Chemical Properties Of Binary Compounds

c) Record the amount of substance that dissolved – all, some, a little, or none.

Moisten filter paper with a few drops of solvent and turn on water vacuum to fullest extent

The mixture was heated at 120°C using an aluminum block and was stirred gently. After all of the solid dissolved, it was heated for 20 additional minutes to ensure the reaction was complete.

17) Pour a small amount of the hot solvent into the flask containing the solid.

Then added 5.00g of CuCl₂ ●H₂O into the distilled water. Stirred to dissolve the mixture

Part 1: Obtain some 0.200M Fe(NO3)3 solution and some 0.00020M KSCN solution. Starting from the first solution, pour and mix 8.0mL of Fe(NO3)3 solution and 2.0mL of KSCN solution into a test tube, where as the second solution has 7.0mL of Fe(NO3)3 solution and 3.0mL of KSCN solution. Continue this process until 5 test tubes have been filled. Pour

9) Trial E: Remove the syringe and empty the beaker. Add a Thermometer to the beaker. Add 200 mL of Room Temperature water to the beaker and heat with a Bunsen Burner until it reaches 100° C. Remove the Bunsen Burner. Repeat Steps 5 & 6.

Fill a test tube about 1/3 full with cold tap water for use in step 34.

The wet, crude product was placed into the 50 mL Erlenmeyer flask. Small amounts of CaCl2 were added to dry the solution. The flask was sealed and the mixture was swirled and left to settle. Once

40 g of ice and approximately 30 ml of sulfuric acid is cautiously added to a 100 mL beaker respectively. Weigh 7.6 g of ammonium chloride and 14.0 g of ammonium bromide and place it in another beaker, crushing the lumps until a powdery mixture remains. The powdery mixture is then transferred to a 125 mL Erlenmeyer flask. Add the ammonium salts into the sulfuric acid mixture. Heat is applied to dissolve the salt. Once the

Place 100 ml of distilled water in a 250-ml (or 400-ml) beaker. Add 1.26g of oxalic acid dihydrate (H2C2O4.2H2O) and 1 ml of concentrated ammonia. Stir the mixture until the solid has dissolved completely.

XII. Take the 250 ml beaker to your lab bench. Set up a gravity filtration with a plastic funnel, folded wet filter paper, and an Erlenmeyer flask. Pour the content in the 250 ml beaker slowly through the filter paper. Wash the filter paper with deionized water. Dispose of the filtrate in the proper labeled waste container.

2) Rinse the solid with about 30 mL of distilled water and decant the liquid from the solid. It is critical that as little solid as possible is lost during this process. Repeat the rinsing two or three times.

This reaction may produce a lot of bubbling or frothing. DO NOT allow mixture to spill over the sides of the container. Do not the solution to boil to dryness. Additional 20ml portions of the 1.5 M KOH to maintain volume. After the metal has be digested, filter the hot solution using a funnel containing a small plug of glass wool into a 150ml beaker.

1. Number four clean test tubes 1-4. 2. Place 1 ml (or 20 drops) of the following solutions into each tube: water, egg albumin, starch, and chicken broth. 3. Add 3 drops of Buiret reagent to each tube and gently shake