Osmosis Lab Report

Purpose: The purpose of this lab is to familiarize you with osmosis and, specifically, what happens to cells when they are exposed to solutions of differing tonicities.

The Osmosis and Diffusion lab was conducted to provide us with information on how built up mucus affects those conflicted by the recessive genetic disease, Cystic Fibrosis., due to a mutation to the membrane regulating chloride (Cl-). This mutation prevents the Cl- from leaving the cell causing the amount of sodium (Na+) in epithelial cells, which results in extreme mucus on the lungs and airways causing this disease to be fatal if not treated but treatment does not equate to a long lifetime. During the lab we took the data from three parts: Diffusion, Osmosis in an Elodea Cell, and finally the Role of Osmosis in Cystic Fibrosis. During Part 1 we looked at diffusion across a semipermeable membrane for starch and glucose, which resulted in both having a negative solution when placed in a semipermeable membrane. Then we looked at osmosis in the Elodea Cell to watch for the occurrence of Plasmolysis, when a cell’s plasma membrane pulls away from the cell, and how a plant cell is affected by both hypertonic and hypotonic solutions. Finally, we observed the role of Osmosis in Cystic Fibrosis using dialysis bags to represent a normal cell and a Cystic Fibrosis cell with the normal containing 1% NaCl while the Cystic Fibrosis bag contained 10% NaCl. After we ran the experiment, we looked at the Percent Change in Mass and compared them after 30 minutes. We found that Cystic Fibrosis cells didn’t change mass as much as the normal cell ending with a change in mass over -1%. The

Dialysis tubing is a membrane made of regenerated cellulose fibers formed into a flat tube. If two solutions containing dissolved substances of different molecular weights are separated by this membrane, some substances may readily pass through the pores of the membrane, but others may be excluded.

The dialysis tubing will be clamped at one end in order to fill it and then clamped at the other end to seal the filled bag. If the bag is not soft and floppy, the experiment will not work. Blot a bag with a paper towel to absorb the moisture and weigh it, if this blotting process is not done it could interfere with the weight readings creating inaccurate information. After the bags of the solutions are prepared, they will be placed into five different beakers with different solutions. Beakers 1-4 will be filled with tap water and the fifth beaker is filled with 40% sucrose and water. Fill each beaker with just enough water or solution so that the bag is covered and place the bags in the beakers simultaneously and record each time. Every 10 min the bags are to be taken out, blotted, and weighed again before returning them back into their respective beaker for another 10 min. The process is repeated until you have reached 90 min. The weights should be recorded in grams (g).

There are 3 potential states that the cell could be in depending on the type of solution:

Using the graduated cylinder, measure 20mLs of the stock sucrose solution and 180mL of water to create a 3% sucrose solution and place it into the 250mL beaker (beaker #2). Place bags #1‐3 (red, blue, yellow) into beaker 2 and bag #4 (green) into beaker 1. Allow the bags to sit for one hour. After allowing the bags to sit for one hour, remove them from the beakers carefully open the bags, noting that often times the tops may need to be cut as they tend to dry out. Measure the solution volumes of each dialysis bag using the empty 250 ml beaker.

The hypothesis states that if the solution is hypotonic the results will decrease, if the solution is hypertonic the results will increase and if the solution is isotonic the solution will vary and or remain constant. In order to test the predictions of the hypotonic, hypertonic, and isotonic hypothesis for the solution  made during the study,  four samples of sucrose were taken and placed into two different beakers each containing a different concentration. Then dialysis tubing A was placed into beaker 1 with B, C, and D placed into beaker 2 for 45 minutes and weighted at 15 minute intervals. My finding in the study was that each of the four samples changed from their initial weight and for the most part accurately proved the hypothesis.

There were several steps completed to prepare for the experiment. Three dialysis tubes were filled with approximately the same volume of distilled water and then were tied shut. The initial mass (in grams) of the tubes was taken using a triple beam scale. I then filled three 500 mL beakers with 400 mL of water each and dissolved different masses of solute (table sugar) in each beaker in order to make 5%, 10%, and 20% solutions. The beakers were labeled accordingly, and then 20 g, 40 g, and 80 g (respectively) of table sugar was weighed out using a digital scale and placed into the corresponding beakers. The sugar was stirred in using a stirring rod until all of the solute was completely dissolved.

Osmosis is defined as the tendency of water to flow through a semipermeable membrane to the side with a lower solute concentration. Water potential can be explained by solutes in a solution. The more positive a number is more likely it will lose water. Therefore should water potential be negative the cell the less likely it will lose water. In using potatoes the effects of the molarity of sucrose on the turgidity of plant cells. According to Clemson University, the average molarity of a White potato is between .24 M and .31 M when submerged in a sorbitol solution. This experiment was conducted with the purpose of explaining the relationship found between the mass in plants when put into varying concentrations of sucrose solutions. Should the potatoes be placed in a solution that contains 0.2M or .4M of sucrose solution it will be hypotonic and gain mass or if placed in .6M< it will be hypertonic and lose mass instead. Controlled Variables in this lab were: Composition of plastic cups, Brand of Russet Potatoes, Brand of Sweet Potatoes and the Temperature of the room. For independent variable that caused the results recorded it was the different Sucrose concentrations (0.0M, 0.2M, 0.4M, 0.6M, 0.8M, 1M). The dependent variable was the percentage change from the initial weighs to the final. The cup with .4 molarity was the closest to an isotonic solution and was used as the control group for the lab. Water potential is the free energy per mole of water. It is

Osmosis is a special type of diffusion where water molecules move down a concentration gradient across a cell membrane. The solute (dissolved substance) concentration affects the rate of osmosis causing it either to speed the process up or slow it down. Based on this, how does different concentrations of sucrose affect the rate of osmosis? If sucrose concentration increases in the selectivity-permeable baggies, then the rate of osmosis will increase.

Cells are always in motion, energy of motion known as kinetic energy. This kinetic energy causes the membranes in motion to bump into each other, causing the membranes to move in another direction – a direction from a higher concentration of the solution to a lower one. Membranes moving around leads to diffusion and osmosis. Diffusion is the random movement of molecules from an area of higher concentration to an area of lower concentration, until they are equally distributed (Mader & Windelspecht, 2012, p. 50). Cells have a plasma membrane that separates the internal cell from the exterior environment. The plasma membrane is selectively permeable which allows certain solvents to pass through

Osmosis is a special type of diffusion. It is the diffusion of water across a semipermeable membrane which is a membrane that is freely permeable to water but is not freely permeable to solutes, the water moves from a dilute solution to a more concentrated solution (Karp, 2010). Both diffusion and osmosis are passive transport, energy is not used in the transport. In osmosis water moves across a membrane toward the solution of greater concentration, because the concentration of water is lower there (Martini and Bartholomew., 2007).

Hand out from the Natural Science Establishment, six dialysis tubing, six plastic cups, distilled water, 0.2 M, 0.4 M, 0.6 M, 0.8 M, and 1.0 M samples of a sucrose solution, paper towels, and a scale.

First I gather all my materials needed for the experiment (see materials list). Second I peel and slice potatoes weigh each potato in grams. Get these slices to weigh the same in mass because if they vary to much in mass that could affect the results of the experiment. Third I place each potato in its own beaker. Fourth once the potatoes are placed in beakers I make sure to place enough solution to fully cover the potato. Each beaker should have a different amount of

Osmosis is when water passes through a cell membrane, it is also form of a diffusion, which is a form of passive transport. Osmosis will continue to until an equilibrium is reached which is when the solutions are isotonic. This means that the solution has the same amount of solute on both sides. If the solution is hypertonic, it has more solute in the solution. In this situation water will move towards it. if the solution is hypotonic, it has less solute in the solution. Whereas in this situation, water will move out of the solution.