Mock Circulation

Resting heart contractions were recorded for thirty seconds until the heart rate was less than 60 beats per minute. A stimulator electrode to be used was set to the following states: Amplitude of 4.00 Volts, a stimulus delay of 50ms, stimulus duration of 10ms, a frequency of 1.0Hz, and a pulse number of 30. The electrode was then placed in direct contact with the heart for 30 seconds at which time the data was observed and recorded.

B. Part B. PowerPhys Experiment 4 – Effect of Exercise on Cardiac Output (13 points total)

Table 2. This table shows the recording of the amplitude, period, and BPMs for the ventricular contractions before and the effects of the Warm Ringer’s after.

Once the patient was correctly hooked up to the EKG the BIOPAC Student Lab Program was started. Lesson five is the one we used for this experiment and once it had been chosen we label it and started the experiment. There were four conditions we needed to measure; the first being lying down. The subject was lying down relaxing on the cot. We clicked record and let it run for 20 seconds. The data resembled the chart below. If it did not we would have had to repeat the steps until it did.

The purpose of arterial pressure and the pulse lab is to determine the effect of posture and exercise on systolic and diastolic pressure and the heart rate. And also in order to find the differences in the reading taken under these condition compares to the baseline reading. The Sphygmomanometer and stethoscope are used to measure the systolic and diastolic blood pressure, counting the beat on the radial artery will give the reading for pulse rate and by using the lab scribe software and IWX214, the blood pressure will be measured. In the heart, the aorta and the carotid arteries have baroreceptors and the chemoreceptors that identify the changes in arterial pressure and the changes in

The pulse is an indication of an individual’s heart rate. When checking for a pulse in the primary survey, begin with palpating the patient’s radial or carotid artery (Basic Patient Care 2012, p. 50). This may reveal a normal (60-100 beats/min), tachycardia (<100 beats/min), bradycardia (> 60 beats/min) or asystole heart rate. Additionally, the capillary refill may also provide details about a patient’s cardiovascular status. This is performed by applying pressure to the nail bed and calculating the time it to takes to refill to a normal color, which should take no more then a few seconds otherwise suggesting capillary closure (Mick J Sanders, 2012, p. 1400). An additional accessory to Circulation is Hemorrhages, these involve more through examinations of the pulse, blood pressure and warmth of peripheries of patients. Additionally, you must thoroughly look for indication of bleeding, specifically in the areas around the chest, abdomen and externally seen by the eye.

The S-A node signal is delayed by the atrioventricular node to allow the full contraction of the atria that allows the ventricles to reach their maximum volume. A sweeping right to left wave of ventricular contraction then pumps blood into the pulmonary and systemic circulatory systems. The semilunar valves that separate the right ventricle from the pulmonary artery and the left ventricle from the aorta open shortly after the ventricles begin to contract. The opening of the semilunar valves ends a brief period of isometric (constant volume) ventricular contraction and initiates a period of rapid ventricular ejection.

In the first part of the practical, we will dissect the heart of a sheep and observe its anatomical structure. We will also examine the structure of blood vessels at a microscopic level. My hypothesis is that by examining the anatomy of the cardiovascular system, we will be able to detect differences in both vessels and the chambers of the heart. In the second part of the practical we will examine the electrical activity of the heart. In doing so my aim will be to produce a familiar ECG reading containing a P wave, QRS complex and T wave. Futhermore, we will take blood pressure readings by listening to the korotkoff sounds of the heart using a sphygmomanometer and stethoscope. We hypothesis that the higher the arm position is from the ground, the smaller the blood pressure reading will

Heart Contractions and Blood Flow – An animation of the showing how the heart pumps.

reports the amount of force exerted by the blood into the arteries during ventricular contraction.

The purpose of these lab exercises is to understand the function and importance of an electrocardiogram. This lab will demonstrate how stress levels or different elevations can affect human heart rate. Furthermore, the equipment used in the experiment will show the functions in the right and left arm; as well as, in the right and left ankles. Finally, the lab will serve a purpose as a way to know how to read an electrocardiogram and calculate the heart rate.

Carry out an experiment to measure the heart rate and ventilation rate before, during and after moderate exercise.

(This experiment is aimed to use 10 Artemia, however, 7 to 13 Artemias are able to achieve the goal in this experiment.). Then seal the cuvette under water and make sure no air bubble is inside the cuvette. After that, put the cuvette into the temperature controlled water bath for ten minutes. After 10 minutes, take the cuvette to the oxygen meter to measure the oxygen concentration by holding the end of the end of the fibre-optic cable squarely on to the senor spot from the outside of the cuvette until the concentration has been shown on screen and record it down. Then return the Artemia to the same incubation bath and repeat this procedure every 5 minutes and measure it for 4 to 5 times. After the process above, we have to find out the total length of the Artemias in the cuvette. To find the total length of the Artemia, use the pipette to move the Artemia out of the cuvette and settle them into a watch glass and measure the length of the Artemias by ruler. At last but not least, put those high energy intake Artemia back into the sink and repeat the experiment instead of those low intake Artemia. On the other hand, to find the difference of activity of the high and low energy intake Artemia, those Artemia will be tracked by the software named, the Tracker and the Tracker are able to determine the velocity of the Artemia under different treatment for 5 replicates.

A negative relationship between the RBC concentration and LIM voltage is observed, when more blood is added to the isotonic saline solution, blood concentration increased, therefore the protein concentration become greater in the solution. The greater concentration of protein in the solution the more light is scattered. The intensity of the scattered light increased, resulted in a lower voltage was detected by the LIM device. Thus resulted in a trend of decreasing voltage with an increasing blood concentration. Figure 1 indicates that the output of the LIM is linear. RBCs were added in an isotonic solution, which means there will be no net water movement between the saline solution and the RBCs. When the blood concentration increased the voltage is decreased, therefore, an inversely proportional relationship is observed between the two variables (y = -0.1069x + 0.0885). Hence, the concentration of blood in the unknown solution is 12.05 µLml-1.

The objectives of this experiment are to demonstrate the characteristics of some various commonly used methods of measuring fluid flow rates and to identify the head losses associated with each flow measuring apparatus. The devices to measure the flow rate are determined by using a venturi meter, an orifice plate meter and a rotameter. Head losses associated with each meter are