Environmental Microbiology Lab Report

2. Used a test tube clamp to held the test tube and gently heated the tube in a laboratory burner flame for about 30 seconds.

*Peanut oil has a higher smoke point and has less of a chance of burning during the experiment.

|EMB Agar | |Distinguishes bacteria that ferment |Dark blue colonies with|E. coli and P. |

Turn on the gas burner and bring it a low heat, only to the point that there is a blue flame. Carefully push the gas burner under the crucible and heat for around two minutes in order to properly rid the crucible of any bacterias or other impurities that may affect the lab.

Citrobacter Freundii is a species of bacteria that can be potentially harmful to humans. It is known to cause meningitis by protruding into the brain and replicating itself (1). The Citrobacter species has also been found as a cause of some urinary tract infections, diarrhea, and even gastrointestinal diseases and symptoms (3). C. Freundii can be located in a wide variety of soils and water (3). Lastly, it is also the cause of many nosocomial infections due to its presence in water (1).

An association between enzyme production, gene copy number, and gene evolution was explored by conducting analysis of the salivary amylase enzyme, AMY1A gene copy number, and the ancestral starch consumption in Homo Sapiens (Tracey 2017, p.22). It was hypothesized that the relative amount of starch consumption was very high for my personal ancestral diet, thus my AMY1 diploid gene copy number in my genome and salivary amylase concentration would be significantly higher than the population mean. With a population of 28 subjects (n=28), individual saliva samples were collected and compared to a calibration curve to determine the approximate amylase concentration by analyzing absorbance values. Individual samples of buccal cheek cells were

5.Position gas collecting hose so it runs from reaction vessel through gas collecting box to opening of the graduated cylinder. The idea is that any gas coming through the tube will rise in the graduated cylinder and displace the water in it.

In the world of microbiology it is vitally important to be able to discern the identities of microorganisms. Not only is it important in a lab setting but as well as in healthcare in general. Properly identify what strain of bacteria a person has will aid in the proper medicine and dose given. Throughout the semester we have learned about different types of bacteria and certain test that can clearly identify them. The purpose of this lab report is to identify a Gram-positive or Gram-negative bacterium. Using all the knowledge of procedures and lab techniques identify the unknown and discuss all the tests you performed.

5.Wait 5 minutes. During these 5 minutes, set all 4 of the syringe plungers on the gas measuring mechanism at 2mL.

When reflecting back to experiment 3, Aseptic Technique and Culturing Microbes, I realized the large amount of microorganisms that can be found in everyday life. Many different types are found with in the human body. Theses experiments focused on two types of bacteria. First was Staphylococcus epidermidis, found on the skin, and second was Lactobacillus acidophilus, found in the gastrointestinal tract. Both have similar needs for growth when it comes to temperature, however, different growth environments are used.

This experiment is about bacterial growth. We will demonstrate a bacterial growth curve using a closed system. Bacterial growth usually takes up to 12-24 hours to get an accurate result so we will be monitoring this growth between two classes. We also used different methods to determine bacterial growth as well as a few different calculations. One way of receiving data is by using a spectrophotometer where we will record the absorption at a given time to create the bacterial growth curve. We also used the plate count method after performing a serial dilution to calculate the actual cell density at different times given. By using this method we can count the population number of the same given and see the maximum cell density

In this lab experiment, students had to create a growth curve for E. coli. The E. coli growth curve would illustrate the progression of the population of E. coli a set time period. In this case, the growth curve depicted the population of E. coli over a 12-hour period. The growth curve for E. coli was created from the absorbance levels, the optical density(OD), recorded from the spectrophotometer.

2. Introduction: Each student was given unknown bacteria and was instructed to perform a variety of experimental tests that would help to identify their bacteria. During the process of identification, the unknown bacteria was added to many different testing medias using aseptic technique. They are as follows: lactose fermentation on eosin methylene blue (EMB), TSI (Triple Sugar Iron agar), Phenol red sucrose, the SIM test, H2S by SIM, IMViC (indole, motility, voges-proskauer, and citrate), Urease (urea broth), PDase (Phenylalanine Deaminase), Lysine Decarboxylase, and Ornithine Decarboxylase. Colonial morphology on EMB was used to

Life on this planet began with microorganisms. Through millions of years microorganisms have found ways to successfully adapt and survive. These adaptations have created a wide biodiversity, allowing them to basically populate in all places. Why are these microbes so important? Because they shape the history of our world. Some microbes can be deathly to humans while some others are favorable, for example, bacteria that lives in the gut of both humans and animals and helps during the process of digestion (Alfred Brown & Heidi Smith, 2006). Understanding these interactions help scientists to find ways to protect humans from potential deathly pathogens. In order to observe microbes, microscope proficiency and microorganisms’ identification are crucial skills in a microbiology lab. During this laboratory session, samples of environmental and human organisms were inoculated into two different rich media and incubated to their according temperature. After this, appropriate use and calibration of the microscope was performed. Lastly, morphology and size of different species of bacteria, algae, fungi and protozoan were recorded.

Another purpose of this experiment is to stress the importance of knowing the identity of a microorganism. Knowing the species of microorganism present in a sample provides a