Organic Chemistry Laboratory

Use a glass beaker to pour an adequate amount of the liquid substance and use the pipette from the glass beaker.

Next, I poured distilled water just below the 250ml mark on the neck of the volumetric flask.

In the lab we filled the first beaker up with water. Then we took a pipet (filled with the liquid) and dropped water droplets onto the

1. Fill the graduated cylinder nearly to the top with water, with a tall glass tube open at both ends (the water level with act as the closed end).

Lycopene and β-carotene are separated using thin layer chromatography (TLC). A mixture of tomato paste containing dissolved lycopene and β-carotene is first spotted on a TLC plate. The technique uses a stationary phase layer, on which the substances stick, and a mobile phase, which migrates upwards the plate and carries the components of the mixture with itself (Chemguide). Depending on their respective polarity, lycopene and β-carotene stick more or less to the stationary phase and so they migrate up the TLC plate at different rates (Chemguide). Thus, as the chromatography is completed, the two components will appear as distinct dots at different heights on the plate. Lycopene has a bright orange color, whereas β-carotene is light yellow.

16) Heat some of the hexane to boiling and place the solid to be crystallized into an Erlenmeyer flask.

Working in the hood or a designated work area, add about 1 mL of ethyl alcohol to a clean evaporating dish. Place the evaporating dish on a heat- resistant pad.

In the beginning of this experiment, our TA added water, salt, and 75/25 hexane/acetone to spinach leaves to a blender and blended the mixture to assume equal amounts for each group and to avoid erros if each student had to do the blending. The addition of the water to the mixture allowed the it to separate into a distinct organic layer after being run in a centrifuge, which was available to be collected at the top of the centrifuge. Salt reduces solubility, which will force the organic parts of the mixture (the desired pigments for example) to separate into the organic layer at the top. Lastly, 75/25 hexane/acetone is added because this is a moderately polar solvent and will useful for both the non-polar and polar pigments present within the spinach leaves. A mixed solution of hexanes and acetone must be used because acetone is very polar, while hexane in very non-polar, and the spinach leaves contain both non-polar and polar pigments in them that are important in the extraction and for further analysis. The mixture was placed in the centrifuge so the solids in the mixture (mostly cellulose) could be separated from the liquids into separate distinct layers for further extraction and testing. In the tube, the organic substances separated into the top layer, whereas the water layer remains at the bottom of the tube below the solid layer made up of mainly cellulose.

the stopcock to release the pressure. Close the stopcock, shake the funnel several times, and again release the pressure through the stopcock (see Technique 12, Section

XII. Take the 250 ml beaker to your lab bench. Set up a gravity filtration with a plastic funnel, folded wet filter paper, and an Erlenmeyer flask. Pour the content in the 250 ml beaker slowly through the filter paper. Wash the filter paper with deionized water. Dispose of the filtrate in the proper labeled waste container.

During the separation of the pigments by chromatography paper, chlorophyll b traveled the shortest distance, chlorophyll a went above it, and the highest went beta carotene. This

Begin by inserting a cheesecloth into a syringe and pressing the cheesecloth to the very bottom of the column.

Carrots and pumpkins are two examples of carotene's visible orange pigment, caused by double bonding in the hydrocarbon

After wearing the gloves we obtained a chromatography vial from professor and label it with my and my peer initials. We dried up the chromatography vial in fume hood and added 1 ml of chromatography solvent to the vial. Then we took a chromatography strip and measure it 1.5 cm with ruler from one end of the strip and drew a line with pencil we cut two small pieces below the pencil line to form a pointed end. We applied spinach on the strip using quarter to rub the spinach leaf on the line that we drew on the strip and put it into the chromatography vial and placed that in fume hood. We observed as the solvent was moving up the chromatography strip by capillary action. When the solvent was reached approximately 1 cm from the top of the strip then we removed the cap from the vial. We took out the strip from the vial using forceps and marked up the location of the solvent front because it evaporates quickly. We measure out the distance as well as the pigment in order to find out the rf value. Moreover we compared rf values to the one in reference list in order to identify the

For lab 12, it is hypothesized that chlorophylls a and b are present in a plant leaf and contribute to the starch production in photosynthesis. Also, products of photosynthesis will be present in leaf tissue exposed to red and blue light wavelengths for several days, but a decreased presence in leaf tissue exposed to green and black light wavelengths. In lab 13, it is expected that since chlorophylls a and b are more polar and smaller molecules than the anthyocyanins and carotenoids, they will travel higher up the chromatography paper than the other pigments.