Iontophoresis In Physical Therapy

I obtained the results from the experiment supported my predictions because as the the concentration Na+ Cl- was increased from 5 mM to 10 mM (by adding more Na+ Cl-), the osmotic pressure also increased. However, after the membrane was changed to 50 MWCO, the Na+ Cl- molecules could diffuse easily through the membrane and did not caused an increase in osmotic pressure.

In this lab experiment, half our group observed and measured osmosis using dialysis tubes that were represented as the semipermeable membrane. It is permeable to water and other small molecules but is impermeable to larger molecules such as the sucrose solution used in each of the four beakers and tubing. The other half of our group observed the tonicity of sheep blood to determine whether the blood was isotonic, hypotonic, or hypertonic. The 85 g/dL of NaCl solution was the ideal isotonic number in relation to the sheep blood cells as well as a reference to the other observations of the solutions.

Osmosis is described in one of three ways when comparing more than one solution. The cell’s external and internal environment helps determine tonicity, which is defined as how the cell reacts to its environment. When the cell’s environment is equal in osmolarity to itself and there is no change, it is considered an isotonic solution. When the environment has a higher osmolarity, shrinkage occurs and it is considered a hypertonic solution. When the environment has a lower osmolarity, swellings occurs and it is considered hypotonic.

The purpose of these experiments is to examine the driving force behind the movement of substances across a selective or semiperpeable plasma membrane. Experiment simulations examine substances that move passively through a semipermeable membrane, and those that require active transport. Those that move passively through the membrane will do so in these simulations by facilitated diffusion and filtration. The plasma membrane’s structure is composed in such a way that it can discriminate as to which substances can pass into the cell. This enables nutrients to enter the cell, while keeping unwanted substances out. Active

Purpose: The purpose of this lab is to familiarize you with osmosis and, specifically, what happens to cells when they are exposed to solutions of differing tonicities.

The concept of osmotic pressure must be understood when studying osmosis. The movement of water from a hypotonic solution through the membrane into a hypertonic solution can be prevented by applying force or pressure on the hypertonic side. The force that must be applied to prevent osmotic movement of water from hypotonic to hypertonic, measured in atmospheres, is referred to as osmotic pressure. Solutions with greater concentrations of OAS have greater osmotic pressures because greater force is required to prevent water movement into them. Distilled water has an osmotic pressure of zero.

Transdermal medications come in the form of patches that are applied to the skin normally to the chest or upper arm. They work by allowing the medication to be released slowly and then absorbed. For example, Hormone Replacement Therapy (HRT) patches and nicotine patches.

In this experiment, we will investigate the effect of solute concentration on osmosis. A semi‐permeable membrane (dialysis tubing) and sucrose will create an osmotic environment similar to that of a cell. Using different concentrations of sucrose (which is unable to cross the membrane) will allow us to examine the net movement of water across the membrane.

The difference is that along with large molecules, living cells prevent molecules with positive charges and solubility. This is not representing in dialysis tubing, and is only found in living cells because the tubing is only based on molecular size (98). When referring the rate of diffusion, the concentration gradient influences the diffusion rate, based on the factors of temperature. The ability for molecules diffuse from high to low concentrations primarily depends on the concentration gradient between the two areas.(96-99). My hypothesis for the study is that in the hypotonic, hypertonic, and isotonic solutions, the direction and rate of osmosis will determine based on the concentration inside the dialysis tubing. My prediction is that if the solution is hypotonic the results will decrease, if the solution is hypertonic the results will increase and if the solution is isotonic the solution will vary and or remain constant.

Osmosis is the passive movement of water from an area of low solute concentration to an area of high solute concentration, normally across a membrane which prevents the movement of solvent. This is a process by which materials may move into, out of, or within cells. Osmosis doesn’t depend on energy provided by living organisms but is affected by the properties of the cell membrane. The rate of osmosis is dependent on such factors as temperature, pressure, molecular properties such as size and mass, and the concentration gradient. In osmosis, the relationship between a solute’s concentration outside of cell and inside of a cell is described in terms of the tonicity of the solution outside of the cell. A cell is in a hypotonic solution when the solute is more concentrated inside the cell and therefore water moves into the cell. In this solution the cell swells as water enters, this may continue until it ruptures or hemolyzes. In the reverse condition, the cell is in a hypertonic solution

In this lab, neutral red was used as a pH indicator. The color changes from yellow to red in a basic solution to an acidic solution. The neutral red dye was applied to Saccharomyces Cerevisiae. When the S. Cerevisiae cells come in contact with the neutral red dye, the dye gets to the cell by crossing the cell membrane. The cell membrane is the outer surface of the cell that functions as a barrier. The outside of the cell membrane is made of lipid and membrane proteins (Hardin, 2012). It is selectively permeable, which means only select ions and molecules can pass through it by transport. Membrane transport can be actively or passively moving a substance from side of the membrane to another (Hardin, 2012). Passive transport does not require energy to move molecules across the cell membrane. Diffusion is a form of passive transport that moves molecules across the membrane from an area of higher concentration to an area of lower concentration. Osmosis, diffusion, and facilitated diffusion are all examples of passive transport. Active transport requires energy to move molecules across the membrane from areas of lower concentration to higher concentration. It requires energy because it pushes sodium ions (Na+) and potassium ions (K+) (Hardin, 2012). When the dye entered the cell, it also showed its location. Sodium azide (Na+N3-) is a metabolic inhibitor that blocks the flow of electrons along

represents a type of potential energy that accounts for the both concentration and the membrane

Cells are always in motion, energy of motion known as kinetic energy. This kinetic energy causes the membranes in motion to bump into each other, causing the membranes to move in another direction – a direction from a higher concentration of the solution to a lower one. Membranes moving around leads to diffusion and osmosis. Diffusion is the random movement of molecules from an area of higher concentration to an area of lower concentration, until they are equally distributed (Mader & Windelspecht, 2012, p. 50). Cells have a plasma membrane that separates the internal cell from the exterior environment. The plasma membrane is selectively permeable which allows certain solvents to pass through

This can be done by the iontopheretic procedure, which is a process that uses an electric current to deliver ionized molecules of fentanyl across the skin and into the systemic circulation. This is made possible by the electrical potential across the skin, which alters its permeability hence producing potential-dependent pores in the lipid bilayer. The increase in pores is directly proportional to the current applied relative to the desired quantity of fentanyl administered.2

Intramuscular injection is used for the delivery of certain drugs not recommended for other routes of administration, for instance intravenous, oral, or subcutaneous. The intramuscular route offers a faster rate of absorption than the subcutaneous route, and muscle tissue can often hold a larger volume of fluid without discomfort. In contrast, medication injected into muscle tissues is absorbed less rapidly and takes effect more slowly that medication that is injected intravenously. This is favorable