A Project On Using New Technology

1618 Words7 Pages
3. Project 1 Detail……….…………………………………………………………5
4. Project 2 Detail………………………………………………………………….7
5. Recommendation…………………………………..…………………………….8
6. Conclusion……………………………………………………………………….9
7. References……………………………………………………………………….10

Introduction:
There is a manufacturing company of medium sized which is working on increasing the prototype capability for its firm. The controversy is going in the selection process of the project among the two proposed project to achieve the goal of the company. The first proposed project was based on the traditional prototype used by the company. The project is tested and resulted with the low risk factor in the priority for increasing the capability of the prototype for the firm. The project follows all the ethics of the company and is based on according to the company’s culture and structure. Therefore no training program is required for the staff. The second project introduces new technique of 3D printing to enhance the prototype with high speed. It minimizes the cost of the project. The requirement of this project is a greater capital input. As the system is using new technology, therefore the training program is required for the employees. The risk factor rises up with the introduction of new prototyping system. If the new system is get successful then it will result with maximizing the profit for the firm. As the consultant I will go through projects by exploring their assumptions, advantages and disadvantages and then I
Get Access