Methanolic Extract of Eggplant (Solanum Melogena) Peel as a Dye Pigment in Differential Stains

An unknown bacterium was handed out by Dr. Honer. The appropriate tests were prepared and applied. The first procedure that was done was the gram stain. Under a microscope, if the gram stain is purple, the bacterium is gram positive, if the stain is red, it is gram negative. The next test was the fermentation tests for glucose, sucrose and

Lycopene and β-carotene are separated using thin layer chromatography (TLC). A mixture of tomato paste containing dissolved lycopene and β-carotene is first spotted on a TLC plate. The technique uses a stationary phase layer, on which the substances stick, and a mobile phase, which migrates upwards the plate and carries the components of the mixture with itself (Chemguide). Depending on their respective polarity, lycopene and β-carotene stick more or less to the stationary phase and so they migrate up the TLC plate at different rates (Chemguide). Thus, as the chromatography is completed, the two components will appear as distinct dots at different heights on the plate. Lycopene has a bright orange color, whereas β-carotene is light yellow.

The Gram stain was used to determine if the bacteria was gram positive or negative. A negative test shows a pink color and a positive test is a purple color. When a bacterium is negative it is because it has an outer membrane and a thin layer of peptidoglycan that is much harder to stain. A positive bacterium has a thick layer of peptidoglycan and no outer membrane that can be penetrated by crystal violet.

For this experiment we were instructed to conduct our own procedure with whichever combination of treatment we thought best would yield the greatest amount of absorbance of betacyanin. My lab partners and I chose to do treatments with ethanol a mild organic solvent, 1% triton a mild detergent solution , and a combination of ethanol and triton.

2) Record the shape of the bacteria, the arrangement of the bacteria, and the gram staining characteristics.

In the beginning of this experiment, our TA added water, salt, and 75/25 hexane/acetone to spinach leaves to a blender and blended the mixture to assume equal amounts for each group and to avoid erros if each student had to do the blending. The addition of the water to the mixture allowed the it to separate into a distinct organic layer after being run in a centrifuge, which was available to be collected at the top of the centrifuge. Salt reduces solubility, which will force the organic parts of the mixture (the desired pigments for example) to separate into the organic layer at the top. Lastly, 75/25 hexane/acetone is added because this is a moderately polar solvent and will useful for both the non-polar and polar pigments present within the spinach leaves. A mixed solution of hexanes and acetone must be used because acetone is very polar, while hexane in very non-polar, and the spinach leaves contain both non-polar and polar pigments in them that are important in the extraction and for further analysis. The mixture was placed in the centrifuge so the solids in the mixture (mostly cellulose) could be separated from the liquids into separate distinct layers for further extraction and testing. In the tube, the organic substances separated into the top layer, whereas the water layer remains at the bottom of the tube below the solid layer made up of mainly cellulose.

This experiment was given to us to utilized previous knowledge learned throughout the semester to identify a gram negative unknown bacterium. We had to first learn the difference between a gram negative and a gram positive organism. We started off with doing gram stains to determine whether it was positive or negative. Based on the gram stains, a gram positive stains purple and a gram negative stains pink. A gram positive stains purple because the cell walls is made of a thick peptidoglycan layer and doesn’t

Abstract: The purpose of this lab is to separate and identify pigments and other molecules within plant cells by a process called chromatography. We will also be measuring the rate of photosynthesis in isolated chloroplasts. Beta carotene, the most abundant carotene in plants, is carried along near the solvent front because it is very soluble in the solvent being used and because it forms no hydrogen bonds with cellulose. Xanthophyll is found further from the solvent font because it is less soluble in the solvent and has been slowed down by hydrogen bonding to the cellulose. Chlorophylls contain oxygen and nitrogen and are bound more tightly to the paper than the other pigments.

Two smears of the unknown bacterium #5 were inoculated while the second smear was used for a back up. The unknown bacterium dried for at least forty minutes. After the smears dried, the slides were heat fixed two times to ensure the stability of the organism. The slide was placed on top of the staining rack then over the small sink.

In the Dyes and Crimes laboratory experiment, the phosphorescence, fluorescence, and chemiluminescence properties i.e. traits of several chemicals were examined using (UV) Ultraviolet lamp. Observations on color, intensity, duration of glow, etc. were analyzed to determine the traits of the several chemicals. Correspondingly, the author of the unsigned note was determined through ink extraction, (TLC) Thin Layer Chromatography, (UV-Vis) Ultraviolet-visible spectroscopy along with the Rf values for of each individual sample of ink compared to the unknown: the ink of the author on the unsigned note. Phosphorescence substances

Crystal violet stains the cell of the bacteria and is placed over the heat fixed slide for one minute then rinsed with H2O. The mordant that binds the stain is gram’s iodine and is recommended to be present on the slide for one minute. Alcohol is used as the decolorizer and is dripped over the recently rinsed slide until the slide runs slightly blue. If the bacterium retains the crystal violet it is due to the thicker peptidoglycan in the cell wall (gram-positive). The bacteria will then be stained with the counterstain safranin for 45 seconds. When crystal violet is not retained in the cell wall of the bacterium it will stain pink (gram-negative). A gram stain was immediately performed with the recently inoculated streak plate. An inoculating loop was used to gather some of the bacteria from an isolated colony. The loop was placed on a new slide and the transferred bacterium to the slide. The slide was dried, heat-fixed, and the gram stain process just described was completed. After microscopic analysis, it was determined the first unknown bacteria was a gram-positive cocci. The second unknown was determined to be gram-negative cocci. With this information a set group of test decided and performed based on the Unknown Bacteria Flow Chart as provided in the lab manual (Pg.) these test and the results are shown in record on the following pages. These are separated for the gram positive and the gram negative

Spores can be stained using specific dyes, such as malachite green, that are absorbed by spores in the presence of heat (Noonan).

The purpose of this experiment was to take spinach leaves and extract the chlorophyll and carotenoid pigments by using acetone as the solvent. The chlorophyll and carotenoid pigments were extracted by using column chromography and alumina was used as the solvent. Solvents of different polarities were used, starting with the least polar, to extract the certain components from the leaves. They were then analyzed by using thin- layer chromatography.

In the first part of this laboratory experiment, a multi-colored leaf was removed from a Coleus plant that was in direct sunlight for several hours. The hypothesized results for which pigments were present and the results of an I2KI starch test were then recorded. A boiling alcohol bath was set

The particles that were collected for the lab were very concentrated prior to being mixed into the medium. Once the particles where mixed into the medium they was a decreased in their concentration as the medium allowed for separation by filling the spaces between them. Once the first streak was made it was slightly less concentrated and this allowed for the particles to be spread out over the surface. The concentration of particles that were spread with each streak continued to decrease. In the final streak, as seen in picture 7, the particles were separated almost to the point of being able to individually identify each color of particle. Much as the same results that you might see with a mixed culture that was completed in a lab and final results reviewed under a microscope.