Quiz Airport & Air Traffic Control Safety

What is the function of Positioning and Orientation System (POS – GNSS+IMU) in LiDAR system, when the LiDAR system is operated through moving platform, such as Aircraft, UAV, ground-based vehicle. Explain with relevant diagrams.

Briefly explain TNC-S earthing scheme as applied to earthing system design. (Hint: Support your answer with a well labelled diagram).

Airframe Electrical System Question: Name four wire types. (Source: FAA AC 43.13-1B/2B)

Please describes the superheterodyne receiver in terms of the type and sequence of components involved. Thanks!

ASAP. Ty

2.7-2.8 Theory

Airframe Electrical system Question: State the four common aircraft system voltages.   (Source: FAA AC 43.13-1B/2B)

1. The value of R^2=0.100 R2=0.100 corresponds to a ______________ effect size A. cannot be determined B. large C. small D. medium

You’re on the moon, skipping around, and your radio breaks. What would be the best way to communicate this problem to your friend, who is also skipping around on the moon: yelling or flashing a light? Why?

An over head transmission line supported from two towers. The high of the two towers are 30 m and 20 m respectively. The distance between the towers is 300 m. The tension in the wires is 7000 N. The weight of one meter of the conductor is 12 N. The horizontal distance between the long tower and point o (minimum center middle point)

18. Why are signals that are in quadrature said to be orthogonal?A. They do not interfere with each other.B. They split into two paths. C. They can shift to one of two predetermined phase states.4D. The amount of data that can be transmitted over time

In your own words and from your own understanding, avoid plagiarism or copying from the Course Material, explain or describe AIR-BLAST CIRCUIT BREAKER.

Q. When the LED’s in the given figure will be ON? Explain in detail. Circuit diagram is attached.

Airframe Electrical System Question: In general, describe and draw the construction of shielded electrical wire. (Source: FAA AC 43.13-1B/2B)

Airframe Electrical System Question: Name Three methods for marking wires. (Source: FAA AC 43.13-1B/2B)

Faaaast Which control strategy is better and why?

Notes : Pls solve with 350 words.

Question 7

It is the product of the antenna gain and the power applied to the antenna. (answer in acronym)

In induced noise, the impairment is created by sources like a. Motor & appliances b. Power lines c. the sending and receiving antenna d. Motion of electrons in wire

i need the answer quickly

Airframe Electrical System Question: What type of wiring method is most often employed in the design and operation of aircraft electrical and electronic system? (Source: FAA AC 43.13-1B/2B)

Question 3 and 4

Discuss in detail the construction of a Directional Coupler

I need the answer as soon as possible

Explain Base peak? Please answer at your own easy words. Answer should be to the point.

Airframe Electrical System Question: Name five areas in an aircraft that are considered "EWIS" areas. (Source: FAA AC 43.13-1B/2B)

The air interface connecting phones, antennas, and towers in mobile networks is completely devoid of wires and cables. Is there anything else required for the backhaul of cellular signals?