Photosynthesis Lab Report

Have you ever really wondered how different variables can affect how plants go through photosynthesis? Well, in this experiment, the purpose was to see how various environmental conditions can affect the overall photosynthetic capacity of a specific plant. The factors, light, darkness, cold, and heat were applied to see how the different components would affect the photosynthesis on spinach plants. Each group was given a different factor to test. Out group was given the light factor. The hypothesis for this experiment is that when adding light as a factor, the light will affect the overall plant photosynthesis.

The purpose of this experiment is to determine the maximum absorbance of fast green, and the chlorophylls, also in the case of fast green create a concentration curve to determine an unknown substance. Each test will use the spectrophotometer.

Photosynthesis is the process in which plants consumed inorganic materials like solar light, carbon dioxide and water and converted it to an organic molecule like sugar and an inorganic gas like oxygen. Light is one of the major elements influencing the rate of photosynthesis; direct light concentration affects the noncyclic pathway (light

The rate of photosynthesis is affected by environmental factors like light intensity, light wavelength, and temperature. This experiment will test the

15) Obtain the boiled chloroplast suspension, mix, and transfer 3 drops to cuvette 4. Immediately cover and mix cuvette 4. Insert it into the spectrophotometer's sample holder, read the percentage transmittance, and record it in Table 4.4. Replace cuvette 4 into the incubation test tube rack. Take and record additional readings at 5, 10, and 15 minutes. Mix the cuvette's contents just prior to each readings. Remember to use cuvtte 1 occasionally to check and adjust the spectrophotometer to 100% transmittance.

Using the yellow tube, which included everything but starch, as the blank, each group zeroed their spectrophotometer. This was done so that any absorbance observed depends only on the amount of starch present, not on any other reagents (buffer, IKI). To zero the spectrophotometer, the wavelength was first set at 580nm, using knob 3 (45). Next, the groups made sure that the light next to “transmittance” was lit, and the chamber to be tightly closed. Having the chamber empty & closed tightly provides reference for the darkest condition possible. Using knob 1, the transmittance was turned until it read 0.0 (45). Before the groups used their blank test tube to zero the spectrophotometer, each needed to wipe the tube with kimwipes to ensure a clean reading. Turning knob 2, each group was then instructed to zero the absorbance, 0.000. Upon removing the blank, each trial was inserted into the chamber (46). The

This lab was conducted to explore the light energy, pigments and the rate of photosynthesis in magnolia leaves. In experiment one a magnolia leaf was used to see the separation of primary and accessory plant pigments using a process called paper chromatography. The importance of this process was to discover which pigment had the highest band along a piece of filter paper and identify various plant pigments in a magnolia leaf such as xanthophyll, chlorophyll a, chlorophyll b, and carotenoids that aid magnolia leaves during photosynthesis. Based on the conducted experiment, it can be concluded that chlorophyll a was the pigment that showed the highest band on the piece filter paper which means that chlorophyll a is the primary pigment in photosynthesis

3. The spectrophotometer was set at 420nm. Distilled water was also used as the ‘blank’.

Photosynthesis occurs in the palisade mesophyll of plant leaves. During photosynthesis, carbon dioxide is broken up into 6 carbon for the sugar molecule and 12 oxygen. In this lab, I determined the rate of photosynthesis in spinach

Incorporation of assay controls included setting up a spectrophotomer and running the chart recorder with a full-scale deflection before the start of the assay. The set recorder had a corresponding value of 1 for the change in the absorbance. Therefore, prior testing was done to observe whether a change occurred in the readings. This helped to indicate that the results were valid, as they could have been affected by a fault during the setting up of the spectrophotometer. On the other hand this was considered as one of the controls for the experiment. Nevertheless, a new cuvette had to be used for each assay.

Photosynthesis is essential to all living organism such as animals and plants. Photosynthesis is a process used by plants and other autotrophs to capture light energy and use it to power chemical reaction that converts carbon dioxide and water into oxygen, carbohydrates and water. (Textbook: Principles of Biology). The reactants and the products of photosynthesis are:

For lab 12, it is hypothesized that chlorophylls a and b are present in a plant leaf and contribute to the starch production in photosynthesis. Also, products of photosynthesis will be present in leaf tissue exposed to red and blue light wavelengths for several days, but a decreased presence in leaf tissue exposed to green and black light wavelengths. In lab 13, it is expected that since chlorophylls a and b are more polar and smaller molecules than the anthyocyanins and carotenoids, they will travel higher up the chromatography paper than the other pigments.

8) Steps 1 - 8 were repeated using the wavelengths of 360 nm to 900

concentration, record the absorbance readings at a fixed wavelength, and plot the absorbance vs. concentration data. The wavelength of 520 nm was selected for experiment Part

     Photosynthesis has a two-stage performance before plants produce the two products they are known to produce. These stages are Photosystem I and II. Photosystem II is dependant on light reactions for energy which causes the electrons to be react and be transferred to Photosystem II. The electrons are transported through the Photosystem II electron transport system, however some energy is used to drive ATP synthesis. Meanwhile, light is being absorbed by the Photosystem I, which causes the electrons to react. This process sends the electrons to the Photosystem I transport system where some energy is released as electrons travel through the electron transport system and is captured as NADPH. When this process is completed oxygen is released from the plant and glucose has been