Persuasive Essay On A Flat Tire

Then put the socket wrench into the square bolt. You will know the wrench is properly on when you have a snug feel or tight fit. Once you find the correct wrench stop, and go locate your oil pan, and place the oil pan directly under the motor under the bolt. Start unloosing the bolt, as you do this make sure the oil pan is directly under the oil that’s draining out the car.

tightened, it's time to add the new oil. Unscrew the oil cap on top of the engine and with the

Once you have the car in the air you will want to put some jack stands under each side and lower the car down on these, this will prevent the car from falling on you if the jack where to collapse, since jacks are only designed to pick the car up, not support it all day. Once the car is safely on the jack stands, you are ready to change the oil.

Step 3: Place the oil drain pan under the plug and loosen the plug with a socket wrench. Remember: turn counterclockwise to remove bolts.

The following steps are the safest way to change a flat tire. If you received a flat tire while driving down the road; first thing to do is to get away from oncoming traffic; at that time, find a place that is well lit, such as a parking lot. Keep in mind the farther you drive on a flat tire, the more damage you will incur to the tire and wheel. Secondly, set the parking brake so that the car does not roll away while the car is off the ground. Then, you have to locate your spare tire, which will replace the flat tire; that is usually in a compartment inside the trunk. The spare tire is secured in place by a bolt or a bracket that unscrews easily. In addition to the spare tire, you will need a jack to raise the

When changing a tire, there is always a catch. So one must know that things won’t go according to plan or some kind of inconveniences will happen. So it is the coldest day of the year and my hands are freezing cold and on top of that I have to grab hold of a tire iron. So I’m driving and a tire pops, first one has to safely come to a complete stop and park the car on the side of the road far away from the road as possible.

woman in the car got out and went to the tyre to see if she could see

Every state, other than New Hampshire, requires drivers to carry their state’s minimum requirements to legally drive a vehicle. Still, there are those who refuse to follow the letter of the law. In fact, in 2012 the Insurance Research Council found that one in eight drivers on the road don’t have insurance at all, totalling 30 million uninsured motorists nationwide.

After letting the car sit for a minute or two, the oil should be fully drained. Reinstall the oil drain plug. Use a torque wrench set to 30 ft./lbs. if you have one. Otherwise, tighten it until snug. Then install the new oil filter. First, lubricate the inner threads, then lubricate the rubber seal around the edge of the filter. Next, fill the filter with fresh oil. Then tighten the filter by hand until snug.

The biggest question now is "How do I install my Roll pans to my car?" I'm going to explain a step by step procedure on how to install the Roll pans. The process is easy, but you should put some time aside to do the job so you aren't rushing to complete it. Firstly, You need to open the tailgate of your truck and release the straps that hold it up. Bring the tailgate toward you until you can lift it up and off the truck. The pins on the hinge of the tailgate have a flat side that lines up with the flat side of the socket the pin is in. This is when you remove the license plate with a screwdriver. Release the bolts in the well of the license plate. These bolts are driven into the bumper. Now go underneath the truck and pull out the taillight wiring from the connections, remove the nuts holding

Step 2: Then place your right hand on the right front hang and pull it down so the left side end hang piece is just below your left breast than release both hands.

6.     Check in after 10 minutes, if you don?t see anymore oil dripping out, screw the nut back in tightly and also screw on the new oil filter. Using a little bit of motor oil on the rubber gasket will ensure a tight fit.

If driving before tire deflated move your vehicle all the way to the right of the road, to remove yourself from any dangers. If not please skip to step two.

First, you will need to prepare yourself. Before you attempt to change your tire, secure your vehicle’s position. Note: depending on your situation you may have, either (a) just got a flat tire while on the road, or (b) you were about to use your car when you discovered your flat tire. Either way, the procedure will moderately be the same. In order to secure your vehicle’s position, you need to find a flat open area, because it is extremely unsafe to jack up a vehicle on an incline/slope. If you were on the road (a) turn on your hazard lights, then drive slowly and carefully until you find a safe spot where you can pull over. Tip: a nearby gas station would be a good place to consider. If your car was previously parked (b) for

A flat tire is really inconvenient. Those who have used a car or even a vehicle may have at one time or another experienced this ordeal. Sometimes when somebody is headed to a very important occasion and is very descent he or she may experience a flat tire while on his or her way to the occasion. Motorists in the last century used to change tires by the road side more often unlike now. There are a few tips that one can use to mitigate this situation.