Mimicking a Double Skin Roof Experiment Essay

What buret reading should you record when the liquid level is as shown in Figure 2?

2.2 Describe what health and safety factors need to be taken into account when moving and positioning individuals and any equipment used to do this.

5.2 Avoiding hazardous manual handling , conducting a full risk assessment, reporting immediately any difficulties adhering to agreed working practices and using equipment correctly.

each Ob­Scertainer. I formed a hypothesis for each one, then I took retests to make more

1. Make sure that you understand the objective of the lab(s) and the requirements for successfully performing them.

| Describe how the health and safety control equipment relevant to the work should be used in accordance with the given instructions.

|2.4 Explain how health and safety risk assessments are monitored|(6/9) |  |  | 019 | 019 |  |  |  |  |  |

Table 1: This table shows the position that the solution was at inside the graduated tube it was held in at each time interval it was measured.

The volume of a small test tube and a thin-stemmed pipet were determined in this section of the lab. Water was poured into a small test tube until the water reached the very top edge of the test tube. The test tube was then emptied into a plastic 25 mL graduated cylinder and volume was measured and recorded into data table 3. A think-stemmed pipet was completely filled with water. Drops were carefully counted and emptied into the empty plastic 25 mL graduated cylinder until the water level reached 1 mL. The number of drops in 1 mL was recorded into data table 3. The thin-stemmed pipet had a total volume of 4 mL and that was also recorded into data table 3.

1. explain the procedures to follow for safety checking the following in a play environment:

Over a long period of time, a consumer’s most traditional choice for a roofing system was asphalt shingles. Other options were sparse and if you wanted to purchase a distinct roofing material compared to asphalt shingles; metal roofing was one of the roofing materials that would do the job. When most homeowners begin contemplating about a metal roof, all they could visualize were the roofing materials they had observed on barns and commercial buildings. Now metal roofing is appearing on homes all around neighborhoods. There are few types of metal roofing, but there is a distinct type called standing seam metal roofing. A standing seam roof is a metal roof where the seams position above the flat, steady surface. It appears contrasting to the rigid metal roofs seen on barns and industrial buildings. Standing seam roofing is amongst the most permanent and maintenance-free type of metal roofing. Standing Seam is becoming more prominent with homeowners because of the several advantages such as durability, energy efficiency, and high seams, fewer seams, and color choices.

Attention to placement of commonly used supplies can reduce the risk for falling while reaching.

Once the Triple threat is properly placed in the retracted state and ready to be installed, lock the wheels of both the Main Stand and the Roll Out Stand to secure the device (figure 22).

Case II: The beam was turned around in such way that the shortest side of the cross section is on the support. The steps described in Case I was repeated and data was recorded.

Depth of water: The amount of water will be changed by 1 cm for every data point. (There are 9) This will be measured in height in order to get the most accurate