3.e) C term of the Van Deemter equation is affected by the change of mobile phase since it is

2. Explain your observations in detail in terms of concentration gradient, diffusion, osmosis, osmotic pressure, passive transport, and active transport.

A. The size of the molecule. The larger molecule will diffuse more slowly than the smaller molecule.

What two parameters are responsible for creating the movement (filtration and reabsorption) of fluid across the capillary wall?

In doing the lab, one was able to determine the characteristics of the given solutions, containing different macromolecules, whilst doing the multiple tests. The tests performed were,

Adsorption chromatography occurs when “one substance form[s] some sort of bonds to the surface of another one”, creating intermolecular forces between the two substances (Chemguide). For thin layer chromatography, the components of the mixture are adsorbed onto the stationary phase that covers the plate (Chemguide). The more polar a substance is, the more strongly adsorbed it is (Chemguide) and the strong intermolecular forces then result in a slower rate of migration with respect to the moving phase. As the solvent touches the TLC plate, the solute (mixture) is allowed to move up the TLC plate

These layers can be separated through the use of a seperatory funnel which drains the bottom layer into a separate container. This method uses the understanding of partition ratios of solutes to different paired solvents to produce an equilibrium leaning towards one solvent over another, thereby extracting a compound from one liquid to the other (Padias 128-37). For example, consider a mixture containing two solutes, solute A and solute B, and two immiscible solvents, solvent A and solvent B. If solute A dissolves well into solvent A, but not very well into solvent B, and solute B dissolves well into solvent B but not very well into solvent A, there would be a higher ratio of solute A in solvent A than in solvent B, and a higher ratio of solute B into solvent B than in solvent A. One can then see that, through the use of different solvents, two dissolved solutes can be separated from a mixture. This ratio of a solute concentration to different solvents is defined by K, the distribution constant. Successive filtrations yield’s a higher percentage of products.

1. What two parameters are responsible for creating the movement (filtration and reabsorption) of fluid across the capillary wall?

1. The relationship between rate of diffusion/ osmosis, volume, and surface area can be easily seen and analyzed through the data that was collected from procedure one: Surface Area and Cell Size. Phenolphthalein is a dye-material in this lab that was used to determine whether a substance was an acid or base. This could be told as the phenolphthalein changed into a murky. Muddled and clouded color when mixed with acids. When the chemical aid was mixed in with a base, the color

The difference is that along with large molecules, living cells prevent molecules with positive charges and solubility. This is not representing in dialysis tubing, and is only found in living cells because the tubing is only based on molecular size (98). When referring the rate of diffusion, the concentration gradient influences the diffusion rate, based on the factors of temperature. The ability for molecules diffuse from high to low concentrations primarily depends on the concentration gradient between the two areas.(96-99). My hypothesis for the study is that in the hypotonic, hypertonic, and isotonic solutions, the direction and rate of osmosis will determine based on the concentration inside the dialysis tubing. My prediction is that if the solution is hypotonic the results will decrease, if the solution is hypertonic the results will increase and if the solution is isotonic the solution will vary and or remain constant.

In this lab experiment we determined the kinetic rate constant for a solvoysis reaction and observed how a change in polarity of the solvents affects the reaction rate. For the specific reaction that we did in the lab we actually measured the formation of HCl since the rate of

The purpose of this experiment was to synthesize t-pentyl chloride from the reaction of t-pentyl alcohol and concentrated HCl. This reaction occurred through an SN1 reaction, a unimolecular nucleophilic substitution reaction. This was a First Order Rate Reaction where the rate of t-pentyl chloride was dependent only on the concentration of t-pentyl alcohol. After the reaction was completed, the products were achieved via 3 liquid-liquid extractions and then after by simple distillation. In the liquid- liquid extractions a solute was transferred from one solvent to another. Then in the simple distillation the miscible liquids or the solution, was separated by differences in boiling points. After this the product was determined through infrared spectroscopy.

The following hypothesis was made in regard to effect of the concentration gradient on the rate of diffusion: The higher the concentration gradient, the faster the rate of diffusion.

The eluting solvent passed down the column by the gravity and an equilibrium was established between the solute absorbed by the absorbent (silica gel in this experiment) and the eluting solving flowing down. Since the components in the sample had different polarity and they interacted with the stationary phase and the mobile phase differently, the components would be carried by the solvent to a different extent and a separation of the components could be achieved.

Hemolysis is the breaking apart of blood cells due to their hypertonic environment which causes the extracellular solutes to diffuse into the cell, in turn, results in swelling of the cell and eventually cell rupture. Molecules primarily cross cellular membranes by three methods; those being through lipid bilayers, aqueous channels, and carrier channels. The size, polarity, and charge of a particular molecule have a direct effect on the rate of diffusion of that molecule. As it relates to the diffusion of propanol, the number of hydroxyl groups within the molecules increased which caused the polarity of the to increase, which also

Chromatography is a separation technique in which the mixture to be separated is dissolved in a solvent and the resulting solution, often called the mobile phase, is then passed through or over another material, the stationary phase. The separation of the original mixture depends on how strongly each component is attracted to the stationary phase. Substances that are attracted strongly to the stationary phase will be retarded and not move alone with the mobile phase. Weakly attracted substances will move more rapidly with the mobile phase.