Advantages And Disadvantages Of Diazonuim Salts

Procedure: In this experiment, various chemicals were mixed together, to determine a reaction. Using two drops from chemical 1 and two drops of chemical two, unless otherwise stated, then recording the type of physical reaction or color changes that occurred.

The synthesis of acetaminophen involves the attraction of the electrophilic carbonyl group of acetic anhydride to the nucleophilic NH2

The sodium hydroxide acts to pull the hydrogen off the oxygen in the 2-methylphenol so that the oxygen has a negative charge and can attack the sodium chloroacetate. Again, using a 1:1 molar ratio, 0.34 g (2.9 mmol) of sodium chloroacetate (the good leaving group) was added to 1 ml of water and dissolved. Following dissolving all of the 2-methylphenol (to avoid the sodium hydroxide reacting concurrently with the sodium chloroacetate and 2-methylphenol) in the sodium hydroxide, the aqueous solution of sodium chloroacetate was transferred to the reaction flask. This mixture was then heated to reflux, using a medicine dropper affixed to the top of the flask as an alternative method to boil without

In the Cannizaro reaction an aldehyde is simultaneously reduced into its primary alcohol form and also oxidized into it 's carboxylic acid form. The purpose of this experiment is to isolate, purify and identify compounds 1 and 2 which contain 4-chlorobenzaldehyde, methanol, and aqueous potassium hydroxide. Compounds 1 and 2 are purified by crystallization. . The purified product will be characterized by IR spectroscopy and melting point.

11) Dry out the methylene chloride solution that contain the benzoin and the dibromobenzene by the use of anhydrous sodium sulfate.

N- saccharin is more stable than O-saccharin, so it should be the major product of the reaction, if not the only product, if the reaction reaches thermal equilibrium. A reaction involving the oxygen as the nucleophile should occur faster than one involving nitrogen because the oxygen is more electronegative. This electronegativity would attract the attack of the nucleophile more so than the Nitrogen atom would.

In this experiment, we alkylate sodium saccharin to N-ethylsaccharin with iodoethane in an aprotic solvent N,N dimethylformamide. Nucleophiles in this experiment will react better in an aprotic solvent. Aprotic solvents have dipoles due to its polar bonds but they do not have H atoms that can be donated into a H-bond. The anions which are the O- and N- of sodium saccharin are not solvated therefore are “naked” and the reaction is not inhibited and preceded in an accelerated rate. The reaction was an SN2 reaction. Since the Oxygen and Nitrogen are more electronegative than the carbon on which they’re attached electrons are pulled towards O- and N- attracting the ethane from Iodoethane. Iodine being more electronegative

10. Ba (NO3)2, barium nitrate produces pale precipitate when put in reaction with sulfuric acid.

In order to test the hypothesis, the same tests given in Table 1 and Table 2 were performed on a sample of calcium nitrate. The results obtained for all the tests were the same as with our unknown compound. To further test this hypothesis, five different reactions were designed, as can be seen in Table 3, in which a

6. Purpose: to clarify the mechanism for the cycloaddition reaction between benzonitrile oxide and an alkene, and to test the regiochemistry of the reaction between benzonitrile oxide and styrene; to purify the crude product of either trans-stilbene, cis-stilbene, or styrene reaction.

The next day an orange goopy textured product resulted. The extracts were then dried and combined with anhydrous sodium sulfate, then evaporated with dry air under the hood in a warm water bath. The liquid was cooled and had an initial weighing of 0.5887g. It was reweighed several minutes later with a final

The reaction is carried out in saturated aqueous ammonium chloride solution. Thus no special drying of solvents, reagents, or glassware is required. The reaction mechanism for this experiment can be seen below (Fig. 2)

The reaction took place in a conical vial and .2mL of each of the reactant samples were added to it along with some 95% ethanol. Two drops of NaOH were added shortly after and stirred at room temperature for fifteen minutes. The vial was cooled in and ice bath and crystallized. Vacuum filtration was performed to filter the crude product. The crude product was recrystallized using methanol and filtered again. We made one change to the procedure and instead of using .7mL of ethanol we

charcoal as a decolorization agent within the recrystallization process if a solution is colored [3].

Add 4 drops of phenolphthalein in to the prepared acetic acid, and check whether the color changes to dark pink.