OXIDATION-REDUCTION REACTION OF MAGNESIUM

2. Obtained a 2-3 cm strip of magnesium metal ribbon and coiled it loosely into a small ball. Added the magnesium metal to the acid in the test tube.

During the immersion of the magnesium metal in the hydrochloric acid solution, white bubbles could be seen escaping the surface of the metal as gas was produced during the reaction. Depending on the temperature of the hydrochloric acid and the overall molar concentration, the rate of reaction differed but the same signs were shown. During the reaction between the magnesium metal and higher concentrations of hydrochloric acid, it was observed that the test tube grew quite warm to the touch. As the immersed magnesium strip sank down, it appeared coated in a layer of white bubbles that fizzed like a carbonated drink. In the lower concentrations of hydrochloric acid, the strip spent some time floating at the surface of the solution in the test tube, later sinking down to the bottom as the

3. The third source of error is not knowing for how long to exactly heat the magnesium until it no longer ignites and forms into a white powder of magnesium oxide. In the procedure, it is stated for how long to heat the magnesium, but as the lab went on, it is realized that the magnesium had to be heated for a longer time. This could mean that the magnesium could have been not heated long enough or too little for it to be fully converted into the magnesium oxide product effecting the final results of the lab by having smaller

    In this lab, a calorimeter was used to find the enthalpy of reaction for two reactions, the first was between magnesium and 1 molar hydrochloric acid, and the second was between magnesium oxide and 1 molar hydrochloric acid. After the enthalpy for both of these were found, Hess’ law was used to find the molar enthalpy of combustion of magnesium, using the enthalpies for the two previous reactions and the enthalpy of formation for water. The enthalpy of reaction for the magnesium + hydrochloric acid reaction was found to be -812.76 kJ. The enthalpy of reaction for the magnesium oxide + hydrochloric acid reaction was found to be -111.06 kJ. These two enthalpies and the enthalpy of formation for water were manipulated and added together using Hess’s law to get the molar enthalpy of combustion of magnesium. It was found that the molar enthalpy of combustion of magnesium was -987.5 kJ/mol. The accepted enthalpy was -601.6 kJ/mol, which means that there is a percent difference of 64%. This percent difference is very high which indicates that this type of experiment is very inefficient for finding the molar enthalpy of combustion of magnesium. Most likely, a there are many errors in this simple calorimeter experiment that make it inefficient for finding the molar enthalpy of combustion of magnesium.

I could use a gas syringe to collect the gas that will evolve from my

About 80 mL of HCl was obtained and mixed with phenolphthalein. Using a LabQuest unit and Gas Pressure Sensor kit, the HCl mixture was added to the flask with the magnesium ribbon and allowed to react. When reaction was complete, the change of temperature and gas was recorded. This procedure was repeated for different masses of magnesium ribbon (masses found on page 89 of the lab manual). After the completed procedure, moles of H₂ produced in each trial were calculated. (The actual procedure can be found on pages 87-89 of the lab manual)

| After hydrochloric acid is added the mg reacts violently with bubbles and heat. Left over is a clear residue.

The solubility of Mg(OH)2 (Ksp = 8.9 10-12) in 1.0 L of a solution buffered (with large capacity) at pH 9.58 is:

Experiment 2 focused on finding the enthalpy of solution of magnesium chloride. Testing the enthalpy of solution started with measuring out 10 mL of deionized water in a graduated cylinder for three separate trials, each trial having a different mass of magnesium chloride. The water was then poured into a well of a Styrofoam calorimeter then the initial temperature of water was taken using a temperature probe and the LoggerPro programming. A measured amount of magnesium chloride was placed in the same well as the water in the calorimeter,

In the experiment the magnesium reacts with the hydrochloric acid to create magnesium chloride and hydrogen. The balanced formula for this is:

The initial magnesium had a mass of 0.06 g while the final compound had a mass of 0.08 g. Magnesium oxide had been formed, and no magnesium should have been lost over the process due to magnesium being unable to form gases or liquids with any of the elements it had been exposed to.

To begin Lab 7 of Chem 115, a clean and dry porcelain crucible and its cover were obtained. Next, an iron ring was attached to a ring stand. A clay triangle was placed on top to the ring and a Bunsen burner was placed under the ring. Following the setup for the experiment, the crucible and its cover were placed on the clay triangle and were heated for about five minutes. After, the burner was turned off and the crucible and cover were left to cool to room temperature. Once the crucible and its cover had reached room temperature, tongs were used to move them to a wire gauze. Using the wire guaze, the crucible and its cover were transported to an analytical scale to weigh and record the mass of it. Next, a strip of magnesium was obtained and

The goal of this experiment was to determine the empirical formula for a hydrate of magnesium sulfate and water. The technique that was used was measure the mass of the hydrate and then apply heat to evaporate the water. Then determine the mass of water that was in the hydrate and the mass of the remaining magnesium sulfate. The equation for the hydrate is determined by calculating the mole to mole ratio of the water and the anhydrous. The resulting formula will be formated as: MgSO4*_H2O

It is expected that the concentration of hydrochloric acid will increase the rate of the reaction between magnesium ribbon and hydrochloric acid. By increasing the concentration of

Experiment to investigate factors affecting the rate of reaction between magnesium ribbon and hydrochloric acid