why?
The diene lactone shown in part (a) has one electron-donating group (¬OR) and one electron-withdrawing group(C“O). This diene lactone is sufficiently electron-rich to serve as the diene in a Diels–Alder reaction.(a) What product would you expect to form when this diene reacts with methyl acetylenecarboxylate, a strong dienophile?
What combination of diene and dienophile undergoes Diels-Alder reaction to give adduct?
Explain why butadiene sulfone was used in the Diels-Alder reaction with maleic anhydride? Why is excess employed in the reaction?