Procedure To Spill Three-Fourths Of Water

ii. Step 2: Place the funnel in the opening and pour in the new oil.

lab bench. Place a beaker from the drawer on the stir plate. Drag the bottle of NH3 to the 5 mL graduated cylinder (the smallest one) by the sink and fill the cylinder by dropping the bottle on the cylinder. Now drag the 5 mL graduated cylinder to the beaker on the stir plate and add the 5 mL of

Add RO water to the 25 ml volumetric flask up to the mark. Put stopper on the flask and shake it properly.

Fill the rest of the container almost to the top with the oil and let the mixture separate.

4.2: Wash hands = 1, Wet hands 2, Rub your hands together applying soap 3, Scrub between fingers and back of the hands 4, rinse of the soap 5, Dry thoroughly.

I mixed oil in the water, the oil then started to settle at the top of the water. (oil is not a soluble)

When you pour oil into the water the oil separates from the water as bubbles and floats to the top and looks like a film on top of the water.

Place 5 candy pieces of the same color into a small beaker. Pour enough acetic acid solution into each tube to just cover all of the candy pieces, around 5 mL.

11.Pour the mixture mixed with water over the filter paper so that the sand remains on top of the paper and the soluble salt water will go through into the beaker

Fill granulated cylinder with water by submerging and make sure no bubbles at the top.

Sprinkle the mix onto a metal plate and then make a depression in the middle.

We started off with 3 plastic clear cups of water, we poured 40 mL of water into each cup, the water the same temperature. We put the Felt was the first material that we put around the cup. We

3) Let the tip set for a minute, so that the liquid can saturate the internal

To make sure this is our only factor we will be testing all the solvents on the same material, a standard blank canvas. We will be painting 2 small streaks for each different formulation and then timing the drying time with the use of a stopwatch.

Next fill the bucket with the recommended ratio of water and soap. Using hot water will affect the cars wax so be sure to use cool water. Don't use more soap than the instructions say to use, because more soap removes more wax. If possible use less soap to help save your car.