Beta Lactamase Lab Report

In this lab or experiment, the aim was to determine the following factors of enzymes: (1) the effects of enzymes concentration the catalytic rate or the rate of the reaction, (2) the effects of pH on a particular enzyme, an enzyme known and referred throughout this experiment as ALP (alkaline phosphate enzyme) and lastly (3) the effects of various temperatures on the reaction or catalytic rate. Throughout the experiment 8 separate cuvettes and tubes are mixed with various solutions (labeled as tables 1,3 & 4 in the apparatus/materials sections of the lab) and tested for the effects of the factors mentioned above (concentration, pH and temperature). The tubes labeled 1-4 are tested for pH with pH paper and by spectrophotometer, cuvettes 1a-4a was tested for concentration and cuvettes labeled 1b-4b was tested for temperature in four different atmospheric conditions (4ºC, 23ºC, 32ºC and 60ºC) to see how the enzyme solution was affected by the various conditions. After carrying out the procedures the results showed that the experiment followed the theory for the most part, which is that all the factors work best at its optimum level. So, the optimum pH that the enzymes reacted at was a pH of 7 (neutral), the optimum temperature that the reactions occurs with the enzymes is a temperature of 4ºC or

• Fourthly, we kept the temperature at a constant 25°C using a water bath. At low temperatures, an increase in temperature causes an exponential increase in enzyme activity. This is because an increase in temperature provides more kinetic energy for the collisions of enzymes and substrates, so

Enzymes are types of proteins that work as a substance to help speed up a chemical reaction (Madar & Windelspecht, 104). There are three factors that help enzyme activity increase in speed. The three factors that speed up the activity of enzymes are concentration, an increase in temperature, and a preferred pH environment. Whether or not the reaction continues to move forward is not up to the enzyme, instead the reaction is dependent on a reaction’s free energy. These enzymatic reactions have reactants referred to as substrates. Enzymes do much more than create substrates; enzymes actually work with the substrate in a reaction (Madar &Windelspecht, 106). For reactions in a cell it is

[An active site can be altered by a non-competitive enzyme which encircles the enzyme and alters the shape of the active site which could be very dangerous.]

These results show how temperature of extreme high, or low affects enzyme activity. The highest rate of enzyme activity occurred at 37 Cº. Anything that was hotter or cold than 37 Cº slowed the reaction rate. As I thought, 100 degrees would denature the enzyme, and that was the case. The data provided shows exactly what temperatures enzymes work best, and worst. The objective was achieved as we discovered the different reaction rates under different temperatures. The results are reliable, as we know enzymes do not work well when under extreme heat or denaturation occurs. What I learned in this experiment was that enzymes don’t work well under cold temperatures because they tend to move slower. My hypothesis did not quite match, because I thought they work best at lower temperatures.

Background and Introduction: Enzymes are proteins that process substrates, which is the chemical molecule that enzymes work on to make products. Enzyme purpose is to increase the rate of activity and speed up chemical reaction in a form of biological catalysts. The enzymes specialize in lowering the activation energy to start the process. Enzymes are very specific in their process, each substrate is designed to fit with a specific substrate and the enzyme and substrate link at the active site. The binding of a substrate to the active site of an enzyme is a very specific interaction. Active sites are clefts or grooves on the surface of an enzyme, usually composed of amino acids from different parts of the polypeptide chain that are brought together in the tertiary structure of the folded protein. Substrates initially bind to the active site by noncovalent interactions, including hydrogen bonds, ionic bonds, and hydrophobic interactions. Once a substrate is bound to the active site of an enzyme, multiple mechanisms can accelerate its conversion to the product of the reaction. But sometimes, these enzymes fail or succeed to increase the rate of action because of various factors that limit the action. These factors can be known as temperature, acidity levels (pH), enzyme and/or substrate concentration, etc. In this experiment, it will be tested how much of an effect

If temperature of the water(enzyme environment) is increased to 35°C, then the enzyme activity will

Enzymes will denature if they get too hot or cold or if the pH of the solution they are in is too high or too

Lactose is a sugar that can be put into smaller molecules, glucose and galactose. Lactose is when you are not able to digest milk and dairy meaning that the enzyme lactase that breaks down lactose is not functioning properly. ONPG was used as a substitute for lactase because even though it is colorless it helps show enzyme activity by turning yellow. This experiment measured the absorbance ONPG when exposed to lactase within an environment of different salinity’s. The enzyme, lactase, was obtained by crushing a lactaid pill and then was added into four cuvettes. ONPG and salt solution of different concentrations were added and their levels of absorption was measured by a spectrophotometer. The results showed that higher salt concentrations have a lower level of absorption. There were 4 cuvettes and within those cuvettes that solutions within them were being tested and the results showed the more salt solution added with the lactase the lower the absorbance. The less salt solution there was a higher rate of absorbance. The data supported the hypothesis that with increasing NaCl concentration there would be a decrease in enzyme activity.

The purpose of this experiment was to record catalase enzyme activity with different temperatures and substrate concentrations. It was hypothesized that, until all active sites were bound, as the substrate concentration increased, the reaction rate would increase. The first experiment consisted of five different substrate concentrations, 0.8%, 0.4%, 0.2%, 0.1%, and 0% H2O2. The second experiment was completed using 0.8% substrate concentration and four different temperatures of enzymes ranging from cold to boiled. It was hypothesized that as the temperature increased, the reaction rate would increase. This would occur until the enzyme was denatured. The results from the two experiments show that the more substrate concentration,

The motive of this lab is to attain a better understanding of enzyme activity by timing chemical reactions in certain temperatures and pH levels. Enzymes act as catalysts that help speed up reactions. Without these enzymes chemical reactions in metabolism would be backed up. There are two factors that affect an enzyme’s reaction rate: temperature and pH levels. In this label we will be testing different pH levels and temperatures to see which ones cause the most reactions.

The results in (Table 29, Fig. 31) illustrated that as temperature of heating and time of exposure of the enzyme increase, stability of this enzyme decrease. The purified pectinase enzyme when exposed to 45°C

We then tested the last set of test tubes containing milk and lactase, we did this to find which ones would present the most glucose concentration results, when placed in different temperatures, 4°C, boiling and room temperature. What we wanted to know was how far temperature could affect lactase to perform its enzymatic activity. We hypothesized that if the lactase is placed in a high or low temperature outside its active range, the temperatures would have a negative impact on the functions of the enzyme. If the temperature has an affect on lactose then we would see some temperatures in which lactase will be function able. We came to a conclusion that enzymes work at a temperature that is closest to body temperature (25°C); boiling water (100°C) denatures the enzyme, while the enzyme is not able to function properly if

The purpose of this lab is to examine the specificity of the lactase enzyme to a specific substrate and how it can denature due to the rise in temperature.

As expected, during the temperature test, the least amount of bubbles were emitted in tubes that had been exposed to extreme heat. The tube placed in boiling water yielded zero millimeters of bubbles. The boiling water denatured the enzyme and altered its chemical structure rendering it incapable of undergoing metabolic reactions. For these same reasons, the vile placed in a hot bath, containing water at 85 degrees, produced only one