preview

Building A Rocket

Better Essays
Open Document

TABLE OF CONTENTS
Introduction…………………………………………………………………..……….1
Hypothesis & Theory.................................................................................................2
Procedures.............................................................................................................3-6
Aftermath/Results......................................................................................................7
Conclusion…………………………………………………………………..…....…..8

INTRODUCTION

Building. The word some of us, get exhausted over. In some cases, without the proper instructions and guides, the creator/maker might find it difficult to create their particular idea. For this …show more content…

Which, later on, would give us a valuable explanation. If the rockets with the smaller masses went significant amounts farther than the rocket’s with a much larger mass, that would validate my hypothesis correct.

PROCEDURES

In the steps provided below, are the methods I used to create my rocket. However, the methods listed may or may not apply to you. Please be aware.

THE BODY:
Materials needed: A 2L Pop-bottle, a black marker, paint, a ruler, and a roll of masking tape. You can also use Duct-tape instead of masking tape if you prefer. Both works equally.

For the body of my rocket, I decided to cover it with masking tape. If I wanted to prove my hypothesis correct, this would be the best way to prove my point.

Get your Pop-bottle, and start measuring it.
It is much easier when you measure out your Pop-bottle, so you know the exact and accurate placements of wherever you decide to place your fins/cone.
Once you have measured out your Pop-bottle, decide where you are going to wrap the masking tape around.
For my sake, I decided to cover the center of the bottle with masking tape.

Get Access
Related
Get Access