Introduction In this paper, I will be discussing what the advantages and the disadvantages of Digital Radiography in Diagnostic Radiology. Further more present factors with each subject showing how they are distinguished as an advantage and an disadvantage. Time, money, and radiation dosage to the patient are very important factors these days because of how many different regulations there are and the concerns for the patient as well. Digital Radiography also known as DR is static images produced with a fan x-ray beam intercepted by a linear array of radiation detectors or an area x-ray beam intercepted by a photostimulable phosphor plate or direct-capture solid-state device. Body Digital Radiography is often compared to Computed Radiography because of their similarities in their use of x-raying as well as they are both used in the medical field. Computed Radiography, also known as CR, is the radiographic technique that uses a photostimulable phosphor as the image receptor and an area beam. Direct radiography is basically Computed radiography but one less step. Computed radiography uses cassette that go into the bucky, where the image is shot. It is then unloaded from the compartment called the bucky, with the latent image and scan through a processor that reads the image and presents itself on the computer monitor for the Tech or Radiologist. This process is then repeated for another image to be taken by reloading another cassette into the bucky compartment. In
There are two very divergent viewpoints across the medical provider landscape as to whether radiological testing is used too much or not enough. The basic equation comes down to a balance between being sure that certain conditions and disorders are not in play and not wasting time/money and/or exposing the patient to potential harm due to the fairly dangerous nature of being exposed to too much radiation.
Although I was aware that some rad techs were practicing in some states without a license; I was still surprise by this report, which states that the Sunset Advisory Commission recommends eliminating the need licensure for nearly 20 medical occupations. Including the one we are majoring in. In the last couple months, we have learned a substantial amount of information on patient dose, dose limits, proper shielding and the roles we are going to play as technologist as well as our responsibilities and how the choices that we make can either have a positive or negative effects on our patients if we are not careful or if the radiation is mishandled. This being said what I found even more surprisingly is that the Commission is under the assumption that the “deregulation of radiologic technologist” would have minimal consequences on patient safety.
Radiologic Technologists, also known as "R.T.s", are professionals who are licensed and certified as specialists in one or more imaging techniques. In the contrary, a Radiologic Technician is a licensed and certified professional who only operates the x-ray imaging equipment to produce clear concise x-ray images for the physicians. A Radiologic Technologist is able to perform all the duties of a Technician. However, they are also tasked and considered as expert for their particular field of specialty.
Radiology Technologist have been around for almost a century. “Radiology Technologist works in various places taking diagnostic imaging examinations for patients, which are x-rays, magnetic resonance imaging, and mammography.” (eHow) This job is one of the few in the world that can give the risk of cancer to the rad-techs. And is stilled one of the most needed in the medical field. Radiology Technologist needs to understand computers and what the x-rays show, and how to set up a patient for and x-ray to be taken. Radiology Technologist are one of the highest paid in the medical field. This is because the job has more risk than any other job in the medical field. The radiology technologists have used x-rays for what has almost been in use
These images call for up to 90% less radiation than with standard film type x-rays. Instead of making use of the traditional silver-oxide x-ray film that must be formulated and then fixed in caustic and ecologically harmful solutions, the new system calls for pictures by way of a small digital sensing unit and it then immediately sends a Image of the tooth on to the video monitor in the treatment room. Therefore, we can easily see your teeth and surrounding components Instantly. Not only does the new digital x-ray do away with the typical wait for x-ray film to be prepared, but it also is highly sensitive, so that patients are exposed to even less radiation than with conventional x-rays.
When it comes to medical imaging, there are several different options to choose from for different testing. There are similarities and differences; pros and cons to each. This paper will discuss MRI, CT, and ultrasound. They each have important things to know regarding radiation dose, cost, and reasons to use one over another.
At the same time, the future of radiology represents unprecedented opportunities and challenges for radiologists. The articles clarify some of the potential aspects for future growth with regard to the utilization of IT in radiology. For example, many image producers believe that the report is the significant work product. To these individuals, the images are solely for the use of the diagnostic interpreter. From this perspective, distribution of images is unnecessary. Although radiologists, for the most part, have embraced the sharing of images, other image producers, such as cardiologists and pathologists, have not. Overcoming this perceptual hurdle is necessary to implement a comprehensive enterprise imaging strategy. The technological revolution enabling PACS has also created platforms for teleradiology. Because radiologists no longer require proximity to clinical colleagues or patients, teleradiology makes care possible in remote locations where radiologists may not be physically
There are not any gasps in the knowledge base and the author seems to be well informed about communication in radiography, from first view the content of abstract is well organised with clear rationale aims to perform a qualitative study (Bassett,2004).
Although Radiologic Technologist (R.T.’s) are most likely known as just someone who takes X-rays they do much more than that. They are responsible for setting up the x-ray equipment along with positioning a patient anatomically
Radiologists is a challenging career that allows me the opportunity to help and maintain good health of my surrounding and community. The Radiologist is a medical doctor who specializes in diagnosing and treating diseases and injuries using medical imaging techniques, such as x-rays, computed tomography, magnetic resonance imaging, nuclear medicine, positron emission tomography, and ultrasound. To begin a career in radiology is very interesting and hard because of the number of tasks and pressure is required to be verified by a radiologist. From a young age, I’ve always hated the electronic game system, but I’ve always been interested in how the technology works and how it has brought so much impact on our life especially the hospital technology. Growing up in the village in Nepal technology was very rare, and hospital system was very unorganized.
A diagnostic radiology is a subspecialty of radiology but it also has its own subspecialty. Such as neuroradiology, nuclear radiology, pain medicine, pediatric radiology, etc. Diagnostic Radiology according to American Board of Radiology, they use x–rays, radionuclides, ultrasounds, and electromagnetic radiation to diagnose and treat disease. The training required for becoming specialized in diagnostic is five year, one is clinical training while the other four is radiology training. Another subspecialty of radiology is interventional radiology, which utilizes minimal-invasive "... image-guided procedures to diagnose and treat disease in nearly every organ system. The concept behind interventional radiology is to diagnose and treat patients using the least invasive technique..." (Goldberg, 2017). The last subspecialty is radiation oncology which is a specialty that involves the controlled use of radiation to treat cancer either to reduce the patient's pain, for a cure or to reduce any other symptoms caused by cancer. One of the cool thing radiation oncologists do is they deliver the treatment that is commonly known as radiation therapy or
•Angiography- is an imaging technique also know as an x-ray. It visualize the inside of blood vessels and organs after injection of contrast material. A long flexible catheter is inserted through the bloodstream to deliver dye. That is what the contrast material
In a profession such as Radiologic Technologists, we perform many duties and there are several time when we decline to use radiopaque markers as a result we have to face the consequences of neglecting to give a proper patient care. The article written by the Enfinger (2015) and his purpose of writing the article is to discuss “the importance of radiopaque markers in digital x-ray.” Enfinger state that a radiographers have been taught from a very beginning of their learning stage to use radiopaque markers in a digital x-ray image. X-ray markers are used on radiographic images to determine the patient’s
Radiology is the process of working and viewing inside the human body without breaking the skin. By using radiant energy, which may take the form of x-rays or other types of radiation, we are able to diagnose and treat many diseases and injuries. Both diagnostic and therapeutic radiology involve the use of
The radiograph, one of the most common diagnostic imaging tools utilized in this field, possesses a very important component called contrast. Contrast helps radiologists perceive image detail and glean information from the area of interest. Radiation Technologists, or Rad-Techs, should always ensure that radiographs have the right amount of contrast so that the radiologist can easily read them for faster diagnosis.