Physioex Exercise 2 Activity 4 Essay examples

2) Amplitude does not change with distance. . From the experiment, the action potential amplitude does NOT change as it propagates down the axon. (The change was small at 0.4, 0.2)

The more stimuli per second, the greater the force generated by the muscle due to a

Encyclopedia of Nursing & Allied Health. Bioelectricity: Transmission of nerve impulses to muscle. Retrieved on 26 June 2011 from http://www.enotes.com/nursing-encyclopedia/bioelectricity

3. Considering your answers to Questions 1 and 2, why did activity in Annie’s motor nerves produce a skeletal muscle response that fatigued during repetitive stimulation?

1. Calculate the temperature of the parcel at the following elevations as it rises up the wind-ward side of the mountain:

Smooth muscle contraction occurs when calcium is present in the smooth muscle cell and binds onto calmodulin to activate myosin light chain kinase (Wilson et al., 2002). Phosphorylation of myosin light chains result in myosin ATPase activity thus cross-bridge cycling occurs causing the muscle to contract (Horowitz et al., 1996). There are two known models of excitation and contraction in smooth muscle, electromechanical coupling (EMC) and pharmomechanical coupling

It compares three specific muscles in the human body that vary in muscle tissue type in terms of:

Next with a stimulation duration of 50us, the stimulus amplitude should be set to the maximal tolerable stimulus intensity. With stimulus frequency of 2Hz, observe and record the leg movement, increase it by 5Hz but should not exceed 50Hz. With the electrodes connected to the analogy output channel and ground of the DAQ board. With the corresponding LabVIEW program, the frequency and amplitude (voltage) of the stimulation supplied to the leg can be controlled. With this the “sweet spot” of the lowest amplitude and best frequency to cause evoked movement can be found and recorded. Now the stimulation frequency should be set to 10Hz and the duration of stimulation pulse to 5ms or less. The range if leg movement changes can be observed as amplitude changes. Electrical stimulation in increments of 0.01V should be delivered and the minimal voltage required to generate muscle twitch should be recorded. The pulse duration should then be increased by durations of 10ms and the minimum voltage should be recorded this should be repeated for a variety of pulse

Introduction: According to the “Human Physiology Laboratory Manual “,BIOL 282 ,page 31 , the reason of performing this experiment is to learn how the muscle contraction occurs based on the molecular level and what kind of factors are involved .As a matter of fact, skeletal muscles contain a lot of nuclei because of the cell fusion while being developed and are made of cylindrical cells that have myofibrils. The myofibrils contain sarcomeres and the

In this exercise, you examined the effect of increasing stimulus intensity on the nerve. What other stimulus parameter

As you increase the amplitude, more neurons reach their threshold and contribute to the increase in size of the compound action potential (CAP). Eventually, as the stimulus voltage is increased, a point will be reached when the waveform of the action potential stops changing. At this point all the fibers in the nerve able to respond to the stimulus are stimulated, which is the maximal response.

Review Sheet Results 1. Describe how increasing the stimulus frequency affected the force developed by the isolated whole skeletal muscle in this activity. How well did the results compare with your prediction? Your answer: When the stimulus frequency was at the lowest the force was at its lowest level out of all of the experiments. As the stimulus frequency was increased to 130, s/s the force increased slightly but fused tetanus developed at the higher frequency. When the stimulus frequency was increased to the amounts of 146-150 s/s, the force reached a plateau and maximal tetanic tension occurred, where no further increases in force occur from additional stimulus frequency. 2. Indicate what type of force was developed by the isolated skeletal muscle in this activity at the following stimulus frequencies: at 50 stimuli/sec, at 140 stimuli/sec, and above 146 stimuli/sec. Your answer: At 50- Unfused

As the voltage was increased from threshold to maximum voltage, there was a greater force in the muscle contraction. Once the maximum voltage (2500 mv) was reached, even if there was an increase in voltage, the force of the muscle contraction remained the same.

9. Strong involuntary muscle reactions to shocks can occur in a amperage ranges as low as __________________.

3. How can you explain the increase in force that you observe? the increase is how many volts went into the muscle.