Thin Layer Chromatography Lab Report

Different procedures were used to isolate benzil from the ether layer and benzoic acid from the aqueous layers. To isolate benzil, anhydrous MgSO4 was added to the flask containing the ether layer solution. MgSO4 removes the remaining water in the ether layer solution. After making sure that enough amount of MgSO4 present in the solution, the ether solution was filtered by using gravity filtration. During filtration, MgSO4 was removed from the solution and the ether solution was collected in 25 ml flask. To separate benzil from the filtered ether solution, the beaker containing the ether solution was heated until the ether evaporated. After letting the beaker to cool to room temperature, the mass of the beaker with the benzil crystals was measured. From the combined mass of the beaker and the benzil crystals and from the predetermined mass of the beaker, the mass of the collected crystals was calculated to be 0.266 gram.

2. What do you think would happen if you watered your houseplants with salt water?

In this lab, liquid-liquid extraction was performed to isolate a mixture of benzocaine and benzoic acid. 2.0107 grams of the mixture was first weighed out for the trials. When HCl was added to the mixture for the first acid extraction of benzocaine, an emulsion formed during inversion and venting that prevented a defined separation of the two layers. 8 mL of water was therefore added before continuing the extraction. The addition of NaOH then turned the top aqueous layer basic, indicated by the pH strips that turned blue when tested. A vacuum filtration isolated 0.29 grams of benzocaine and a MelTemp apparatus measured the crystal’s melting point ranges to be 85.1C-87.4C. For the base extraction of benzoic acid, the aqueous layers were retrieved

Adsorption chromatography occurs when “one substance form[s] some sort of bonds to the surface of another one”, creating intermolecular forces between the two substances (Chemguide). For thin layer chromatography, the components of the mixture are adsorbed onto the stationary phase that covers the plate (Chemguide). The more polar a substance is, the more strongly adsorbed it is (Chemguide) and the strong intermolecular forces then result in a slower rate of migration with respect to the moving phase. As the solvent touches the TLC plate, the solute (mixture) is allowed to move up the TLC plate

9) Filter the ppt formed as result of step 7 from the newly acidic solution.

In this experiment, distillations were done. This is a technique that utilizes the differing boiling points of two or more compounds in a mixture in order to separate the compounds from the mixture. The way fractional distillation works is that the initial mixture is boiled up to the point of the lower boiling point compound; this compound then evaporates. This compound is then

In this experiment, a mixture of unknown #3 was used. That mixture had acid, base, and neutral. We added solvent to the unknown. It is important to know the density of the solvent in order to determine which is the aqueous layer and which is the organic layer. If the solvent that has more density than water, so the organic layer will be the lower layer, while if the solvent has lower density than water, the organic layer will be the upper layer. This will make an error if the determination of the layers was wrong after added the strong acid or the strong base. We added 5% HCl to the mixture in order to separate the base in the aqueous layer and form its salt. Same thing, we add 5% NaOH to the mixture in order to separate the acid and form its salt. In order to recover the base, we add 10% NaOH to the HCl extraction. The result will be salt with a base. Same thing for the acid, in order to recovered it, we added 10% HCl. The reaction will give us salt with an acid. For the neutral, we added sodium sulfate as a drying reagent in order to dry water and separate the neutral part as pure.

Answer: Distillation is a method for separating a liquid from a solid or from another liquid in which the liquid is boiled off and then recondensed (Yee, n.d., Distilliation). It works because the substance you are looking to distill is boiled off recondensed and separated. It can be used to purify liquids from solids or from other liquids (Yee, n.d., Distillation).

IV) Part C Results: 1) Complete the following table by rating each pair of liquids as either miscible or immiscible. (2 Points)

2. Plan: Each student in a group of three will work to create a reaction with the Benzonitrile Oxide with, cis-stilbene, trans-stilbene, or styrene in an Erlenmyer flask. With this Reaction solution thin layer chromatography will be performed using each reaction solution. The different reactions will then be compared by running co-spot TLC’s. An NMR of the crude products from each reaction will be taken.

Experiment 4A: Determination of a Partition Coefficient for Benzoic Acid in Methylene Chloride and Water, and Experiment 4B: Solvent Extraction I: Acid-Base Extraction Using the System Benzoic Acid, Methylene Chloride, and Sodium Bicarbonate Solution

On a thin chromatography plate, five spots were placed ( as shown in table 2) and the plate was developed using chloroform/methanol. This was later visualized with dragendorff’s reagent under the UV light. All separated components were observed, identified and recorded.

3. Q-Thinking about what you learned in the lab and doing some additional research, if you mixed fresh and salt water together in the marine environment, how would the water “layer”? Where would the freshwater be and why?

     Liquid chromatography is an analytical technique that is useful for separating ions or molecules that are dissolved in a liquid phase. If the sample solution is in contact

AIM : Thin-Layer Chromatography can show many different characteristics of a mixture. It is recognized for isolation , separation ,identification, and anaylsis of the mixture’s components. The purpose of this experiment is to separate carbohydrates into its pure components such as mixtures of monosacrides by TLC. TLC is used to identify sugars in normal and pancreatic disease urine, the procedure is easy and reproducible .