Power Of Enzymes Lab Report

And finally into test tube 3, I pipetted 1.0 ml turnip extract and 4.0 ml of water. The contents of test tube 1 was poured into a spectrometer tube and labeled it “B” for blank. “B” tube was now inserted it into the spectrometer. An adjustment to the control knob was made to zero the absorbance reading on the spectrometer since one cannot continue the experiment if the spectrometer is not zeroed. A combination of two people and a stop watch was now needed to not only record the time of the reaction, but to mix the reagents in a precise and accurate manner. As my partner recorded the time, I quickly poured tube 3 into tube 2. I then poured tube 2 into the experiment spectrometer tube labeled “E” and inserted it into the spectrometer. A partner then recorded the absorbance reading for every 20 seconds for a total of 120 seconds. After the experiment, a brown color in the tube should be observed to indicate the reaction was carried out. Using sterile techniques, any excess liquid left was disposed

In the experiment we used Turnip, Hydrogen Peroxide, Distilled Water, and Guaiacol as my substances. On the first activity, Effect of Enzyme concentration of Reaction Rate for low enzyme concentration, we tested three concentrations of the turnip extract, and hydrogen peroxide. For the Turnip Extract I used 0.5 ml, 1.0 ml, and 2.0 ml. For hydrogen peroxide we used 0.1 ml, 0.2 ml, and 0.4 ml. We used a control to see the standard, and used a control for each enzyme concentration used. The control contains turnip extract and the color reagent, Guaiacol. We prepared my substrate tubes separately from the enzyme tubes. My substrate tube

Amylase experiment # 2 was done to see how the pH affected the efficacy of the enzyme. First we collected all of the materials that were necessary to make this experiment. We needed five clean test tubes, the following standard solutions, 1% Starch Solution pH 3,1% Starch Solution pH 5,1% Starch Solution pH 7,1% Starch Solution pH 9,1% Starch Solution pH 11

Of the many functions of proteins, catalysis is by far the most vital. When catalysis is not present, most reactions in the biological systems take place very slowly to produce at an adequate pace for metabolising organism. The catalysts that take this role are called enzymes. Enzymes are the most efficient catalysts; they can enhance rate of reaction by up to 1020 over uncatalysed reactions. (Campbell et al, 2012).

Students will be observing normal catalase reaction, the effect of temperature on enzyme activity, and the effect of pH on enzyme activity in this experiment. The enzymes will all around perform better when exposed in room temperature than when it is exposed to hot and cold temperatures. This is based on the fact that the higher the temperature, the better the enzymes will perform, but as the temperature reaches a certain high degree, the enzymes will start to denature, or lose their function.

Enzymes are biological catalysts that speed up chemical reactions, without being used up or changed. Catalase is a globular protein molecule that is found in all living cells. A globular protein is a protein with its molecules curled up into a 'ball' shape. All enzymes have an active site. This is where another molecule(s) can bind with the enzyme. This molecule is known as the substrate. When the substrate binds with the enzyme, a product is produced. Enzymes are specific to their substrate, because the shape of their active site will only fit the shape of their substrate. It is said that the substrate is complimentary to their substrate.

Enzymes are types of proteins that work as a substance to help speed up a chemical reaction (Madar & Windelspecht, 104). There are three factors that help enzyme activity increase in speed. The three factors that speed up the activity of enzymes are concentration, an increase in temperature, and a preferred pH environment. Whether or not the reaction continues to move forward is not up to the enzyme, instead the reaction is dependent on a reaction’s free energy. These enzymatic reactions have reactants referred to as substrates. Enzymes do much more than create substrates; enzymes actually work with the substrate in a reaction (Madar &Windelspecht, 106). For reactions in a cell it is

Enzymes are biological catalysts. They are made in livings things built up by amino acids to make protein. Enzymes are able to speed up reactions and can repeat reactions.

In the first part of the enzyme lab, we mixed a substrate and an indicator with an enzyme. There was also a neutral buffer in each of the chemical mixtures. The neutral buffer regulated the pH to around 7. We got a color palette and once we mixed each together, we observed and saw a change in the color of the substance. The darker and more brown the substance got, the more oxygen produced by the reaction. Our results showed that amount of oxygen produced increased about 10% a minute until it sort of equilibrated at 4 minutes and didn’t change to the fifth minute mark. If we were to change anything we did in the experiment, we would make our comparisons to the chart more precise. Overall we thought it

An enzyme is a substance produced by a living organism that acts as a catalyst to bring about a specific biochemical reaction. They are mainly made up of proteins and can tremendously speed up reactions. E. coli ( a bacterium) has about 1,000 different types of enzymes floating around in its cytoplasm at any given time. Enzymes can be used to join and even break up molecules as shown in the diagram below.

“Enzymes are proteins that have catalytic functions” [1], “that speed up or slow down reactions”[2], “indispensable to maintenance and activity of life”[1]. They are each very specific, and will only work when a particular substrate fits in their active site. An active site is “a region on the surface of an enzyme where the substrate binds, and where the reaction occurs”[2].

|Control-Glucose (mg/dL) |EDTA-Glucose (mg/dL) | |Mean= |250.5 |94 | |Sample size= |98 |98 | |t= 50.1

Organisms cannot depend solely on spontaneous reactions for the production of materials because they occur slowly and are not responsive to the organism's needs (Martineau, Dean, et al, Laboratory Manual, 43). In order to speed up the reaction process, cells use enzymes as biological catalysts. Enzymes are able to speed up the reaction through lowering activation energy. Additionally, enzymes facilitate reactions without being consumed (manual,43). Each enzyme acts on a specific molecule or set of molecules referred to as the enzyme's substrate and the results of this reaction are called products (manual 43). As a result, enzymes promote a reaction so that substrates are converted into products on a faster pace (manual 43). Most enzymes are proteins whose structure is determined by its sequence of its amino acids. Enzymes are designed to function the best under physiological conditions of PH and temperature. Any change of these variables that change the conformation of the enzyme will destroy or enhance enzyme activity(manual, 43).

Enzymes are very specific in nature, which helps them in reactions. When an enzyme recognizes its specific substrate, the

Enzymes are biologically active proteins that serve as catalysts; they have the ability to speed up chemical reactions. Without a catalyst many biochemical reactions will be carried out too slowly for the body to benefit. All sorts of enzymes occur naturally in our bodies, some help digest food. An enzyme such as amylase is present in saliva which breaks down starch into smaller maltose molecules. Without an enzyme holding the large molecule in position, this reaction will be extremely slow. Every reaction requires certain amount of energy to form. Enzymes lower the activation energy (amount energy required to be put into the reaction to begin). It does this by applying pressure to bonds that require s the molecule to break, or bring the molecules closer to bond. The molecules or chemicals the enzymes work on are called substrates, substrates then bind to the enzyme active site, once they bond to the active site, the enzyme will change shape to fit the substrate, and this is known as the induced fit model. All enzymes are specific to particular molecules or chemicals and are usually named after their substrate ‘ase’. For example lactase is an enzyme that breaks down lactose.