Alka Seltzer Lab Report

Our testable question was, what is the effect of different liquids on the dissolving rate of the alka seltzer. To answer this question we dissolved alka seltzer in three different liquids, and recorded the data we found. After testing water three times

In this lab we tested how changing the content of the water affects the speed of the alka seltzer dissolving. My hypothesis was that the tap water would dissolve the tablet fastest, the salt water would be second fastest, and the sugar water would be the slowest. I was correct that the tap water would dissolve the fastest, but I was wrong in that the salt water would dissolve faster than the sugar water. I think that our results came out the way they did because of the amount of sugar and salt we put into the water. When we put the sugar and salt into the beakers, we came up with those measurements on the spot. After the salt and sugar had been added, the salt water was very cloudy, but you could barely tell the tap water from the sugar water.

Research Question: This investigation will determine the how the amount of water (independent variable) affects the amount the amount of time (dependent variable) it takes for the Alka-Seltzer to dissolve.

Students will place a potato cube into a test tube and add 3 ml of H202 into each tube. Then students will wait one minute and record the height in cm of the bubbles and rate how rapidly the solution bubbles on a scale of 0-5. (0=no reaction, 1=slow,……. 5= very fast.)

The mole is a convenient unit for analyzing chemical reactions. Avogadro’s number is equal to the mole. The mass of a mole of any compound or element is the mass in grams that corresponds to the molecular formula, also known as the atomic mass. In this experiment, you will observe the reaction of iron nails with a solution of copper (II) chloride and determine the number of moles involved in the reaction. You will determine the number of moles of copper produced in the reaction of iron and copper (II) chloride, determine the number of moles of iron used up in the reaction of iron and copper (II) chloride, determine the ratio of moles of iron to moles of copper, and determine the number of atoms and formula units involved in

Ever wonder about the chemical makeup of tablets that people take for pain relief? Before a tablet can be successfully made, the limiting and excess reactants must be considered. The limiting reactant will affect the amount of the product that can be made. Another reason why the starting reactants must be determined carefully is to make reduce the amount of the reactant in excess so that reactants are not wasted. This experiment uses an Alka-Seltzer tablet. Alka-Seltzer dissolves in water and is an antacid and a pain reliever1. The Alka-Seltzer tablet has many uses such as relief of headaches, ingestion, heart burns, or even upset stomachs2. The active ingredients in an Alka-Seltzer tablet is aspirin, also known as acetyl-salicylic acid (C8H12O4), citric acid (C6H8O7), and sodium bicarbonate (NaHCO3)2. The aspirin in the Alka-Seltzer tablet helps with pain relief. Because of the acid-base chemistry (Brønsted-Lowry), citric acid and sodium bicarbonate produce O2, which makes the tablet fizz when it is dropped in liquid. The Brønsted-Lowry theory shows how the Brønsted-Lowry acid donates a hydrogen ion while the Brønsted-Lowry base accepts the hydrogen ions3. The remaining NaHCO3 that is in excess post reaction with the citric acid is what is used to neutralize stomach acid which helps relief heart burn2. The problem in

First students obtained 8 graduated cylinders and labeled them. Each one contained a different ratio of vinegar and water. These graduated cylinders with the liquid were weighed and recorded.Then, students obtained an Alka-Seltzer tablet and recorded its mass. Then one alka-seltzer tablet was dropped into each of the graduated cylinders. Students had to

The manufacturer results shows that Alka-Seltzer has 1.9 grams per tablet. In the experiment the results are too small compared to the number that is given by the label. In the first run only .0588 grams reacted to the acid. That suggest that the tablet only contains 0.588 grams of sodium bicarbonate which is very different from the manufacturers. The second run gave an even smaller number of gram. In terms of moles only .0007 reacted in the first and third run and only .0006 in the second run. There are many factor that could had alter the amount of moles that reacted to the acid which affected the result in showing that there is a smaller composition of sodium bicarbonate in the tablet than that of the manufacturer’s.

How does the dissolve rate of the Alka-Seltzer tablets change as the temperature of the water changes? The dissolve rate is being affected by the temperature of the water. Temperature is a measure of kinetic energy in molecules (NYU). The higher the temperature, the higher the kinetic energy. Energy is required to create a reaction. Molecules with more energy come into contact with each other more often. The molecules of the reactants have to come into contact with each other, so more energy in molecules result in faster dissolving time.

The proof (twice the % alcohol) starts at its maximum and goes down (as the alcohol evaporates). If we start with a high concentration of alcohol, we will get the azeotrope (95% alcohol, 5% water) for a while, then the concentration will decrease.

I filled three clear cups, the first one with dH2O, the second with 0.1% NaHCO3 solution (equal parts 0.2% NaHCO3 and dH2O), and the third with 0.2% NaHCO3 solution. The control of the experiment is the cup with dH2O. The independent variable is time and the dependent variable is the number of disks floating in the solution. We separated the 30 disks into three groups of 10, placed them in syringes filled with a corresponding solution (either dH2O, 0.1% NaHCO3, or 0.2% NaHCO3), and removed all air from the syringe. This causes photosynthesis to stop in the disks, which then causes the disks to not float any longer. The three groups of disks were placed in each cup filled with 100mL corresponding to the solution, then placed under a light source and started a timer. For each minute in 15 minutes, data regarding the number of disks that floated to the top of each

In this experiment the scientists are looking for how gas production is effected when different sized Alka-Seltzer tablets are put into water. The independent variable is the different sizes while the dependent variable is the amount of gas produced. A constant variable includes the same brand of Alka-Seltzer tablets, the volume of water and same starting temperature. Finally the scientist’s control variable is the first trial testing the whole tablet comparing its reaction time to each new piece.

Alka Seltzer is a medical drug used for pain relief and used for relieving indigestion. For example, if you have a stomachache or some indigestion problems, Alka Seltzer may help neutralize the stomach acidity. Not only that, Alka Seltzer is also used for cleaning household items, such as vases or jewelry. Alka Seltzer contains citric acid and sodium bicarbonate, which makes it dissolve and release carbon dioxide gas when dropped in water. In this experiment, my lab partner, Rebecca, and I are trying to find a way to make Alka Seltzer dissolve faster in water. Rebecca and I both decide that if we increase the temperature of the water or make the water hotter, then the Alka Seltzer will dissolve faster because I know when salt and sugar dissolve in hot water, they dissolve faster. I predict that this same result would apply to this experiment.

2. (5 pts) List and explain the names and affiliations of the various characters/stakeholders in this story – I’m looking for us to use the story to map out the complexities that are generally associated with solving public health puzzles – the stakeholders you list and explain here should apply to many of the cases we consider going forward.

The experimental setup will be a pH meter placed inside each water bottle of water to check the acidity in each one, and it will be tested with a pH meter. The purpose of the investigation is to see which company of water bottles has the highest pH level. The independent variables are the different companies of water, the dependent variable will be the pH level of the water, and the controlled variable will be the pH meter, the computer and wires, the glass of water, and the distilled water.