Question: a. Compute the overhaul volume.b. Compute the length of overhaul if total cost of hauling is P105,750.00c. Compute the total cost of borrow. A single summit mass diagram from station 0+100 to 0+800 of a proposed extension of highway hasthe following technical data:Mass ordinate of the initial limit of the economical distance = +600 m3Free haul distance = 50mLimit of Economical Haul = 450mCost of Borrow = P500.00 per cubic meterMass ordinate of station 0+100 = -80 m³Mass ordinate of station 0+800 = -130 m3Assume 20m per station

Answered: Image /qna-images/answer/af68be22-c046-4dd2-bee9-2d6cefadd1ae.jpg

Answered: a. Compute the overhaul volume. b.…

a. Compute the overhaul volume. b. Compute the length of overhaul if total cost of hauling is P105,750.00 c. Compute the total cost of borrow.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

In a proposed highway undergoing road earthworks, the given roadway cross-section notes are as follows:STA 20 + 100 3.00 1.50 1.00-8.50 0.00 6.50STA 20+ 300 2.20 1.20 2.60-7.70 0.00 8.10Width of the roadway is to be determined using side slope of xH:1V where x is the unknown horizontal sideof the slope. Show and draw plotted points of the cross-section of roadway each station. Calculate thefollowing:1. Total number of man-days to finish the earthwork job2. Total cost of machine rentals to finish the earthwork job.In the inventory of available heavy equipment on site are three (3) hydraulic excavators with bucket payloadcapacity each of 0.76m3 and one (1) hydraulic excavator with bucket payload capacity of 1.15m3. The hourlyproduction of each excavator with 100% efficiency are 149m3 and 196m3 respectively. Daily machine rentalfees for smaller capacity is 1,200 pesos while bigger capacity costs 2,200 pesos. Daily machine operationsis limited to 8 hours.
I'm enrolled in Surveying and we are working on Ditch Volume Calculation. I had to find the Horizontial Distance and Area of Trapizoid on 3 survey locations. Location 1: had a trapizoid area of 139.04 Locatoin 2: had a trapizoid area of 57.69 Location 3: had a trapizoid area of 43.43 Question 1: What is the area of each station in square feet? Question 2: What is the average area between stations:? Question 3: What is the distance between stations Volume (cubic feet) Question 4: If a dump truck has a bed that measures 5x8x20 how many truckloads will it take to cover (fill) the ditch? Thank you for any help in getting started.
Stations 5 + 100 and 5 + 120 are stations with regular trapezoidal sections (level sections) with base with of 12 m. and side slopes of 2:1. The area at station 5 + 120 is 66.5 sq. m. What is the top width of the section at station 5 + 100 if the volume between stations is 985 cu. m?
Given the following level section notes for stations 1+120 and 1+160: 1+120 | 6.6 | 0 | 7.6 | 0.8 | 3.7 | 1.3 1+160 | 74 | 0 | 98 | 1.2 | 2.3 | 2.4 The side slope is 2:1. The radius of curvature is 275 m. The center of curvature is on the right. a) What is the roadbed width? b) What is the area of section 1+120? c) What is the area of section 1+160? d) What is the volume between section 1+120 and 1+160 using end area method? e) What is the prismoidal volume correction? g) What is the centroid of excess of section 1+160? h) What is the correction due to horizontal curvature?
A pipeline transporting natural gas is to be laid out on the side of a hill (from pt. A to pt. B) as shown in the figure. Trigonometric leveling was performed where a transit (with a stadia factor of 100.8 and stadia constant of 0.38) was set at pt. C somewhere between pts. A and B. The following readings were observed. How long is the inclined section of the pipe? Determine the material cost of the inclined pipe to be installed if the material costs P 5,000/meter.
Given the triangulation figure shown which has already been adjusted. The length of the baseline EF is 8,243.26 meters. Determine the following: a) Strength of figure factors b) Distance angles and the equations for determining the length of GH by different routes c) Strength of figure for each chain of triangles d) Length of line GH using the strongest route
A surveyor starting from a point A moves N. 27°20′ E. a distance of 537′ 4.25″ to point B. Next, she moves N. 52°12′ E. a distance of 337′ 7.5″ to point C. Next, she walks S. 6°5′ W. a distance of 1197′ 3.25″ to point D. Finally, she returns to the starting point.What distance must she walk to return to the starting point? (Answer accurate to the nearest quarter inch.) _____ ft & ____ inchesWhat heading does she walk from the fourth point to return to the starting point? (Answer accurate to the nearest minute.)N. _____° ________′ W.What is the acreage of this plot of land?area = _______acreYour answer should be accurate to 3 decimal places.Notes:* the prime symbol in an angle represents minutes: 60′ = 1°* the prime symbol in a length represents feet; double prime = inches;* 1 acre = 4840 yd²* 1 acre = 43,560 ft²* an angle like N 20 E means 20 degrees east of north.
A 90m by 90m lot is to be divided into 9 equal square sections. The elevations of the ground surface at each corner of the square section are as follows: A=7.3m E=6.7m I=8.3m M=8.5m B=8.3m F=8.2m J=8m N=8.1m C=6.8m G=8.7m K=6.3m O=8.8m D=8.1m H=7.8m L=7.2m P=7.5m Find the volume to be excavated if the ground surface is to be leveled to elevation 5m.
A 120mx120m lot is divided into 9 equal sections. Find the volume (m3) to be excavated if the ground surface is to be leveled to elevation 10m. The elevations of the ground surface at each corner are as follows: A = 19.2m B = 15.3m C = 16.9m D = 19.5m E = 17.2m F = 17.6m G = 16.2m H = 15.1m I = 17.2m J = 18.6m K = 18.2m L = 17.5m M = 18.8m N = 17.1m O = 16.2m P = 17.9m Round your answer to 3 decimal places.
RN =51 Kindely solve as soon as possible.
The base and altitude of a triangle were measured with certain estimated probable errors as follows: b= 229.35 ± 0.18m and h=199.05 ± 0.15m , the true area of the lot probably
From the results of a hydrographic survey of a lake the following data were obtained. Aa = 1240.71 sq.m. (area enclosed by the boundary of the water surface) Ab = 752.79 sq.m. (area enclosed by contour B) Ac = 397.77 sq.m. (area enclosed by contour C) Ad = 178.44 sq.m. (area enclosed by contour D) Ae = 48.33 sq.m. (area enclosed by contour E) If the vertical distance (h) between contour levels is 1.50 m, determine the total volume of water in the lake above the level of contour E. Resolve the above problem if the vertical distance between contour levels is 2.0m. Which has a larger value of volume?