Conservation Of Mass Lab

2. The second source of error in the lab is when opening the lid of the crucible which allowed smoke of magnesium oxide to escape. During the lab, we removed the lid a couple of times to allow oxygen to enter the crucible so the magnesium reacts with the air to form magnesium oxide. However, the smoke could have easily escaped from the crucible because of the strong force of heat from the laboratory burner. This could have affected the lab results by decreasing the final mass when some of the product have escaped.

Materials:Magnesium stripCrucibleCrucible coverClay triangleIron ringRetort standTongsBalanceBunsen burnerProcedure:1.obtained a strip of magnesium between 30-40 cm long2.coiled magnesium strip into a tight roll3.measured the mass of the crucible and cover4.Added the magnesium strip to the crucible and measured the

The first experiment is about the combustion of magnesium after which the ash is formed.

The objective of this lab was to use prior knowledge about the Law of Conservation of Matter and of different types of chemical reactions in order to evaluate if aluminum disappears during the reaction and copper appears. The reaction that occurred between Copper (II) Chloride and aluminum was a single replacement reaction. Clear signs that a chemical reaction took place include heat release/temperature change, color change, and formation of a precipitate. When a single element, in this instance aluminum, replaces another element in a compound, copper, a single replacement reaction occurs. A basic formula for these reactions is AB + C → AC + B.

The aim of the lab was to determine the molar enthalpy of the combustion of magnesium using values from reactions between magnesium and magnesium oxide in hydrochloric acid solution using Hess’s Law and Calorimetry. The calculated molar enthalpy of the combustion of magnesium from this experiment was -633.6KJ/mol. This result was found by putting a known mass of magnesium metal as well as magnesium oxide powder into a concentration of HCl. Firstly, a styrofoam calorimeter was used to determine the standard reaction temperature of magnesium metal and hydrochloric acid. Next, calorimetry was again used to determine the reaction temperature of magnesium oxide and hydrochloric acid. Lastly, the thermochemical equations for the two

The purpose of this lab was to test the law of definite proportions for the synthesis reaction of combusting magnesium. In this lab, the polished magnesium ribbon was placed in covered crucible and was heated in order for it to react with Oxygen presented in air and in water provided. The result showed that Magnesium oxide formed through chemical reaction was made up of 60.19% magnesium and 39.81% oxygen, which is approximate proportion of both particles in every Magnesium oxide compound. From this lab it can be concluded that the law of definite proportion stating that the elements in a pure compound combine in definite proportion to each other is factual.

    In this lab, a calorimeter was used to find the enthalpy of reaction for two reactions, the first was between magnesium and 1 molar hydrochloric acid, and the second was between magnesium oxide and 1 molar hydrochloric acid. After the enthalpy for both of these were found, Hess’ law was used to find the molar enthalpy of combustion of magnesium, using the enthalpies for the two previous reactions and the enthalpy of formation for water. The enthalpy of reaction for the magnesium + hydrochloric acid reaction was found to be -812.76 kJ. The enthalpy of reaction for the magnesium oxide + hydrochloric acid reaction was found to be -111.06 kJ. These two enthalpies and the enthalpy of formation for water were manipulated and added together using Hess’s law to get the molar enthalpy of combustion of magnesium. It was found that the molar enthalpy of combustion of magnesium was -987.5 kJ/mol. The accepted enthalpy was -601.6 kJ/mol, which means that there is a percent difference of 64%. This percent difference is very high which indicates that this type of experiment is very inefficient for finding the molar enthalpy of combustion of magnesium. Most likely, a there are many errors in this simple calorimeter experiment that make it inefficient for finding the molar enthalpy of combustion of magnesium.

Introduction: Chemical reactions are dependent upon two factors: temperature and concentrations of substance. We can monitor the rate at which a chemical decomposes or the rate at which a chemical substance appears. In this experiment we will be measuring the rate of decomposition of hydrogen dioxide with the following reaction:

| After ignition of magnesium light and toxic fumes are made, and white powder (2MgO or Magnesium Oxide) is left over.

A1.Work under the hood! With a pair of tongs, hold a strip of magnesium in a bunsen burner flame. Do not look directly at the flame. Save the ash in a small beaker for the next procedure. If magnesium is substance "A" in the general equation, what is "B"?

Because it is dangerous to burn magnesium, it is not possible to directly record heat change. Our lab team suggests an indirect way of determining the heat of combustion for magnesium. To accomplish this, we need to perform two separate trials. One uses a solid (powder) version of MgO, while the other uses Mg ribbon. With the results from these, we can use Hess’ Law to determine q=∆H. This provides both a safe and successful way of indirectly determining the heat of combustion for magnesium.

In any chemical reaction, the mass of the products is less than the mass of the reactants.

With the mass of oxygen found, 0.02 grams, the percent compositions of magnesium and oxygen can be found by dividing their masses by the total mass of the new compound:

How empirical formula of Magnesium Oxide is obtained by heating Magnesium in the presence of air?

If the mass of the reactants are compared to the mass of the products, then the mass will stay the same because the law of conservation of mass states that in any given chemical reaction, the total mass of the reactants equals the total mass of the products.