Reflection on Taking Blood Pressure Essay example

The purpose of arterial pressure and the pulse lab is to determine the effect of posture and exercise on systolic and diastolic pressure and the heart rate. And also in order to find the differences in the reading taken under these condition compares to the baseline reading. The Sphygmomanometer and stethoscope are used to measure the systolic and diastolic blood pressure, counting the beat on the radial artery will give the reading for pulse rate and by using the lab scribe software and IWX214, the blood pressure will be measured. In the heart, the aorta and the carotid arteries have baroreceptors and the chemoreceptors that identify the changes in arterial pressure and the changes in

Hypertension is the medical term for high blood pressure. A normal blood pressure is 120/80. A blood pressure reading higher or equal to 140/90 is considered abnormally high. Elevated blood pressure means your heart is working harder than normal, putting both your heart and arteries under great strain. High blood pressure is serious business.

Advise patients to avoid wrist cuffs as they tend to give higher BP readings than arm BP cuffs due to the smaller radius of the arteries in the

To discover heart murmurs it is important to initiate an assessment of the cardiovascular system. Inspection of jugular veins for irregular pulsations should be noted. Observe for elevated (raised) pulsations in the jugular vein with patients head turned at an angle with a penlight and estimate jugular venous pressure. Palpate the carotid arteries by gently pressing for strength of pulse. Findings for palpation should be documented as absent, palpable, normal, or bounding. Auscultation should be performed on each carotid artery using the diaphragm and bell of

a. Deflate the BP cuff at a rate of 5 to 10 mm Hg per second.

Upon the disappearance of the Korotkoff sounds, carefully observe the manometer for an additional 10 by 20 mmgHg of deflation to confirm the absence of sounds is confirmed , release the remaining pressure rapidly and remove the cuff.

Hypertension is the term used to describe high blood pressure. Blood pressure is a measurement of the force against the walls of your arteries as your heart pumps blood through your body. Blood pressure readings are usually given as two numbers -- for example, 120 over 80 (written as 120/80 mmHg). One or both of these numbers can be too high. The top number is called the systolic blood pressure, which is the force of blood in the arteries as the heart beats, and the bottom number is called the diastolic blood pressure which is the force of blood in the arteries as the heart relaxes between beats. When you blood pressure is a normal it’s lower than 120/80 mmHg most of the time. High blood pressure (hypertension)

Clinic BP was measured via an automatic oscillometric Accutorr monitor. Each clinic BP assessment was completed in a quiet and climate controlled room, following AHA guidelines.

Blood pressures can be obtained by invasive or non-invasive means. When carrying out a skill such as blood pressure, the nurse needs not only to have the capability of reading the results on the electrical sphygmomanometer, they also need to have the understand of what the results mean and be able to decipher if the results are normal for that patient. Even though a range of what is deemed to be normal is given, a patient may have low blood pressure, which is slightly lower than the normal range, however consistency and adhering to and following that patient’s care plan will enable you to see that. Just as if the blood pressure reading is high.

The upper arm needed to be bare, with any sleeve comfortably rolled up. The blood pressure cuff was be wrapped snugly around the upper arm. The group member putting it on had to pay close attention to the labels on the cuff to ensure it was not inside out or twisted. The lower edge of the cuff was about 1 inch above the bend of the elbow. The cuff was inflated quickly to about 160mm Hg; next, the valve of the cuff was opened slightly, allowing the pressure to slowly fall. A standard stethoscope was used to determine blood pressure. The measurer then placed the bell of the stethoscope firmly on the brachial artery of the arm being measured. As the pressure falls, the reading when the sound of blood pulsing was first heard was recorded. This was the systolic pressure. As the air continued to be let out, the sounds disappeared. The point at which the sound disappeared is recorded. This was the diastolic pressure. Inflating the cuff too slowly or not high enough may cause a false reading. If the valve is loosened too much, blood pressure won’t be measurable. The procedure was done at least two more times for accuracy. These results were then averaged. To measure heart rate, the participant found their pulse on the carotid or radial artery using their index or middle finger. The pulse was counted for 15 seconds and then multiplied by 4 to get an accurate beats per minute estimate. This was also done twice and averaged.

According to the chart I am the same as other women in my age range. Even though my blood pressure was above what it should be my risk of heart disease was relatively low. The blood pressure part shocked me a little bit, I would never have thought that I have a higher blood pressure than I should. If I think logically about it, this makes sense because I am stressed and constantly worrying about school, which can lead to an increase in blood pressure, but I just never thought about it.

It is like trying to tell a story by using only a single photograph. Multiple photographs are needed to convey the message and therefore multiple blood pressure measurements are needed to get a true idea of what the average blood pressure is 15. Therefore, in order to make the diagnosis of hypertension, the following precautions have to be taken: 1) In a resting (sitting or lying position), undisturbed and relaxed; 2) He/she should not have recently exercised, had coffee or done anything else that could temporarily raise blood pressure; 3) At least 3 measurements should be taken and the average of these calculated; and 4) This should be repeated on 3 different occasions in order to confirm that the patient has a high blood pressure level 15. Doctors have developed other techniques to increase the value of the blood pressure measurement including fitting a cuff on a patient and sending them home for 24-hours to see what their blood pressure is like in their natural environments 3,16. This is important because some people have very high blood pressures when in the hospital environment or when in the company of a doctor and is referred to as the White-coat effect

Indubitably, in the modern world, people are faced with far lesser health problems than their not so distant ancestors. Thankfully to the rapid growth and development of the medical industry and the scientific progress, doctors these days have a particular capacity not only to cure diseases but to prevent them as well. Nevertheless, the health situation in the world is not so bright as it may seem due to the first impression. There is a number of woefully constant and permanent health problems, precisely hereditary, which are tormenting people until now. Amidst them is the issues of high blood pressure or hypertension, which has been widespread specifically in Australia.

According to the research, Hypertension is a high blood pressure, a situation in which the arteries have elevated blood pressure. When the heart beats, it will pump blood to the all organs in the body through the arteries. If the pressure is higher the heart has to pump more harder. There is a accurate step how to check the blood pressure. Health care professionals will measure blood pressure by enlarge a cuff with the air around patient 's arm and listen to the blood flow with a stethoscope as the cuff deflates. They will read the numbers based on when the patient 's heart beats, which is alias systolic pressure, but when the heart will be in rest between beats, which is also known as diastolic pressure. The adult normal level of blood pressure is 120/80, where 120 is the systolic and 80 is the diastolic. The blood pressure of 140/90 or above is considered to be high blood pressure or hypertension (Lewis, S., 2013).

The main function of the heart is to pump the pureblood into arteries with some force. Therefore, the force on arteries when blood is pumping by heart or when the heart is resting is known as blood pressure. The blood pressure is usually measured by taking the two numbers like 120/80, where 120 is known as the Systolic pressure and 80 is Diastolic. Therefore, for a normal healthy person, Systolic blood pressure must be between the ranges of 80 to 120. Anything above the 140 counts is high blood pressure and treated as hypertension condition. Similarly, Diastolic blood pressure number between ranges of 60 to 80 is treated as normal diastolic blood pressure and readings crossing 90 or higher is