Enzymes Essays

The hypothesis is that catalase activity will increase exponentially with higher concentrations of hydrogen peroxide until all catalase active sites are filled, in which case the

The role of an enzyme is to catalyse reactions within a cell. The enzyme present in a potato (Solanum Tuberosum) is catechol oxidase. In this experiment, the enzyme activity was tested under different temperature and pH conditions. The objective of this experiment was to determine the ideal conditions under which catechol oxidase catalyses reactions. In order to do this, catechol was catalyzed by catechol oxidase into benzoquinone at diverse temperatures and pH values. The enzyme was exposed to its new environment for 5 minutes before the absorbance of the catechol oxidase was measured at 420 nm using a spectrophotometer. The use of a spectrophotometer was crucial for the collection of data in this experiment. When exposed to hot and cold temperatures, some enzymes were found to denature causing the activity to decrease. Similarly, when the pH was too high or low, then the catechol oxidase enzyme experienced a significant decrease in activity. It can be concluded after completing this experiment that the optimal pH for catechol oxidase is 7 and that the prime temperature is 20º C. Due to the fact that the catechol oxidase was only tested under several different temperatures and pH values, it is always possible to get a more precise result by decreasing the increments between the test values. However, our experiment was able to produce accurate results as to the

These results shown from this experiment led us to conclude that enzymes work best at certain pH rates. For this particular enzyme, pH 7 worked best. When compared to high levels of pH, the lower levels worked better. The wrong level of pH can denature enzymes; therefore finding the right level is essential. The independent variable was the amount of pH, and the dependent being the rate of oxygen. The results are reliable as they are reinforced by the fact that enzymes typically work best at neutral pH

Background and Introduction: Enzymes are proteins that process substrates, which is the chemical molecule that enzymes work on to make products. Enzyme purpose is to increase the rate of activity and speed up chemical reaction in a form of biological catalysts. The enzymes specialize in lowering the activation energy to start the process. Enzymes are very specific in their process, each substrate is designed to fit with a specific substrate and the enzyme and substrate link at the active site. The binding of a substrate to the active site of an enzyme is a very specific interaction. Active sites are clefts or grooves on the surface of an enzyme, usually composed of amino acids from different parts of the polypeptide chain that are brought together in the tertiary structure of the folded protein. Substrates initially bind to the active site by noncovalent interactions, including hydrogen bonds, ionic bonds, and hydrophobic interactions. Once a substrate is bound to the active site of an enzyme, multiple mechanisms can accelerate its conversion to the product of the reaction. But sometimes, these enzymes fail or succeed to increase the rate of action because of various factors that limit the action. These factors can be known as temperature, acidity levels (pH), enzyme and/or substrate concentration, etc. In this experiment, it will be tested how much of an effect

Lab six requires students to observe the effects of pH and enzyme concentration on catecholase activity. Enzymes are organic catalysts that can affect the rate of a chemical reaction depending on the pH level and the concentration of the enzyme. As pH comes closer to a neutral pH the enzyme is at its greatest effectiveness. Also at the absorbance of a slope of 0.0122 the enzyme is affected greatly. The pH effect on enzymes can be tested by trying each pH level with a pH buffer of the same pH as labeled as the test tube and 1mL of potato juice, water, and catechol. This is all mixed together and put in the spectrophotometer to test how much is being absorbed at 420nm. As the effect on enzyme concentration can be tested almost the same way. This part of the exercise uses different amounts of pH 7-phosphate buffer and potato juice, and 1mL of catechol mixed together in a test tube. Each substance is put in the spectrophotometer at a wavelength set tot 420nm. The results are put down for every minute up to six minutes to see how enzyme concentration affects reaction rate. The results show that the pH 8 (0.494) affects the enzyme more than a pH of 4 (0.249), 6 (0.371), 7 (0.456), and 10 (0.126). Also the absorbance is greatest at a slope of 0.0122 with test tube C that has more effect on the reaction rate, than test tube A, B, and D.

2. We measured 1 mL of turnip peroxidase (the enzyme) and 3 mL of neutral buffer (pH corresponding to the test tube number i.e. pH 5 in test tube 5) with a syringe and disposed it into tubes 3, 5, 6, 7, 8, and 10

Within the experiment, pure catechol was mixed with different concentrations of catechol oxidase and the rate at which each solution produced benzoquinone was measured. The amount of benzoquinone made throughout the trials was measured by using a colorimeter to measure the level of “brownness” of the liquid. The colorimeter worked by shining a light through the liquid and then measuring that light on the other side to see how much of it was absorbed. In this experiment, absorbance of blue light was measured because blue light is absorbed by the color brown. The amount of blue light absorbance was measured every 15 seconds for five minutes. Because enzymes speed up reactions, more enzymes would cause the reaction to be even faster.1

The purpose of this experiment was to record catalase enzyme activity with different temperatures and substrate concentrations. It was hypothesized that, until all active sites were bound, as the substrate concentration increased, the reaction rate would increase. The first experiment consisted of five different substrate concentrations, 0.8%, 0.4%, 0.2%, 0.1%, and 0% H2O2. The second experiment was completed using 0.8% substrate concentration and four different temperatures of enzymes ranging from cold to boiled. It was hypothesized that as the temperature increased, the reaction rate would increase. This would occur until the enzyme was denatured. The results from the two experiments show that the more substrate concentration,

The purpose of this investigation is to discover the effect of pH on the activity of catalase, an enzyme which plays the integral role of converting hydrogen peroxide into water and oxygen, and discover which pH level it will work at the most efficient rate (the optimum). The original hypothesis states that that the optimum would be at a pH is 7, due to the liver, where catalase usually resides, being neutral. The experiment consists of introducing the catalase to hydrogen peroxide, after exposure to certain solutions; hydrogen peroxide, water and hydrochloric acids, all containing the adjusted pH, and measuring the height of froth formed, an observable representation of the activity of the enzyme. The final data indicated that

Catechol, in the presence of oxygen is oxidized by catechol oxidase to form benzoquinone (Harel et al., 1964). Bananas and potatoes contain catechol oxidase that acts on catechol which is initially colorless and converts it to brown (Harel et al., 1964). In this experiment, the effect of pH on the activity of catechol oxidase was conducted using buffers ranging from pH2 to pH10. Two trials were conducted due to the first trial results being altered by an external factor. The results were acquired by taking readings every 2 minutes for 20 minutes from a spectrophotometer and then recorded on to the table. The data collected in the table were then made into graphs to illustrate the influence of pH on the catechol oxidase catalyzed reaction. After analysis, the data revealed that pH did have a significant influence on the enzyme as recorded by absorbance per minute. However, the data was collected was not accurate due to external factors, thus the results are debatable and should be experimented again for validation.

Turnips and horse radish roots are rich source of this enzyme. In this experiment, we would carry out a reaction between hydrogen peroxide and guaiacol which is colorless dye, using peroxidase as a catalyst, to produce water and an oxidized form of guaiacol which is brown. The formation of brown color would serve as an indicator that the breakdown of Hydrogen Peroxide took place. The enzyme activity would be directly proportional to the brown color intensity. The color intensity would be measured using a spectrophotometer and standardized to find the corresponding concentration for each absorbance unit.

Abstract: Enzymes, catalytic proteins that at as catalysis which makes the process of chemical reactions more easily. There are two main factors that actually affects enzymes and their functions which are temperature and pH. Throughout this experiment, the study how pH and peroxidase affects each other and the enzyme was made. The recordings of how the enzymes responded when it was exposed to four different pH levels to come up with an optimum pH which was predicted in the hypothesis and the IRV at the end.

Enzymes are high molecular weight molecules and are proteins in nature. Enzymes work as catalysts in biochemical reactions in living organisms. Enzyme Catecholase is found on in plants, animals as well as fungi and is responsible for the darkening of different fruits. In most cases enzymatic activities are influenced by a number of factors, among them is temperature, PH, enzyme concentration as well as substrate concentration (Silverthorn, 2004). In this experiment enzyme catecholase was used to investigate the effects of PH and enzyme concentration on it rate of reaction. A pH buffer was used to control the PH, potato juice was used as the substrate and water was used as a solvent.

Enzymes are an important part of all metabolic reactions in the body. They are catalytic proteins, able to increase the rate of a reaction, without being consumed in the process of doing so (Campbell 96). This allows the enzyme to be used again in another reaction. Enzymes speed up reactions by lowering the activation energy, the energy needed to break the chemical bonds between reactants allowing them to combine with other substances and form products (Campbell 100). In this experiment the enzyme used was acid phosphates (ACP), and the substrate was p-nitrophenyl phosphate.

The enzyme catechol oxidase, extracted from masticated potato (Solanum tuberosum) lowers activation energy, as it is a catalyst. This enzyme can react with catechol to produce benzoquinone and water. Catechol oxidase is tested against a multitude of phosphate buffers, acidic, neutral and basic pH values, and chilled temperatures to hot temperatures. The purposes of these testes were to determine the optimal temperature and pHs at which catechol oxidase performs at. The method to measure results was the usage of a spectrophotometer (Vernier Spectrouis Plus). The spectrophotometer measures the absorbance levels of the pigment excreted when catechol oxidase undergoes a reaction. The high the absorbance, the more products produced and vise versa. The highest absorbance for the catechol oxidase submitted to different temperatures measured an average 0.6018 nm, when at 20 C. The highest absorbance for the catechol oxidase submitted to different pH values measured two averages of 0.658 at pH 6 and 0.6464 at pH 7. The conclusion taken from the available data explains that the optimal pH for catechol oxidase was between pH 6 and 7 and the optimal temperature was at room temperature at 20C.