Lab5_Prelab_Guidelines_ECE225_Fall_2023

(electronics) Hello dear, I now have a very important test, and I need to answer in a short time, less than an hour And if you give me the answer within the specified time, I will like you on your answer and invite my colleagues also and thank you

I have one (1) AC source, four (4) diodes, and one (1) thyristor. In this case, I would like to obtain a full- controlled rectifier using these components; please describe the circuit?

I need a diagram of a circuit by the transform and rectification block, using the bridge rectifier circuit (KBJ1008). It can be a source of any value. You don't need to do any calculations, just a drawing of how this circuit will look, please.

I need a diagram of a circuit by the transform and rectification block, using the bridge rectifier circuit (4 diodes). It can be a source of any value. You don't need to do any calculations, just a drawing of how this circuit will look, please.

4. Please I want a solution of this question with all details. Many Thanks Note: It is preferable to solve by typing.

Give a brief introduction about the topic of generation and measurement of direct current voltage...(if possible for 2 pg or 1 pg) high voltage engineering subject..

Assume that an input signal is applied to the circuit given above, as shown in the figure next to it. Accordingly, answer the following questions. The diodes used are silicon diodes, their operating voltages are 0.7 volts, and can be omitted because their resistance is very small. a) Write the name of this circuit, thinking about which circuit we do in the courses is equivalent to the purpose. b) What are the diodes/diodes that are active in a positive half-loop? Please type. c) What are the diodes/diodes active in the negative half-loop? Please type. d) Calculate ? ?−???( ?? ) for this circuit.

Construct a 3 paragraph introduction about Kirchoff's Laws. (Voltage and Current Law). Also, give possible reasons for some discrepancies between the actual values of voltage and current and the manual computation of values.

This Multiple choice questions from electronics lab course &just write for me final answer ,It easy for you.

2. A full wave rectifier is used to convert 400 Hz ac todc Design a full-wave rectifier power supply that will deliver a dc outpuvoltages 15V and the load current is 1A. RSIT

Please solve this power electronics problem given, I have attached the parameters

Question 4) A full wave controlled rectifier with ohmic load given in the figure below feeds a 10 Q load and the effective (rms) value of the source voltage is 110V and its frequency is 60 Hz. Accordingly requested below Find the circuit parameters: a) the peak voltage of the source, b) the peak current of the load, c) Average stress of the load, d) Average current of the load, e) The effective (rms) voltage of the load, f) Effective (rms) current of the load, SCR 1 SCR 2 is R g) Power of the load SCR 3 t* SCR 4

if i want building power supply out 9v. full wave rectifier ,Consists of resistor and 2 capacitor and 4 dimes and transformer .what is the Equations and circuit diagram for it

Subject : ECE

The PMMC movement (basic meter) used in DC voltmeter can be effectively used in AC oltmeters also AC voltmeters can be designed in two ways explain the difference and sketch the diagram of the two ways. design an AC voltmeter of full range 100 Vrms Using Full Wave Rectifier with multiplier resistor and a basic meter of resistance 150 and full scale current 200μA. assist your answer with a diagram.