Evaluation Of A Dialysis Bag With Two Pipettefuls Of Glucose And Starch Solution

2. What molecules remained inside of the dialysis bag? The starch had remained inside of the dialysis bag.

If the solution in the left beaker contained both urea and albumin, which membrane(s) could you choose to selectively remove the urea from the solution in the left beaker? How would you carry out this experiment?

In this lab experiment, half our group observed and measured osmosis using dialysis tubes that were represented as the semipermeable membrane. It is permeable to water and other small molecules but is impermeable to larger molecules such as the sucrose solution used in each of the four beakers and tubing. The other half of our group observed the tonicity of sheep blood to determine whether the blood was isotonic, hypotonic, or hypertonic. The 85 g/dL of NaCl solution was the ideal isotonic number in relation to the sheep blood cells as well as a reference to the other observations of the solutions.

When glucose carriers in the membrane were set to 500, the glucose transport rate for 2.00 mM of glucose was .0008 mM/min. Equilibrium was reached at 43 minutes. At 700 glucose carriers the rate was .0010 mM , and equilibrium was reached at 33 minutes. When the glucose carriers was set at 900 the rate was .012 mM/min, and equilibrium was reached at 27 minutes. After changing the glucose concentration to 8.0 mM, the glucose transport rate with 500 carrier proteins was .0023 mM/min, and equilibrium was reached at 58 minutes. With the simulation set at 700 carrier proteins the rate was .0031mM/min, and equilibrium was reached at 43 minutes. When the simulation was done with 900 carrier proteins the glucose transport rate was .0038, and equilibrium was reached at 35 minutes.

Hypothesis: If we add higher concentrations of sugar to the dialysis tubing, then the net movement of coffee into the dialysis tubing will increase.

The independent variable was the concentration of sucrose in the dialysis tubing we used as a simulated membrane.

Table 1 shows the contents of the bags and the content of the concentration it was submersed in. Bags 2-4 each contain a solution of both sucrose and water. These bags were each put into beakers containing hypertonic solution. These bags gained weight over time because the water moved from its high concentration inside the beaker to the low concentration inside the membrane of the artificial cell, the membrane being the bags that consisted of dialysis tubing. The

Using the graduated cylinder, measure 20mLs of the stock sucrose solution and 180mL of water to create a 3% sucrose solution and place it into the 250mL beaker (beaker #2). Place bags #1‐3 (red, blue, yellow) into beaker 2 and bag #4 (green) into beaker 1. Allow the bags to sit for one hour. After allowing the bags to sit for one hour, remove them from the beakers carefully open the bags, noting that often times the tops may need to be cut as they tend to dry out. Measure the solution volumes of each dialysis bag using the empty 250 ml beaker.

Three peaks are observed in Figure 1 (concentration of glucose vs. elution volume) which was expected due to the results in table 4 that show intervals of elution. The intervals of the elution are represented as peaks on the graph. The intervals are due to the glucose molecules that enter the beads of the column causing the glucose molecules to elute slowly. Two peaks are observed in Figure 2 (concentration of starch vs. elution volume), which was not expected. One peak was expected for the

The hypothesis states that if the solution is hypotonic the results will decrease, if the solution is hypertonic the results will increase and if the solution is isotonic the solution will vary and or remain constant. In order to test the predictions of the hypotonic, hypertonic, and isotonic hypothesis for the solution  made during the study,  four samples of sucrose were taken and placed into two different beakers each containing a different concentration. Then dialysis tubing A was placed into beaker 1 with B, C, and D placed into beaker 2 for 45 minutes and weighted at 15 minute intervals. My finding in the study was that each of the four samples changed from their initial weight and for the most part accurately proved the hypothesis.

There were several steps completed to prepare for the experiment. Three dialysis tubes were filled with approximately the same volume of distilled water and then were tied shut. The initial mass (in grams) of the tubes was taken using a triple beam scale. I then filled three 500 mL beakers with 400 mL of water each and dissolved different masses of solute (table sugar) in each beaker in order to make 5%, 10%, and 20% solutions. The beakers were labeled accordingly, and then 20 g, 40 g, and 80 g (respectively) of table sugar was weighed out using a digital scale and placed into the corresponding beakers. The sugar was stirred in using a stirring rod until all of the solute was completely dissolved.

In part II of the lab six small glass tubes were obtained in a test tube rack. Ten drops of distilled water were then added to test tube 1, five drops to tubes 2-4, and no drops in tubes 5 and 6. Five drops of 0.1M HCl were added to test tube 5 and five drops of 0.1M NaOH to test tube 6. Five drops of enzyme were then added to all tubes except tube 1. Tube 3 was then placed in the ice bucket and tube 4 was placed in the hot bucket at 80-900C for five minutes, the remaining tubes were left in the test tube rack. After the five minutes five drops of 1% starch was added to every tube and left to sit for ten minutes. After ten minutes five drops of DNSA were then added to all the tubes. All the tubes were then taken and placed in the

Secondly, osmosis was to be observed to gain a proper understanding of how the principal of dialysis functions.

In the final experiment we filled a dialysis bag with starch solution and tied off both ends of the bag so that it is water tight. We then filled a separate bag with sodium chloride and submerge both dialysis bags in two beakers of distilled water. We allowed the bags to sit in the water for 10 minutes. We then put silver nitrate into the water that held the dialysis bag filled with sodium chloride and recorded any changes in the water. We then added iodine to the water that held the dialysis bag of starch and observed any changes in the water.

The beaker was then filled partially with distilled water; 1 ml of potassium iodide was then added, and the solution was tested for the presence of glucose. This data was recorded in table 1 on the data sheet along with the starting color of both the potassium iodide solution and the glucose/starch solution. The dialysis tubing was then submersed into the beaker containing the potassium iodide solution, and set aside for 30 minutes to allow maximum diffusion.