Module Code And Title Assignment

1.What are conversion factors? Why were conversion factors developed? How do they impact on which bond is cheapest to deliver? Under what conditions would there be no cheapest to deliver? Explain in detail.

M2 part - Considering your work for Task 2 e or f, indicate how some of the fundamental principles of HCI have been applied and how the specific need has been met.

For this task, check before you hand in your work that you have met the criteria in the grading grid.

Figure.12 THD of input current at full load showing (a) third and (b) fifth harmonics.

Define five (5) major tasks, each with one to two (1-2) subtasks. Also write a brief description for each task.

4. Tasks should be broken down so goals can be achieved in a reasonable timeframe.

In this progress report, I will present the completed work of Task 1. I will show the progress of Tasks 2-3.

For assignment 5, I also started with choosing which task I am going to do. At first, I wanted to write 5A because

Its energy can be generated for both low and high voltage purposes, ranging from 12V for domestic uses to up to 240V for industrial applications. This quality empowers it to significantly decrease waste in electric power.

gate-oxide capacitance, W n and W p are the dimensions of transistors, VDD is the power supply

There are two types leakage currents reverse bias diode leakage and sub-threshold leakage. The magnitude of these currents is affected by the technology.

A brief introduction to link, simple steps on how it works with a screenshot that displays the main process. Remember to mention its major cons in the end. The four converters are as follows:

Symbol VCC VIH VIL IOH IOH IOL TA Supply Voltage HIGH Level Input Voltage LOW Level Input Voltage HIGH Level Output Current a − g @ 15V = VOH (Note 7) HIGH Level Output Current BI /RBO LOW Level Output Current Free Air Operating Temperature 0 Parameter Min 4.75 2 0.8

Key words – i) Effect of series resistance ii) i-v characterstics iii) Power region iv) Power Plane Analysis v)Maximum Power Point Tracking.

This project has been carried out at the department of the electrical engineering at S.V.I.T. Vasad. It has been great opportunity to work with this project and get knowledge about this area of the power electronics.