Enzyme Reaction : Enzymes And Enzymes

At five minute intervals over the next fifteen minute period, record the color intensity of the solution of each test tube.

In this lab or experiment, the aim was to determine the following factors of enzymes: (1) the effects of enzymes concentration the catalytic rate or the rate of the reaction, (2) the effects of pH on a particular enzyme, an enzyme known and referred throughout this experiment as ALP (alkaline phosphate enzyme) and lastly (3) the effects of various temperatures on the reaction or catalytic rate. Throughout the experiment 8 separate cuvettes and tubes are mixed with various solutions (labeled as tables 1,3 & 4 in the apparatus/materials sections of the lab) and tested for the effects of the factors mentioned above (concentration, pH and temperature). The tubes labeled 1-4 are tested for pH with pH paper and by spectrophotometer, cuvettes 1a-4a was tested for concentration and cuvettes labeled 1b-4b was tested for temperature in four different atmospheric conditions (4ºC, 23ºC, 32ºC and 60ºC) to see how the enzyme solution was affected by the various conditions. After carrying out the procedures the results showed that the experiment followed the theory for the most part, which is that all the factors work best at its optimum level. So, the optimum pH that the enzymes reacted at was a pH of 7 (neutral), the optimum temperature that the reactions occurs with the enzymes is a temperature of 4ºC or

In the experiment we used Turnip, Hydrogen Peroxide, Distilled Water, and Guaiacol as my substances. On the first activity, Effect of Enzyme concentration of Reaction Rate for low enzyme concentration, we tested three concentrations of the turnip extract, and hydrogen peroxide. For the Turnip Extract I used 0.5 ml, 1.0 ml, and 2.0 ml. For hydrogen peroxide we used 0.1 ml, 0.2 ml, and 0.4 ml. We used a control to see the standard, and used a control for each enzyme concentration used. The control contains turnip extract and the color reagent, Guaiacol. We prepared my substrate tubes separately from the enzyme tubes. My substrate tube

Enzymes are biological catalysts that speed up chemical reactions, without being used up or changed. Catalase is a globular protein molecule that is found in all living cells. A globular protein is a protein with its molecules curled up into a 'ball' shape. All enzymes have an active site. This is where another molecule(s) can bind with the enzyme. This molecule is known as the substrate. When the substrate binds with the enzyme, a product is produced. Enzymes are specific to their substrate, because the shape of their active site will only fit the shape of their substrate. It is said that the substrate is complimentary to their substrate.

Effect of pH on Enzyme Activity. 1. Dependent Variable. amount of product (glucose and fructose) produced 2. Independent Variable. pH 3. Controlled Variables. temperature; amount of substrate (sucrose) present; sucrase + sucrose incubation time

These results shown from this experiment led us to conclude that enzymes work best at certain pH rates. For this particular enzyme, pH 7 worked best. When compared to high levels of pH, the lower levels worked better. The wrong level of pH can denature enzymes; therefore finding the right level is essential. The independent variable was the amount of pH, and the dependent being the rate of oxygen. The results are reliable as they are reinforced by the fact that enzymes typically work best at neutral pH

Lab six requires students to observe the effects of pH and enzyme concentration on catecholase activity. Enzymes are organic catalysts that can affect the rate of a chemical reaction depending on the pH level and the concentration of the enzyme. As pH comes closer to a neutral pH the enzyme is at its greatest effectiveness. Also at the absorbance of a slope of 0.0122 the enzyme is affected greatly. The pH effect on enzymes can be tested by trying each pH level with a pH buffer of the same pH as labeled as the test tube and 1mL of potato juice, water, and catechol. This is all mixed together and put in the spectrophotometer to test how much is being absorbed at 420nm. As the effect on enzyme concentration can be tested almost the same way. This part of the exercise uses different amounts of pH 7-phosphate buffer and potato juice, and 1mL of catechol mixed together in a test tube. Each substance is put in the spectrophotometer at a wavelength set tot 420nm. The results are put down for every minute up to six minutes to see how enzyme concentration affects reaction rate. The results show that the pH 8 (0.494) affects the enzyme more than a pH of 4 (0.249), 6 (0.371), 7 (0.456), and 10 (0.126). Also the absorbance is greatest at a slope of 0.0122 with test tube C that has more effect on the reaction rate, than test tube A, B, and D.

3) Adding less enzyme caused the reaction to proceed more slowly than when more enzyme was utilized.

In the first part of the enzyme lab, we mixed a substrate and an indicator with an enzyme. There was also a neutral buffer in each of the chemical mixtures. The neutral buffer regulated the pH to around 7. We got a color palette and once we mixed each together, we observed and saw a change in the color of the substance. The darker and more brown the substance got, the more oxygen produced by the reaction. Our results showed that amount of oxygen produced increased about 10% a minute until it sort of equilibrated at 4 minutes and didn’t change to the fifth minute mark. If we were to change anything we did in the experiment, we would make our comparisons to the chart more precise. Overall we thought it

Figure one depicts the reaction rate of peroxidase enzyme over time. The y-axis shows the absorbance of the assay solutions, and the x-axis depicts time it took for the reaction to occur in seconds.

As stated in the introduction, three conditions that may affect enzyme activity are salinity, temperature, and pH. In experiment two, we explored how temperature can affect enzymatic activity. Since most enzymes function best at their optimum temperature or room temperature, it was expected that the best reaction is in this environment. The higher the temperature that faster the reaction unless the enzyme is denatured because it is too hot. Similarly, pH and salinity can affect enzyme activity.

Enzymes are biological catalysts, which accelerate the speed of chemical reactions in the body without being used up or changed in the process. Animals and plants contain enzymes which help break down fats, carbohydrates and proteins into smaller molecules the cells can use to get energy and carry out the processes that allow the plant or animal to survive. Without enzymes, most physiological processes would not take place. Hundreds of different types of enzymes are present in plant and animal cells and each is very specific in its function.

The purpose of this lab is to test for enzyme activity by examining factors that may influence enzymes.

After the substrate solution was added, five drops of the enzyme were quickly placed in tubes 3, 4 and 5. There were no drops of enzyme added in tubes 1 and 2 and in tube 6 ten drops were added. Once the enzyme solution has been added the tubes were then left to incubate for ten minutes and after five drops of DNSA solution were added to tubes 1 to 6. The tubes were then placed in a hot block at 80-90oC for five minutes. They were then taken out after the five minute period and using a 5 ml pipette, 5 ml of distilled water were added to the 6 tubes and mixed by inversion. Once everything was complete the 6 tubes were then taken to the Milton Roy Company Spectronic 21 and the absorbance of each tube was tested.

Enzymes are proteins that act as catalysts and help reactions take place. In short, enzymes reduce the energy needed for a reaction to take place, permitting a reaction to take place more easily. Some enzymes are shape specific and reduce the energy for certain reactions. Enzymes have unique folds of the amino acid chain which result in specifically shaped active sites (Frankova Fry 2013). When substrates fit in the active site of an enzyme, then it is able to catalyze the reaction. Enzyme activity is affected by the concentrations of the enzymes and substrate present (Worthington 2010). As the incidence of enzyme increases, the rate of reaction increases. Additionally, as the incidence of substrate increases so does the rate of reaction.