Essay Chromatography Investigation

When the pH is not at its optimum, the differing pH's will disrupt the bonding between the R groups of the amino acid causing its structure and the shape of the activation site to change

Adsorption chromatography occurs when “one substance form[s] some sort of bonds to the surface of another one”, creating intermolecular forces between the two substances (Chemguide). For thin layer chromatography, the components of the mixture are adsorbed onto the stationary phase that covers the plate (Chemguide). The more polar a substance is, the more strongly adsorbed it is (Chemguide) and the strong intermolecular forces then result in a slower rate of migration with respect to the moving phase. As the solvent touches the TLC plate, the solute (mixture) is allowed to move up the TLC plate

11) Dry out the methylene chloride solution that contain the benzoin and the dibromobenzene by the use of anhydrous sodium sulfate.

These layers can be separated through the use of a seperatory funnel which drains the bottom layer into a separate container. This method uses the understanding of partition ratios of solutes to different paired solvents to produce an equilibrium leaning towards one solvent over another, thereby extracting a compound from one liquid to the other (Padias 128-37). For example, consider a mixture containing two solutes, solute A and solute B, and two immiscible solvents, solvent A and solvent B. If solute A dissolves well into solvent A, but not very well into solvent B, and solute B dissolves well into solvent B but not very well into solvent A, there would be a higher ratio of solute A in solvent A than in solvent B, and a higher ratio of solute B into solvent B than in solvent A. One can then see that, through the use of different solvents, two dissolved solutes can be separated from a mixture. This ratio of a solute concentration to different solvents is defined by K, the distribution constant. Successive filtrations yield’s a higher percentage of products.

In the beginning of this experiment, our TA added water, salt, and 75/25 hexane/acetone to spinach leaves to a blender and blended the mixture to assume equal amounts for each group and to avoid erros if each student had to do the blending. The addition of the water to the mixture allowed the it to separate into a distinct organic layer after being run in a centrifuge, which was available to be collected at the top of the centrifuge. Salt reduces solubility, which will force the organic parts of the mixture (the desired pigments for example) to separate into the organic layer at the top. Lastly, 75/25 hexane/acetone is added because this is a moderately polar solvent and will useful for both the non-polar and polar pigments present within the spinach leaves. A mixed solution of hexanes and acetone must be used because acetone is very polar, while hexane in very non-polar, and the spinach leaves contain both non-polar and polar pigments in them that are important in the extraction and for further analysis. The mixture was placed in the centrifuge so the solids in the mixture (mostly cellulose) could be separated from the liquids into separate distinct layers for further extraction and testing. In the tube, the organic substances separated into the top layer, whereas the water layer remains at the bottom of the tube below the solid layer made up of mainly cellulose.

Abstract: The purpose of this lab is to separate and identify pigments and other molecules within plant cells by a process called chromatography. We will also be measuring the rate of photosynthesis in isolated chloroplasts. Beta carotene, the most abundant carotene in plants, is carried along near the solvent front because it is very soluble in the solvent being used and because it forms no hydrogen bonds with cellulose. Xanthophyll is found further from the solvent font because it is less soluble in the solvent and has been slowed down by hydrogen bonding to the cellulose. Chlorophylls contain oxygen and nitrogen and are bound more tightly to the paper than the other pigments.

The separation of molecular particulates from any mixture may involve any combination of the relative chemical, electrostatic, and mechanical properties composing each component contained therein. Typically this mixture may exist as a liquid solution or gaseous species. The respective interactions of each particulate depend on the surrounding conditions to which the solution is subjected. A solvent is utilized to dissolute the mixture such that it may pass through a separation chamber that contains

The eluting solvent passed down the column by the gravity and an equilibrium was established between the solute absorbed by the absorbent (silica gel in this experiment) and the eluting solving flowing down. Since the components in the sample had different polarity and they interacted with the stationary phase and the mobile phase differently, the components would be carried by the solvent to a different extent and a separation of the components could be achieved.

On a thin chromatography plate, five spots were placed ( as shown in table 2) and the plate was developed using chloroform/methanol. This was later visualized with dragendorff’s reagent under the UV light. All separated components were observed, identified and recorded.

Pigments extracted from different greens have different polarities and may be different colors. Mixed pigments can be separated using chromatography paper. Chromatography paper is able to separate mixed pigments due to their polarity and solubility. Pigments of chlorophyll a, chlorophyll b and beta carotene will be separated on chromatography paper because each has its own polarity and solubility, which results in different distance traveled up the paper. Beta carotene is non-polar so it travels the highest distance, followed by chlorophyll a. Chlorophyll b is the most polar; therefore, it travels the shortest distance. The separated pigments on the chromatography paper can be eluted in acetone and absorbance spectrum is

Impurities that are present in the solution can be removed by extracting them from the original solvent into another solvent. This is done by mixing two immiscible (insoluble to one another) solvents (Manion, 2004). By mixing the

Chromatography is a separation technique in which the mixture to be separated is dissolved in a solvent and the resulting solution, often called the mobile phase, is then passed through or over another material, the stationary phase. The separation of the original mixture depends on how strongly each component is attracted to the stationary phase. Substances that are attracted strongly to the stationary phase will be retarded and not move alone with the mobile phase. Weakly attracted substances will move more rapidly with the mobile phase.

The purpose of this experiment was to take spinach leaves and extract the chlorophyll and carotenoid pigments by using acetone as the solvent. The chlorophyll and carotenoid pigments were extracted by using column chromography and alumina was used as the solvent. Solvents of different polarities were used, starting with the least polar, to extract the certain components from the leaves. They were then analyzed by using thin- layer chromatography.

It is possible to separate these pigments from each other using a technique called paper chromatography. In this process, plant tissue extract is applied to a piece of chromatography paper. “A solvent is allowed to travel up the paper, and if the pigment is soluble in the solvent, it will be carried along with it.” (Benya, 2009) Different pigments have different affinities for the solvents or polarity and will travel at different rates. Chlorophyll, anthyocyanins, and carotenoids are typically non-polar.

AIM : Thin-Layer Chromatography can show many different characteristics of a mixture. It is recognized for isolation , separation ,identification, and anaylsis of the mixture’s components. The purpose of this experiment is to separate carbohydrates into its pure components such as mixtures of monosacrides by TLC. TLC is used to identify sugars in normal and pancreatic disease urine, the procedure is easy and reproducible .