A traffic light hangs from a pole as shown in the figure ( Figure 1). The uniform aluminum pole AB is 7.40 m long and has a mass of 11.0 kg. The mass of the traffic light is 23.0 kg. Determine the tension in the horizontal massless cable CD. Figure 3.80 m C 37° A T = 距 ΑΣΦ Submit Request Answer Part B ? N Determine the vertical component of the force exerted by the pivot A on the aluminum pole. ΜΕ ΑΣΦ 1 of 1 Fp,vertical = B Submit Request Answer 000 Part C ? N Determine the horizontal component of the force exerted by the pivot A on the aluminum pole. Fp,horizontal= ΜΕ ΑΣΦ ? N

A traffic light hangs from a pole as shown in the figure ( Figure 1). The uniform aluminum pole AB is 7.40 m long and has a mass of 11.0 kg. The mass of the traffic light is 23.0 kg. Determine the tension in the horizontal massless cable CD. Figure 3.80 m C 37° A T = 距 ΑΣΦ Submit Request Answer Part B ? N Determine the vertical component of the force exerted by the pivot A on the aluminum pole. ΜΕ ΑΣΦ 1 of 1 Fp,vertical = B Submit Request Answer 000 Part C ? N Determine the horizontal component of the force exerted by the pivot A on the aluminum pole. Fp,horizontal= ΜΕ ΑΣΦ ? N

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter5: Newton's Law Of Motion

Section: Chapter Questions

Problem 65P: Consider the baby being weighed in the following figure. (a) What is the mass of the infant and...

See similar textbooks

Similar questions

an 817 kg construction bucket is suspended by a cable A that is attached at O to two other cables B and C, making angles u1 = 51.0° and u2 = 66.0° with the horizontal. Find the tensions in (a) cable A, (b) cable B, and (c) cable C. (Hint: To avoid solving two equations in two unknowns, position the axes as shown in the figure.)
There are two forces on the 1.19 kg box in the overhead view of the figure but only one is shown. For F1 = 15.7 N, a = 14.7 m/s2, and θ = 34.1°, find the second force (a) in unit-vector notation and as (b) a magnitude and (c) a direction. (State the direction as a negative angle measured from the +x direction.)
A picture frame hung against a wall is suspended by two wires attached to its upper corners. If the two wires make the same angle with the vertical, what must this angle be if the tension in each wire is equal to 0.75 of the weight of the frame?
The cable supporting a 2105 −kg−kg elevator has a maximum strength of 23260 N. What maximum upward acceleration can it give the elevator without breaking?
Solve Prob. 3.110, assuming that P = 138 N.(Reference to Problem 3.110):To test the strength of a 625 × 500-mm suitcase, forces are applied as shown. If P= 88 N, (a) determine the resultant of the applied forces, (b) locate the two points where the line of action of the resultant intersects the edge of the suitcase.
The archer aims to release the arrow. As the archer pulls the cord with his right arm, he applies a 540 N force with his left hand. Given: a = 200 mm b = 300 mm c = 400 mm 1. What is the resulting tension (N) in the upper cord? 2. Calculate the tension (N) in the lower cord? 3. How much force does the archer exert with his right arm?
The cable supporting a 30 kg box has a maximum strength of 294 N. What maximum downward acceleration can it give the box without it breaking?
Using the same force table that you used, a student was given two forces and asked to find a single force that would produce equilibrium with the two forces. The two forces were given by providing one of the components and the angle the force made with the positive x- axis. The two forces were as follows: Force 1: Fx = −2.70 N; Theta = 220.0 degreees Force 2: Fy = 3.20 N; Theta = 60.0 degrees (a) For each force, calculate the magnitude of the force and the mass required to produce it. (b) Calculate the mass and its angle of application to produce equilibrium with these two forces. Please specify your angle as counterclockwise positive with respect to the positive x-axis.
The magnitudes of the three forces are F1 = 1.6kN,F2 = 1.2kN and F3= 1.0kN. Compute their resulatant in the form (a) R=Rxi + Ryj+Rzkl and (b) R=Rλ
A man weighs 210 lbf at a location where g= 32.10 ft/s2. Determine his weight on the Mars, where g= 5.47 ft/s2.
What is the mass of a book that weighs 3 N at a location where g = 9.81 m/s2?
The helicopter view in Figure P1.70 shows two people pullingon a stubborn mule. Find (a) the single force that isequivalent to the two forces shown and (b) the force a thirdperson would have to exert on the mule to make the net force equal to zero. The forces are measured in units ofnewtons (N).