Industrial Training Report

Repeaters are devices for amplifying signals and retransmit at higher power on the area of an obstruction for the indication to cover longer detachments. They are used to in the

City Hall will host the Layer 3 routers and switches, in addition point to point source radios. Connecting the 9 schools and 9 buildings using the PTP radios and then distributed with simple Layer 2 switches to wireless access points located inside each of the buildings.

vicinity as well as coastal onshore radio stations. It has been said that one problem

Handheld radios will be used as the primary communication device. Each radio will be fully charged prior to the event, and set to channel 1.

The rugged waterproof outdoor enclosure allows mounting the unit next to the antenna, reducing RF coaxial cable losses and cost.

4. Radio: most common form of wireless transmission, typical of home routers and most wireless devices to use this form. Infared uses low frequency light waves to carry data using line-of-sight.

Wireless DSL is a type of fixed wireless which requires a line of sight between communicating transmitters. Unfortunately; this makes its application limited, because in order to be effective, it requires tall buildings or towers. Most multitenant buildings such as hotels, remote office buildings and apartments use this. Transmitters are what connect the building to the ISP, and the DSL used inside the building connects to the wireless transceiver. Fixed wireless can be point to point or multipoint. Satellite is another form of fixed wireless. Both the point-to-point and multipoint versions have data transmissions ranging from 1.5 to 54 Mbps, dependent on the vendor. Mobile wireless service can be set up by the provider in a package one the WAP network protocol is fixed to support it. (Wireless Application Environment) (Fitzgerald, 349-350).

A networking framework in which devices communicated with each other by first going through an Access Point (AP). In infrastructure mode wireless devices can communicate with each other or can communicate with a wired network. With one AP is connected to wired network and a set of wireless stations it is referred to as a Basic Service Set (BSS). An extended service set (ESS) is a set of two or more BSSs that from a single sub network. Most corporate wireless LAN operates in infrastructure mode because they require access to the wireless LAN in order to use services such as file services or printers. A cellular network or mobile network is a wireless infrastructure base network distributed over land areas called cells.

It's the only weather station in it's class that uses frequency hopping spread spectrum radio technology translating weather data wirelessly

The Company leases space on its communications towers to tenants providing a diverse range of communications services, including personal communications services,

2. Outcome: To expand professional certification and credentialing of these professionals. As a result, it will provide efficiently and effectively individual skill sets to enable our road to success and sustain operations and the Institution of Excellence (IOE).

The service radio coverage is correct, if the service area is secured by the base stations. The service area is secured, if the unification of radio cells of every base station contains the whole service area (Svilen, n.d). The radio cell of a base station is a part of the space around it, in which a portable station watches the base station with radio signal strength adequate for correspondence (Svilen, n.d). The adequate radio signal strength in the service area is a basic prerequisite for the portable stations to be able to access to the WMN. The radio coverage service guarantees this adequate signal strength in the service area (Svilen, n.d). A service location is a state of the service area, determined by its directions. A service location

The antennas on this tower are attached to a metal pole and structure themselves with an Antenna Array as visible in the screenshot. This structure can usually carry from 3 to 18 antennas, depending on the number of wireless carriers and volume of transmission. Also, by using the Antenna Array, the antenna can increase the overall gain and cancel out interference from a particular set of directions. Another benefit of the Antenna array is that it maximizes the Signal to Interference Plus Noise Ratio The tower is located at 2716 46th Street Tampa, FL. It is composed of many omnidirectional antennas that point on different views and angles. The current tower coordinates point to Latitude 27.9677 and Longitude -82.4077. As I mentioned before, it is required by the Federal Communications Commission that any antenna which height more than 200ft above ground level will be registered to avoid interferences. I searched for this information in the Antenna Structure Registration section of the Federal Communication Commission and below there is the

It is our goal to help our members develop the necessary skills and resources to succeed in their academic and professional careers. Throughout the year, we plan to hold resume workshops, networking how- to events, and workshops on professionalism. We hope to produce young engineers fit with the skills, both technical and social, to excel in industry.

operation but also needs to have an appropriate proposed design. It employs two techniques to improve the radiation pattern. These techniques are the use of an angled dipole and vertical copper plates arranged on the ground plane for improvement in the radiation pattern of lower and upper bands, respectively radiation profile in both bands, namely similar gain, wide beamwidth. One of the popular techniques for broadening the patch antenna bandwidth is to incorporate a U-slot on its surface. They have the ability to confine the power in certain directions instead of scattering the power everywhere.