Introduction To Identity The Unknow Acid Solution

Purpose/Hypothesis: The purpose of this experiment is to use both cabbage juice and pH paper to determine the pH of household items. This way, we can tell which products are basic and which one are acidic. If we use cabbage juice as an universal pH indicator by comparing it to pH paper then pH determined by the cabbage juice will be unstable because by using cabbage juice, it can be different depending on how diluted it is.

The purpose of this experiment is to determine an unknown concentration of acid (hydrochloric acid) with a standard solution of a base (sodium carbonate) using titration method.

The purpose of this semester long experiment was to determine an unknown organic acid. An organic acid is an organic compound with acidic properties. A base reacts with acids to form salts. Titrations are used to determine the concentration of unknown substances. The purpose of the KHP experiment was to determine the molarity of NaOH. HCl titrations are mainly to check technique and used to verify the molarity of NaOH solution. The hypothesis is that this acid is C4H3OCOOH.

In this assignment you will be asked to rank aqueous solutions of acids, bases, and salts in order of increasing pH. This is most easily done by first identifying the strong acids that have the lowest pH, the strong bases that have the highest pH, and the neutral solutions that have a pH near 7. The weak acids

The purpose of this experiment was to determine the pKa, Ka, and molar mass of an unknown acid (#14). The pKa was found to be 3.88, the Ka was found to be 1.318 x 10 -4, and the molar mass was found to be 171.9 g/mol.

Question: The equivalence points of the two titration curves were not in the same pH range. Explain. (Why was the pH at the equivalence point different for the two different acids?)

By using the pH paper to measure the solutions A through E it would point out what substance is an acid and which one was basic. Also, by adding Bromothymol blue and Phenolphthalein afterwards to the solution it would indicate what color it would turn to when mixed into an acid and a base.

2. In Part I of this experiment, acetic acid is titrated with NaOH. The net ionic equation for acetic acid reacting with NaOH is CH3COOH+ NaOH =NaC2H3O2+H2O. The equivalence point is when the moles of the titrant and other solution are equal.. You detect the equivalence point by obtaining the point on the graph where the steep pH occurs. In titrating acetic acid with NaOH, the pH is greater than 7 at the equivalence point because NaOH is a strong base so it results in a higher pH, due to the OH- ions in the solution.

To begin, three sets ofabout 0.3000g of KHP are weighed out on an analytical balance. Put the three sets of KHP into three separate, labeled flasks. All three sets of the KHP is then dissolved with approximately 50mL of deionized water. Next, a buret is used to start the actual titration. Buret is initially filled to 0.00mL mark with the NaOH solution, this is recorded as initial volume. Next, add 2-3 drops of phenolphthalein indicator into each of the three flasks containing KHP. A magnetic stir bar is then added to the first flask, and placed above a stir plate. Everything is positioned under the buret. Stirrer is put on medium speed and the titration can start. Slowly release the NaOH into the KHP flask. As the end point is reached, a pink color will be seen in the flask. When the lightest pink possible remains in the solution for more than 30 seconds titration is complete. The final volume is recorded, and the same steps are taken for the other two sets of KHP solution. Finally, blank titration is completed to determine deviation.

Observe and measure a weak acid neutralization and determine the unknown identity of an unknown acid by titration.

By using acid-base titration, we determined the suitability of phenolphthalein and methyl red as acid base indicators. We found that the equivalence point of the titration of hydrochloric acid with sodium hydroxide was not within the ph range of phenolphthalein's color range. The titration of acetic acid with sodium hydroxide resulted in an equivalence point out of the range of methyl red. And the titration of ammonia with hydrochloric acid had an equivalence point that was also out of the range of phenolphthalein.. The methyl red indicator and the phenolphthalein indicator were unsuitable because their pH ranges for their color changes did not cover the equivalence points of the trials in which they were used. However, the

First, three titration curves and three second derivative curves were created to determine the average pH at the half-equivalence point from the acetic acid titrations. Titration curves were used as visuals to portray buffer capacity. The graphs and a table, Table 1, that showcased the values collected were created and included below. The flat region, the middle part, of Figures 1, 2 and 3, showed the zone at which the addition of a base or acid did not cause changes in pH. Once surpassed, the pH increased rapidly when a small amount of base, NaOH, was added to the buffer solution. Using the figures below and

In this lab a acid-base indicator phenolphthalein was used to determine endpoint of a reaction HCl(aq) and KOH(aq). At the end point all of the HCl(aq) would have reacted with KOH(aq), and the pH becomes 7. The phenolphthalein would changed colours from colourless to pink indication when enough KOH(aq) was added. The purpose of numerous trials was to use the average volume of the 3 trials with similar measurements.

An acid-base titration is the determination of the concentration of an acid or base by exactly neutralizing the acid/base with an acid or base of known concentration. This allows for quantitative analysis of the concentration of an unknown acid

For this experiment, a pH meter was used so this part of the experiment began with the calibration of the pH meter with specified buffers. The buret was then filled with the standard HCl solution and a set-up for titration was prepared. 200g of the carbonate-bicarbonate solid sample was weighed and dissolved in 100 mL of distilled water. The sample solution was then transferred into a 250-ml volumetric flask and was diluted to the 250-mL mark. The flask was inverted several times for uniform mixing. A 50-mL aliquot of the sample solution was measured and placed unto a beaker. 3 drops of the phenolphthalein indicator was added to the solution in the beaker. The electrode of the pH meter was then immersed in the beaker and the solution containing the carbonate-bicarbonate mixture was titrated with the standard HCl solution to the phenolphthalein endpoint. Readings of the pH were taken at an interval of 0.5 mL addition of the titrant. After the first endpoint is obtained, 3 drops of the methyl orange was added to the same solution and was titrated with the standard acid until the formation of an orange-colored solution. Readings of the pH were also taken at 0.5 mL addition of the titrant.