Flat Tire Process

Firstly, to changing to flat tire is to pull over to the side of the road. This step is very important because if you don't pull over than someone coming on the road behind you may hit you without knowing your car is there. Many

Once you have the car in the air you will want to put some jack stands under each side and lower the car down on these, this will prevent the car from falling on you if the jack where to collapse, since jacks are only designed to pick the car up, not support it all day. Once the car is safely on the jack stands, you are ready to change the oil.

Suppose you are driving to your local convenience store. Suddenly, you hit a sharp object, and your tire blows. What do you do? Do you panic and call roadside assistance, or are you lucky enough to have the knowledge to replace the tire? It is surprising that many people have no idea how to change a flat tire. It is a shame that more people do not know how to perform such a simple and useful task. Learning this skill will help you become more independent and get you back on the road quicker. Luckily, it is not that hard to learn. Follow these simple steps, and you will have a new tire on your car in approximately eight to ten minutes.

The following steps are the safest way to change a flat tire. If you received a flat tire while driving down the road; first thing to do is to get away from oncoming traffic; at that time, find a place that is well lit, such as a parking lot. Keep in mind the farther you drive on a flat tire, the more damage you will incur to the tire and wheel. Secondly, set the parking brake so that the car does not roll away while the car is off the ground. Then, you have to locate your spare tire, which will replace the flat tire; that is usually in a compartment inside the trunk. The spare tire is secured in place by a bolt or a bracket that unscrews easily. In addition to the spare tire, you will need a jack to raise the

Once all the lug nuts are screwed on tight much sure that none of them are lose, so that they don’t come unscrewed. Afterwards lower the car, and tighten the lug nuts further, put jack, tire iron and the popped tire in the trunk, and drive off. Of course, at home, nobody thinks to double-check that the spare tire was inflated, that the jack and tire iron were in the trunk and one knows where to position the jack underneath the car, and the flashlight actually works. It being the coldest they of the year, there is no time to learn that the spare tire is not inflated and that the jack can’t be found.

Finally, you will now need to lower the car to the ground. Remove the flat tire from under the car. Crank the jack lowering the car to the ground. Do not fully lower it to the ground because you have to tighten the nuts again just to make sure you got it right. After everything is fully tightened, lower the car completely. Place the hub back on the wheel and remove the jack from under the car. Place the flat tire into your car and get it repaired if possible.

All vehicles come with the tools you need to change the tire. You will need a jack, a lug wrench and the spare tire from your vehicle. The owner’s manual from your vehicle will give you the location and a description for all of these tools. Gather these tools and lay them out in an area near the tire that is flat. Now that you have the tools, you

Once the car is lifted with the jack you're going to want to place the jack stands under the vehicle. After the jack stands are placed where they are needed. You're next job is to remove the cap for the oil which is on tip of the motor. After the cap is removed then you'll want to find the oil plug. The oil plug is going to be on the bottom of the engine. Make sure you place the oil drain pan underneath the oil pan before loosening the plug. Once you have placed the oil drain pan underneath the oil pan you will want to loosen the plug. Once you loosen the plug make sure you take it out completely. Once the plug is out oil should start draining from the oil pan. While the oil is draining you will want to locate the oil filter. The oil filter can usually be located on the top or bottom of the engine. When you find the oil filter you're going to want to twist it off. Remember "Lefty loosey righty tighty." Make sure the oil pan can catch the falling oil from the

Your next step is to remove the wheel. First, remove the adjustment screw that holds hold the wheel in place all the way. Put is aside; you will need to reuse this part. Next, use a pair of pliers to grab onto the wheel and spring assembly, and pull it out of place. Repeat this process with both wheels.

The objective of this tutorial is to instruct the reader how to swap a defective car tire for a spare. Spare tires can be used as a makeshift fix so that the driver can safely make it to a repair shop. Basic knowledge of tools and fasteners is needed for this tutorial. Failure to follow instructions closely may lead to personal injury, damage to your vehicle, or can cause an accident on the road. If you are in doubt whether or not you can handle the tutorial, call a professional or a towing company to assist you.

2. Gather your tools. If you do not own the right tools to change the oil, you will need to invest in them or borrow what you need from a friend. You must have a pair of jack stands or ramps, especially if your vehicle’s ground clearance is low. Work gloves, rags, a socket wrench, a funnel, an oil filter wrench and an oil drain pan are essential. Invest in a new drain plug if the old one is stripped.

Changing the oil in a vehicle is simple for the car owner to learn how to change car oil. It does not require many tools and supplies to complete the task. There are five easy steps changing the oil in a car: go to buy the supplies, Jack the car up, remove the oil drains plug, remove the oil filters, and remove the oil cap.

The ability to change a flat tire is a skill everyone needs to have. You end up getting a flat tire while driving in the middle of nowhere on a very hot summer day. You just could not straddle that sad little armadillo on the road. Before you know it, a loud pop comes from your car and the car starts to wobble. A bone must have gotten stuck in one of your tires. What happens now? You do not have service to call someone to fix your tire and you surely do not know how to change one yourself. Someone with a flat tire should know how to assess the situation, take the tire off, and put the new tire on.

An auto mechanic will balance a tire by applying weights around the rim of the tire. Once the tire is mounted on the wheel, it is put in a device that

Next, you need to take off the hubcap that is keeping your tire in place. You are going to need to use a tire iron to take the hubcap off your trailer. You are going to need to put the tire-iron under the top of the rim, and then work slowly to loosen and pull of the hubcap. You should work around the tire in a clockwise direction.