Le' Chatelier's Principle

You find a sample of a solution that has a faint odor resembling vinegar. You are verifying that it is indeed vinegar and you add a few drops of phenolphthalein. The sample turns pink. What assumptions can you make about this sample?

The two most obvious formation of the precipitate were the combinations with the MgSO4. The MgSO4 and NH3 solution became very opaque and the MgSO4 and Na2CO3 turned from liquid to a full solid white substance. The Na2CO3 and CH3COOH did not have as strong of a reaction, however, the precipitates were able to be visualized with in the clear

6. We added 1.0 mol dm-3 of NaOH into tube #7 until a change in color is observed.

20) If the solid is still not dissolved, add a tiny amount of hexane and swirl again.

When the red Co(NO3)2*6H2O crystal was added to the white NH4 crystal, and water was added to dissolve, the solution turned blue in color. As the solution was nixed, the color changed to that of a blue-purple and a blue precipitate formed. When the 6 M NH3 began to be added, the color shifted to dark purple color after 15 mL of ammonia and the amount of the precipitate was less. After 20 mL of ammonia, the solution became a red brown with very little of the blue precipitate. After 30 mL of ammonia, the solution was similar in color to an iodine solution, a dark brown-red, almost black in color. At this point there was no visible precipitate on the surface of the solution. After 40 mL of the ammonia had been added, the solution was the same iodine like color as before. When closely examined, there was a black precipitate that had settled on the bottom of the beaker. At this point, hydrogen peroxide, 3% H2O2, was added to solution. After 4 mL of the H2O2 was added, the solution was the same color and the precipitate had not changes. After 8 mL of the H2O2, there was not noticeable change. After 12 mL of the H2O2, the solution was slightly redder in color but the precipitate had not changed. After 15 mL of H2O2, the solution was the same color and no changes had occurred to the precipitate. At 17 mL, the solution began to effervesce slightly, though there

The objective of the experiment is to apply Le Chatelier's Principle, which is a system that responds to an external stress and then adjusts itself in order to alleviate the stress when it is at equilibrium. A reactant is added, and the equilibrium is reestablished, resulting in more products and fewer reactants, and thus, the position of equilibrium is shifted to the right. When a product is added, the equilibrium position is shifted to the left because there are more reactants and fewer products.

After adding all four reactants and keeping the mixture cold a cloudy, white residue was present in the bottom of the flask.

Heavy precipitate emerged immediately and solution turned white in color; solution then became opaque and turned light, bright blue in color.

NH3. Add 20 mL water to the beaker by filling and emptying the 10 mL cylinder into the beaker

The solution is stirred with a stirring rod and stopped as soon as the pink colour disappears.

Place 100 ml of distilled water in a 250-ml (or 400-ml) beaker. Add 1.26g of oxalic acid dihydrate (H2C2O4.2H2O) and 1 ml of concentrated ammonia. Stir the mixture until the solid has dissolved completely.

2. Add about 20 mL of distilled water and stir the mixture with a glass stirring rod to dissolve the sample. There may be a small amount of insoluble residue. If your sample does not dissolve completely, remove the insoluble material by filtration.

When it is almost neutralized, pour possible minimum amount of sodium hydroxide for a fair result.

The black precipitate was allowed to settle and then the supernatant, the clear liquid that lies above a precipitate, was decanted, or poured carefully off. Then, 200 mL of hot distilled water was added and the precipitate was allowed to settle to repeat the decanting process again.

Sodium hydrogen carbonate was added to the solution until it becomes neutral. Ph paper was used for this test to determine its ph value.