Heat of Mixing: Ethanol and Water

of sugar to 25ml of water and dissolve it. When we have the water at

5. Experiment: Click Reset. Check that the Solute outside is 10 and the Initial cell volume is 40%. To calculate the solvent concentration, divide the number of solvent particles by the total number of particles, and then multiply by 100. (Note: The Gizmo only displays the solute concentrations.)

(0.074 mol HCl x 1 mol NaOH) / 1 mol HCl = 0.074 mol NaOH

9. The accepted value for the density of water is 1 g/mL and the accepted density for isopropyl alcohol is 0.786 g/mL. Determine the percent error between your calculated densities and the accepted values for both water and isopropyl alcohol. Record the percent error in Data Table 4.

The results showed the molarity of the NaOH solution. This experiment was completed twice and a new average molarity

You have the mass of water from calculation #9, the specific heat of water is 4.184 J/g(oC), and the temperature change of water

3.6.3. 2, 4 – D (2, 4–Dichloro phenoxy acetic acid) stock solution (1mg/ml): 10.0mg of 2.4-D being weighed and dissolved completely in 1N NaOH to a final total volume

Our purpose in this lab was to create four solutions of the same components and different concentration. I found the concentration in Molarity (mol/liter). I would dilute a solution to create new solutions, using the formula M1xV1=M2xV2 where M=molarity and V=volume. In this lab, there were four solutions, Solution A, Solution B, Solution C, and Solution D. The solute or substance that dissolves was sugar and the solvent or substance that the solute dissolves in was water. For Solution A, I weighed 3.42 g sugar and diluted to 100 mL to get a concentration of 0.10 M and the color of bright red. For Solution B, I weighed 0.342 g sugar and diluted to 100 mL to get a concentration of 0.010 M and the color of pink. For Solution C, I measured 10

After the twenty minutes elapsed, the flask was cooled to room temperature and then titrated with the remaining NaOH until the colorless solution remained pink. The final volume was then recorded. While solution #1 was heating the same process was repeated with solution#2 and the second burette

a) Graph the following data on semi-log OR regular graph paper. Determine the D-value using the graph. Show your work.

In the scenario described in problem 7, what is the amount (in moles) of excess

3. The volume of a fixed mass of a liquid sample increases as the temperature rises from 20 to

We can assume that the specific heat capacity of water is 4.18 J / (g × °C) and the density of water is 1.00 g/mL.

We will be using 6 different fuels to heat up 100ml of water, and find out the changes of the temperature. We will measure the temperatures of the water before and after the experiment. We will burn heat the water for exactly 2 minutes, and check the changes in temperature. The change in temperature will allow us to work out the energy given off the fuel by using this formula:

3. Calculate the total heat released in each reaction, assuming that the specific heat of the solution is the same as for pure water (4.18J/gK). Use q=mcΔT. Show work here and record your answer in Data Table 2.