Biblep Case Study

1. Assuming that the order contains a dozen of cookies, the time to take a rush order is the sum of cycle times for each activity: 0+6+2+9+1+0+5+2+1=26 min.

For my experiment I picked 3 different brands of bubble gums. Hubba Bubba gum, Bubble Yum and Bazooka. After chewing each piece of gum for 2 minutes, one at the time, I blow a bubble as big as I could. Then, my partner (my mom) measured and I write down the results. I repeated the same steps 3 times and results was collected in a data chart (see data chart # 1). Then, the average size of the bubble was calculated by adding each result and divided by 3. The average size of the bubble made from Hubba Bubba Gum was 3.8 cm, Bubble Yum was 3.5 cm and Bazooka was 3.3 cm. As a result of my experiment, I found that Hubba Bubba gum makes the biggest bubble (3.8 cm).

23) Which of the following is observed in a scatter plot when there is an inverse relationship between x and y?

J 4. B 5. C 6. A 7. H 8.

The reason why it has this growth for best, average, and worst cases however is because of the way the sort itself works. It compares the “smallest” (first index at first iteration) value it has to every single other element in the array. Every time it finds a smaller, it redefines it as smallest, then once it is finished comparing makes a swap. It then repeats the process from the 2nd index, and once again compares it to every single proceeding element. It repeats this until the list is sorted. It even does this even if there is no sorting to be done, hence, always the same order of

In insertion sort, the best case is not quadratic because it only has to verify each entry once since it would have nothing to insert. The algorithm would just read through the array once and see that it is already sorted. Selection sort must check each entry twice to verify that the array is correctly sorted in the best

The main program first reads the input, that is, the infix-expression, and use stacks to convert the given expression to a prefix expression, which conforms the operator precedence levels. In order to do so, the stack will push the lowest precedence level operations to the stack first, then push the lowest level operations among the remaining operations, and repeat this process until it went through all the operations. Next, the stack will pop the top element repeatedly into the tree until there is nothing left in the stack.

By the laws of modular arithmetic, the multiplicative inverse of a modulo m exists if and only if a and m are coprime. Indeed, since d and φ(n) are coprime, d has a multiplicative inverse e in the ring of integers modulo

For example using the numbers 1-2-3 again, the three combinations where the numbers are in ascending order, so 1-2-3, 2-3-1, and 3-1-2 will be facing one way and the sequences 1-3-2, 2-1-3, and 3-2-1 will be a mirror image of the original number sequences spiralateral. The way I know that this is true is because I used two of my number sequences and drew them out and then I checked

If we clearly view the problems we can see that the problem A is faster, then B. The reason is A have a clear end and it takes few steps to reach it, but problem B have almost unlimited values and it takes a huge time to reach there. This is the reason A is much faster then B. Let’s figure it out mathematically.

During this time his young friend rejoins him, and is welcomed back with open arms by bubbles. However, his young friend has become addicted to drugs, and when the robber fails to steal the drugs from Bubbles as bubbles planned, bubbles meets back up with his friend at there home. However, in the morning Bubbles realized that his friend was dead taking the poisoned drugs in the middle of the night. Moreover, this causes Bubbles to turn himself in to the homicide police for the murder, but when the officers and captain leave the room he tries to hang himself. However, the police save his life and in a moment of decency the Captain refuses to press charges for the murder and instead leaves him at the hospital in a psychiatric/drug unit. In the last scene with bubbles we see him break down in when the detective and his friend or sponcer come to the hospital and his friend or sponcer enters the

The bubble sparks too soon. People don't pay attention at him and walk away. Desmond stops and looks at Bubble. Bubble never stop creating bubbles.

Worst-fit memory allocation is opposite to best-fit. It allocates free available block to the new job and it is not the best choice for an actual system. In the illustration, on the first cycle, job 5 is in waiting queue while job 1 to job 4 and job 6 are the jobs to be first process. After then, job 5 occupies the free block replacing job 2. Block 5 is now free to accommodate the next job which is job 8 but since the size in block 5 is not enough for job 8, so job 8 is in waiting queue. Then on the next cycle, block 3 accommodate job 8 while job 1 and job 5 remain on their memory block. In this cycle, there are 2 memory blocks are free. In the fourth cycle, only job 8 on block 3 remains while job 1 and job 5 are respectively replace by job

We observe that there is high standard deviation for most of the steps (especially Underwriting Step) and is comparable to mean value itself. Ex: For RERUNs Underwriting step mean is 18.7min while the standard deviation is 19.8min. Hence we are using 95% SCT for determining bottleneck step. And thus we consider Underwriting Stage as the bottleneck for the whole system.

approximations used, inversion method explanation and other parameters explained using example of aki richards approximation