Relationship Between Volume And Pressure

Procedure: I used a ruler, thermometer, and scale to take measurements. I used a graduated cylinder, short step pipet, scale, and ruler to determine volume and density. I used a volumetric flask, graduated pipet, pipet bulb, scale, and glass beaker to determine concentrations and densities of various dilutions.

1. Fill the graduated cylinder nearly to the top with water, with a tall glass tube open at both ends (the water level with act as the closed end).

Predict: If the added mass on the lid was 50 kg, a total mass of 60 kg would exert pressure on the gas inside the container. What would be the volume of the gas? __.42 ______________

The bronchial tubes increase in length and diameter during inhalation. Bronchial tubes decrease in length and diameter during exhalation. Poiseuille’s law can be applied to the lungs when the bronchial tubes become constricted due to an increase in mucus production and can decrease in size. When the bronchial tubes decrease in size and the patient is breathing, it is going to take more pressure to move the air into the swelled bronchi. If the radius of a patient’s bronchial tubes increased by sixteen percent, the pressure to move oxygen into the lungs would double. Therefore, a patient with bronchial smooth muscle constriction of sixteen percent would have to double their driving pressure to keep a constant flow rate. If swelling occurs and the patient does not increase their pressure, the amount of oxygen they are getting to their lungs will decrease. Respiratory therapists can see this taking place in patients with asthma that have excess mucus secretions.

I took the graduated cylinder and started filling it up with water until the bottom of the meniscus was to the the 100.0 mL mark with the assistance of a dropper pipet. I then took the 13 x 100 mm test tube and slowly poured the water from the graduated cylinder into the test tube until it was full to the top. I then poured the water in the test tube out into the sink and put the graduated cylinder on the counter so I can get an accurate measurement of the lower meniscus to record on my data table. I once again followed the same procedure again filling a second test tube with water from the graduated cylinder then setting it on a straight surface to get an accurate measure of the volume to

A sample of gas is trapped in a sealed container, which has a movable lid. Moving the lid up or down will change the volume inside the container. You will use an attached manometer to measure the pressure inside the container.

Measure 500ml of tap water in the 500cm3 beaker, then measure 5g of sodium hydrogen carbonate using the 50cm3 beaker and weight scale and place in the beaker of water, using the glass rod to dissolve it into the mixture.

Since a graduated cylinder is usually used for liquid measurement, students think they need to put water in the cylinder. This is not

The purpose of arterial pressure and the pulse lab is to determine the effect of posture and exercise on systolic and diastolic pressure and the heart rate. And also in order to find the differences in the reading taken under these condition compares to the baseline reading. The Sphygmomanometer and stethoscope are used to measure the systolic and diastolic blood pressure, counting the beat on the radial artery will give the reading for pulse rate and by using the lab scribe software and IWX214, the blood pressure will be measured. In the heart, the aorta and the carotid arteries have baroreceptors and the chemoreceptors that identify the changes in arterial pressure and the changes in

The volume of a small test tube and a thin-stemmed pipet were determined in this section of the lab. Water was poured into a small test tube until the water reached the very top edge of the test tube. The test tube was then emptied into a plastic 25 mL graduated cylinder and volume was measured and recorded into data table 3. A think-stemmed pipet was completely filled with water. Drops were carefully counted and emptied into the empty plastic 25 mL graduated cylinder until the water level reached 1 mL. The number of drops in 1 mL was recorded into data table 3. The thin-stemmed pipet had a total volume of 4 mL and that was also recorded into data table 3.

Both the orifice and the Venturi meters produce a restriction in the flow and measure the pressure drop across the meter. The velocity of a fluid is expected to increase as the fluid flows from an open area, to a more constricted area. Assuming incompressible flow, a negligible height change, and steady state, Bernoulli’s equation can be simplified to show the correlation between the volumetric flow rate and the pressure drop. The equation for both meters is as follows:

Submerge the graduated cylinder in the plastic tub so that it is completely filled with water. Hold the open end of the graduated cylinder and move it vertically upside-down where the open end of the graduated cylinder is still submerged in the plastic tub. Clamp the graduated cylinder the ring stand of the lab table to keep it in place. perforate a hole in the top of the rubber cork for the solution container. Cut a straw the length of about four inches. place the straw inside of the rubber cork hole. Set up your timer for two minutes.

Robert Boyle, a philosopher and theologian, studied the properties of gases in the 17th century. He noticed that gases behave similarly to springs; when compressed or expanded, they tend to ‘spring’ back to their original volume. He published his findings in 1662 in a monograph entitled The Spring of the Air and Its Effects. You will make observations similar to those of Robert Boyle and learn about the relationship between the pressure and volume of an ideal gas.

A volumetric pipette & measuring cylinder can be calibrated by just weighing the water they deliver. As for volumetric flask, the weight of an empty flask is recorded. Next, weigh the flask after filling it with water to the mark.

If the solution contains only sucrose then the osmotic pressure will increase substantially. This would represent a hypotonic solution because more water molecules are entering the cell meaning the solution contains no invertase. If the osmotic pressure has a slight increase than the solution contains sucrose and invertase due to the rate of the sucrose being broken down, however the cell will overtime begin to shrink. If the osmotic pressure remains close to the same than the solution contains no sucrose, containing only water and invertase. We predicted that because the height of the fluid in the osmometer tubing was increasing only a little bit our blue solution was hypertonic and contained invertase and sucrose. The invertase was able to break down sucrose into glucose and fructose which were small enough to be able to leave the cell membrane. This would reflect a hypertonic solution. We predicted this would cause the cell to shrink in size and the height of the fluid would never increase.