Alpha Amylase Overproducer

To properly investigate the optimal temperatures for both bacterial and fungal amylase, it is simplest to do a visual comparison using a visual aide such as iodine. Iodine has chemical properties that, when introduced to starch, turn a dark bluish purple. In short, the iodine test uses this reaction to determine the presence of starch in the reaction. The lighter the color of the solution, the more the starch was broken down by the amylase, and, correspondingly, the darker the color, the higher the concentration of starch still present. This experiment is designed to test an organism’s ability to break down starch under different conditions and to find the optimal temperature for starch hydrolysis to occur and it breakdown to maltose, The test was conducted in 5 different temperatures and in two minute intervals. According to where these amylases are found, the bacterial

0.0375 mg/ml Porcine Pancreatic Amylase Solution (amylase powder in 0.9% NaCl ), Iodine Solution; each solution were pipetted into each of the 5 test tubes with 5 ml of 1% starch. Each tube contained a 1% starch solution with a different pH. All tubes were at room temperature. Room temperature was 22C. 0.2 ml of porcine pancreatic amylase solution was then pipetted into each tube. A timer was started and every 3minutes the starch / amylase mixture were pipetted from each tube and pipetted into the spot plate for every sample tube, then the iodine solution were added to a spot plate cell for each sample. Iodine reacts with starch to change from yellow to deep blue /black in the presence of starch. A lightening of the blue/ black to a brown color will occur as less starch is present. Results were reported as (+) for presence of starch in the sample or (–) for the absence of starch. After every three minute increment had passed, these same

The purpose of this experiment was to record catalase enzyme activity with different temperatures and substrate concentrations. It was hypothesized that, until all active sites were bound, as the substrate concentration increased, the reaction rate would increase. The first experiment consisted of five different substrate concentrations, 0.8%, 0.4%, 0.2%, 0.1%, and 0% H2O2. The second experiment was completed using 0.8% substrate concentration and four different temperatures of enzymes ranging from cold to boiled. It was hypothesized that as the temperature increased, the reaction rate would increase. This would occur until the enzyme was denatured. The results from the two experiments show that the more substrate concentration,

The EMG 26 strain cultured on the sixth and seventh lane is a competent producer of _lacI_ gene. This gene produces _lac_

An experiment was performed to test how temperature variations affect enzymatic activity of the enzyme amylase. The results of the experiment will also determine the optimal temperature of the amylase enzyme. The results of the experiment provide evidence for determining the environments that the enzyme amylase would most likely be present. By determining the possible environments, one can predict what and how environmental factors will affect the enzyme amylase. Two forms of amylase (Bacterial - Bacillus licheniformis and Fungal - Aspergyllus oryzae) were combined with starch molecules at four different temperatures (0⁰, 25⁰, 65⁰, 85⁰ Celsius). The combination of starch and the amylase enzyme resulted in a visual chemical reaction that was recorded. The enzyme activity was recorded every two minutes, starting at 0 and ending at 10. The start time 0 served as the control group of the experiment. The results concluded that both bacterial and fungal amylase has an optimal temperature around 65⁰C. This was possible to determine by recording the color change of the spot plate wells. Amylase catalyzes efficiently at its optimal temperature which resulted in yellow spot plate wells. Enzymatic activity decreased when the temperature was less than 65⁰C, resulting in a green-brown well. The green wells indicated that starch wasn’t broken down completely and was still present. Temperatures greater than 65⁰C resulted dark-green wells which resembled the denaturing of

An enzyme also known as a protein, is a biological catalyst which speeds up chemical reactions by lowering the activation energy to increase the rate in which the reaction occurs. The enzyme used was amylase, which breaks down starch molecules into maltose. PH, substrate concentration, salt concentration, and temperature. When enzymes reach a low temperature, the activity is slowed down of molecule movement, but the enzyme is not destroyed. Once enzymes are placed in optimal temperatures once again, it will restore its activity to a normal rate. When enzymes reach too high above optimal temperature, the enzyme is denatured and cannot be restored. In the experiment performed the activity of breaking down starch in fungal and bacterial amylase was being tested at a range of temperatures and time. The fungal and bacterial amylase work best at optimal temperature. Amylase will function best at sixty degrees Celsius at 10 minutes when starch had been one hundred percent hydrolyzed. Hydrolyzed is the breakdown of molecules through addition of water. The experiments independent variables were the time, temperature and enzyme used. The dependent variable was the enzyme activity that broke down the starch into maltose. The controlled variables were the temperature baths, the iodine drop amount, the mixture drop amount, and location of experiment. The control group was the zero minutes without amylase at

During these experimental procedures, the implication of multiple different temperatures on fungal and bacterial amylase was studied. In order to conduct this experiment, there were four different temperatures used. The four temperatures used were the following: 0 degrees Celsius, 25 degrees Celsius, 55 degrees Celsius, and 80 degrees Celsius - Each temperature for one fungal and one bacterial amylase. Drops of iodine were then placed in order to measure the effectiveness of the enzyme. This method is produced as the starch test. The enzyme was tested over the course of ten minutes to determine if starch hydrolysis stemmed. An effective enzyme would indicate a color variation between blue/black to a more yellowish color towards the end of the time intervals, whereas a not so effective enzyme would produce little to no change in color variation. According to the experiment, both the fungal amylase and bacterial amylase exhibited a optimal temperature. This was discovered by observing during which temperature and time period produced a yellow-like color the quickest. Amylase shared a similar optimal temperature of 55 degrees Celsius. Most of the amylases underwent changes at different points, but some enzymes displayed no effectiveness at all. Both amylases displayed this inactivity at 0 degrees Celsius. At 80 Celsius both the enzymes became denatured due to the high temperatures. In culmination, both fungal and bacterial amylase presented a array of change during it’s

Enzymes are biological catalysts that lower the activation energy required for a reaction to take place. They speeds up the process of the reaction, while still not being consumed, they can function multiple times. Enzymes are specific to molecules or sets of molecules and only work with these specific substrates. The enzymes cause substrates to be converted to products faster than they would without enzymes. A substrate fits into an enzyme, which then catalyzes the conversion of the substrate into products. The enzyme facilitates reactions, however it can become denatured. When an enzyme is denatured its form changes, thus preventing its function of converting substrates to products faster, and the enzyme does not work. The enzyme used in this experiment is amylase. Amylase is an enzyme that catalyzes the breakdown of the polysaccharide starch into the disaccharide maltose. Amylase is produced by human salivary glands and aids in digestion and breaking down food substances.

Bacterial amylases operate at higher temperatures than do fungal amylases. Fungal amylases react rapidly at lower temperatures; fungal amylases are used as an agent for alcohol fermentation for grain (Underkofler et al, 1958). Fungal amylases is said to be denatured – change shape (Alberte et al, 2012), at high temperatures above 60° C and bacterial amylases on the other hand are stable and show little denaturing at temperatures up to 85°C 3 The question answered by the experiment is if the temperature is not within the range of the enzymes (fungal and bacterial amylase) optimal temperature (higher temperature) then will the enzymes denature and if the enzymes are placed in lower temperature from optimal the activity then will it slow down enough to stop all reaction, meaning each enzyme will not be operating efficiently. Knowing about a bacterial amylases and fungal amylases optimal temperatures are important for knowing which food products and industrial products it can be used on to conserve the product because then the producer knows about which products it can be incorporated into depending on the temperature it is manufactured at.

How does decreasing the levels of pH by adding Hydrochloric acid affect the Amylase’s ability to break down potato starch solution?

The objective of the lab was to examine the effects of environmental variables on the functions of an enzyme. To the point, an experiment was conducted to test the effect of pH on the function of the enzyme Amylase.

In this lab our group observed the role of pancreatic amylase in the digestion of starch and the optimum temperature and pH that affects this enzyme. Enzymes are located inside of cells that increase the rate of a chemical reaction (Cooper, 2000). Most enzymes function in a narrow range of pH between 5 through 9 (Won-Park, Zipp, 2000). The temperature for which enzymes can function is limited as well ranging from 0 degrees Celsius (melting point) to 100 degrees Celsius (boiling point)(Won-Park, Zipp, 2000). When the temperature varies in range it can affect the enzyme either by affecting the constant of the reaction rate or by thermal denturization of the particular enzyme (Won-Park, Zipp, 2000). In this lab in particular the enzyme, which was of concern, was pancreatic amylase. This type of amylase comes from and is secreted from the pancreas to digest starch to break it down into a more simple form called maltose. Maltose is a disaccharide composed of two monosaccharides of glucose. The presence of glucose in our experiment can be identified by Benedicts solution, which shows that the reducing of sugars has taken place. If positive the solution will turn into a murky reddish color, where if it is negative it will stay clear in our reaction. We can also test if no reduction of sugars takes place by an iodine test. If starch is present the test will show a dark black color (Ophardt, 2003).

The Effects of Enzyme Concentration on the Activity of Amylase To investigate the effect of Amylase concentration on its activity. the relative activity of Amylase is found by noting the time taken for the starch substrate to be broken down, that is, when it is no longer gives a blue-black colour when tested with iodine solution. This time is referred to as the achromatic point. Equipment: v Amylase solution 0.1% v Starch Solution 1.0% v Distilled water v Iodine in potassium iodine solution v White tile and polythene pipette v Graduate pipettes or syringes v Test tubes in rack v Beaker (used as water bath) v Stopwatch, Thermometer v Eye Protection

In this lab we looked at the role of pancreatic amylase in the digestion of starch and the effect that temperature and pH has on this enzyme. Enzyme’s work as catalysts that increase the rate of chemical reactions within cells (Cooper, 2000). In order to do this, enzymes must show two essential properties: these two fundamental properties of enzymes include increasing the rate of chemical reactions without being eternally altered by the reaction and accelerating the reaction rate with keeping the reactants and products in chemical equilibrium (Cooper, 2000). Enzymatic catalysis is necessary for life. Most biochemical reactions would not occur under the mild temperatures and pressures

The Effect of pH on the Activity of the Enzyme Amylase Aim :- To find the effect of pH on the activity of the enzyme amylase. An enzyme is a type of protein found in all living cells. Enzymes act as biological catalysts, breaking down substrates without needing a high temperature, allowing all the chemical reactions of metabolism to take place, regulating the speed at which they progress, lowering the activation energy and providing a means of controlling individual biochemical pathways.