Lab Report On Chemistry

The experiment is to observe a variety of chemical reactions and to identify patterns in

During the immersion of the magnesium metal in the hydrochloric acid solution, white bubbles could be seen escaping the surface of the metal as gas was produced during the reaction. Depending on the temperature of the hydrochloric acid and the overall molar concentration, the rate of reaction differed but the same signs were shown. During the reaction between the magnesium metal and higher concentrations of hydrochloric acid, it was observed that the test tube grew quite warm to the touch. As the immersed magnesium strip sank down, it appeared coated in a layer of white bubbles that fizzed like a carbonated drink. In the lower concentrations of hydrochloric acid, the strip spent some time floating at the surface of the solution in the test tube, later sinking down to the bottom as the

The purpose of the lab was to determine the ratio of air to acetylene results in complete combustion of acetylene gas. The balanced chemical equation for this experiment was C2H2(g) + O2(g) --> CO2(g)+ H2O(l). Complete combustion is the reaction of an element or compound with oxygen to produce the most common oxides and energy. Complete combustion occurs when the fuel and oxygen combine in exact proportions to completely burn the fuel, which leaves a clean test tube. Incomplete combustion is the reaction of an element or compound with oxygen to produce some oxides with less oxygen than the most common oxides. Incomplete combustion occurs when there is not enough oxygen to react

Add hydrochloric acid to the household product, and if the chemicals began to bubble, once mixed together, then this would indicate that sodium bicarbonate is present.

The first experiment is about the combustion of magnesium after which the ash is formed.

Please Note: This lab involves a lot of waiting for the gas collection. Make sure you allot yourself the full three hours to perform the experiments.

About 80 mL of HCl was obtained and mixed with phenolphthalein. Using a LabQuest unit and Gas Pressure Sensor kit, the HCl mixture was added to the flask with the magnesium ribbon and allowed to react. When reaction was complete, the change of temperature and gas was recorded. This procedure was repeated for different masses of magnesium ribbon (masses found on page 89 of the lab manual). After the completed procedure, moles of H₂ produced in each trial were calculated. (The actual procedure can be found on pages 87-89 of the lab manual)

The goal of this lab was to determine the amount of grams of sodium bicarbonate (NaHCO3) required to produce enough CO2 gas to completely fill the lab and also how many Alka-Seltzer tablets that would equate to. This was done by collecting CO2 gas by inverting a buret and submerging it under water in order to calculate the volume of CO2 released from a fragment of Alka-Seltzer tablet. The main component of Alka-Seltzer is sodium bicarbonate, used to neutralize excess stomach acid during illness through the following reaction that generates CO2:

Many combustion reactions involve the burning of organic compounds called hydrocarbons, compounds containing the elements carbon and hydrogen, or other organic compounds. When a hydrocarbon is burned completely, the products of the combustion reaction are usually carbon dioxide and water. Natural gas, propane, and wood all burn to produce carbon dioxide and water as the products.

I believe the type of reaction to have occurred to be a condensation reaction as H2O has been produced as a by-product.

Working in the hood or a designated work area, add about 1 mL of ethyl alcohol to a clean evaporating dish. Place the evaporating dish on a heat- resistant pad.

To see if the concentration of hydrochloric acid will increase the rate of the reaction between magnesium ribbon and hydrochloric acid.

The procedure for this experiment was to first obtain four balloons and blow them up in order to stretch them. Then obtain and fill the four large test tubes each with thirty milliliters of warm forty degrees Celsius water and two grams of dry yeast which was weighed on a scale and scooped out by a spatula. After five milliliters of water, ten percent glucose, fructose or sucrose went into one of the four test tubes. Then parafilm was placed on top of each of the test tubes to seal them and they were swirled activating the yeast through rehydration. After swirling the film was removed and the balloons were tightly placed on the test tubes. Then finally observed the tubes build up of CO2 all the while swirling gently every fifteen minutes, recording observations.

The volume of carbon dioxide gas produced from a reaction was measured in order to determine what carbonate sample was used. A gas assembly apparatus was used to capture the gas from a reaction between an unknown carbonate and 6M hydrochloric acid; three trials were performed. The mass of the unknown carbonate was determined, and the reaction occurred in a test tube. The volume of gas produced by the reaction was measured, and the partial pressure of carbon dioxide was calculated after the partial pressure of water vapor was determined using Dalton’s Law of Partial Pressures. The percent mass of carbon dioxide gas was then calculated, and the average mass percent was compared to the table of known carbonates. It was concluded that the unknown carbonate sample used in the reaction was magnesium carbonate.

Carbon dioxide, in its gaseous form, is a natural constituent gas of the Earth’s terrestrial atmosphere [5]. According to the standards outlined by The International Institute of Refrigeration the chemical formula for carbon dioxide is CO2 and the refrigerant code for carbon dioxide is R744 [6]. CO2 gas is poisonous to living organisms when inhaled in a sufficiently concentrated form. The molecule of carbon dioxide consists of two oxygen atoms bonded to one carbon atom. It can be produced by the combustion of hydrocarbons, as the product of breathing of living people and animals and by fermentation [7]. The carbon dioxide molecule is illustrated in the figure that follows: