Check Your Understanding If you place a wire directly across the two terminal of a battery, effectively shorting out the terminals, the battery will begin to get hot. Wiry do you suppose this happens?
The reason for the battery getting heated while shorting out its two terminals.
Explanation of Solution
Introduction:
If a battery with internal resistor r is connected to a load resistor R, the load resistor is in series with the internal resistor. The equivalent resistance of the circuit becomes
Applying Ohm's law in the circuit
The magnitude of the current flowing through the resistor is,
Power consumed by a resistor,
Short circuit of battery occurs, if one connectsthe positive terminal of the battery to the negative terminal with highly conducting wire. Due to low load resistance, a huge amount of current starts to flow.
One can assume resistance of the connecting wire is zero, then the magnitude of the current flow through the circuit is
The power dissipated in internal resistance,
Conclusion:
Power dissipated in the internal resistance will generate heat, and the battery begins to get hot.
Want to see more full solutions like this?
Chapter 10 Solutions
University Physics Volume 2
Additional Science Textbook Solutions
College Physics (10th Edition)
University Physics Volume 1
Introduction to Electrodynamics
College Physics: A Strategic Approach (3rd Edition)
Physics for Scientists and Engineers: A Strategic Approach, Vol. 1 (Chs 1-21) (4th Edition)
Life in the Universe (4th Edition)
- All capacitors are uncharged before switch S is closed. What amount of much charge goes through points a and b after the switch is closed? 8M F 4MF 12V C 12puF -48 μC,-48 μC Ο 48 μc, -24 μC Ο 72 μC, +24 μC -48 μC ,-12 μ O +72 µC, +72 µcarrow_forwardcapacitor and take C = xe A/d and Q = CAV to investigate the charge as follows. Use typical values for a cylindrical axon of cell wall thickness d = 1.6 x 10-8 m, axon radius r = 2.0 x 10¹ μm, and cell-wall dielectric constant x = 2.2. Positive charge layer Negative { charge layer External fluid Axon wall membrane 1 O No O Internal fluid Axon radius = r + d Q (a) Calculate the positive charge on the outside of a 0.10-m piece of axon when it is not conducting an electric pulse. (Assume an initial potential difference of 7.0 x 10-2 v.) C How many K+ ions are on the outside of the axon assuming an initial potential difference of 7.0 x 10-2 V? K+ ions Is this a large charge per unit area? Hint: Calculate the charge per unit area in terms of electronic charge e per angstrom squared (A2). An atom has a cross section of about 1 A² (1 A = 10-10 m). (Compare to normal atomic spacing of one atom every few A.) Yesarrow_forwardCalculate how many electrons pass per second through a conductive wire connected to a 100W lamp at 127 V. Repeat calculations for a 100 W lamp at 220 V.arrow_forward
- iLearn Help - Resources - stion 20 Consider the circuit below. What is the charge on and the voltage across the capacitor labelled C2? yet vered nts out of + 12 V - Flag estion 4 uF C2 4 uF 4 µF Select one: O 24 microCoulombs, 12 V 24 microCoulombs, 4 V 24 microCoulombs, 6V O 24 Coulombs, 6 V MacBook Airarrow_forwardThe giant axon of a squid is 0.5 mm in diameter, 10 cm long, and not myelinated. Unmyelinated cell membranes behave as capacitors with 1 μF of capacitance per square centimeter of membrane area. When the axon is charged to the -70 mV resting potential, what is the energy stored in this capacitance?arrow_forwardNerve cells transmitelectric signals through their long tubular axons. These signals propagatedue to a sudden rush of Na+ ions, each with charge +e, into theaxon. Measurements have revealed that typically about 5.6 * 10^11 Na+ions enter each meter of the axon during a time of 10 ms. What is thecurrent during this inflow of charge in a meter of axon?arrow_forward
- A 1.5-uF capacitor in a television set is charged by a 22,000-V potential difference. To preventharm to the television repair technician, a large “bleeder” resistor is connected across thecapacitor’s ends. When the television set is turned off, the capacitor discharges through the bleederresistor rather than through the technician, who might accidentally touch its ends. (a) Calculate thetime needed to discharge 95 percent of the charge on the capacitor through a 1.0 MΩ resistor. (b)What is the total charge that must be discharged? Used the formula q=qf e -t/RCarrow_forwardIf you touch the terminal of a battery, the small area of contact means that the skin resistance will be relatively large; 50 kΩ is a reasonable value. What current will pass through your body if you touch the two terminals of a 9.0 V battery with your two hands? Will you feel it? Will it be dangerous?arrow_forwardSuppose a biological membrane with a specific capacitance of 1 μF/cm^2 has a resting surface charge density of 0.1 μC/cm^2. Also suppose there are 50 sodium channels per μm^2 and thatwhen each opens for 1 ms, 1000 Na+ ions flow through the channel, resulting in a reduction of the potential difference (the membrane voltage). Compare this membrane’s resting potentialvoltage to the membrane voltage 1 ms after 10% of these channels open, assuming no other changes occur during this time.arrow_forward
- In the circuit shown (a) find the charge on each capacitor; (b) voltage across each capacitor and (c) voltage of the battery. Voltage acioss suF= 6V. 4uF A 3MF tcarrow_forwardA 70 μF capacitor is fully charged by a 15 V battery. It is then disconnected form the battery and discharged thruh a 180 olhm resistor. If we define a capcitor to be fully discharged when ther is less than one elementary charge e on it, then how long does it take to fully discharge this capacitor?arrow_forwardWhy is it possible for a bird to sit on a high - voltage wire withoutbeing electrocuted? (See Fig. CQ18.9.)arrow_forward
- College PhysicsPhysicsISBN:9781285737027Author:Raymond A. Serway, Chris VuillePublisher:Cengage LearningPhysics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage Learning
- Principles of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning