S. Agalactiae Lab Report

The colonies were smooth, translucent, and had a white brownish color. The Gram stain resulted in Gram positive cocci. After the Gram stain was completed, the bacteria were streaked on a Mannitol-Salt Agar plate and a Catalase test was performed. After these test were completed a Phenol Red Dextrose Fermentation tube was inoculated, and a SIM Tube inoculated.

The next step of the project included preparing a Gram stain to discover the cell shape, arrangement, and if the bacteria is gram positive or

Table 3 shows Gram stain results that indicated C. Freundii as a gram negative bacterium in rod shapes scattered in singles and some in pairs. Each gram stain produced the same results. The Bartholomew and Mittwer method of endospore staining indicated that C. Freundii tested negative for endospore formation. Table 4 shows the biochemical test results of the unknown and the official test results for comparison.

Preliminary studies help identify Genus species of bacteria. Two different preliminary study pathways must be used since two different pathogens were found in the sample. A dilution and a quadrant streak are the ideal methods to separate pure cultures of bacteria. MacConkey Agar and CAN (MAC) is a selective media that is used for the cultivation of gram negative bacteria. (PEA) is a selective media that is used

This lab experiment was done for the purpose of learning how to determine a gram negative bacterium based on multiple tests learned throughout the semester. My gram negative unknown bacterium given to me was Salmonella typhimurium based off of the following tests; Triple Sugar Iron Agar (TSIA), Sulfate Indole Motility (SIM), Methyl Red (MR), Voges-Proskaur (VP), Citrate, Urea Hydrolysis, and Gelatin Hydrolysis. Each test performed gives results such as motility, acid production, fermentation, carbon requirements, or detection of certain coenzymes. With a process of elimination, I determined which bacteria it was not and which bacterium I had, S. typhimurium. The expectation was to master the techniques for each test and utilize the results to determine the unknown bacterium I was given within a two-week period.

In this experiment, an unknown bacterium was given to each individual student. The main purpose of this lab was to identify the given unknown bacteria going through a series of biochemical tests as one of the gram negative bacteria among six different Gram negative bacteria Escherichia coli, Enterobacter aerogenes, Klebsiella pneumoniae, Proteus mirabilis, Pseudomonas aeruginosa and Salmonella typhimurium. At the very beginning, streaking method; T-streak technique was used to isolate the pure colonies. For the morphological identification of unknown bacteria, Gram Stain Method was done. Biochemical tests that were conducted for the experiment

Two smears of the unknown bacterium #5 were inoculated while the second smear was used for a back up. The unknown bacterium dried for at least forty minutes. After the smears dried, the slides were heat fixed two times to ensure the stability of the organism. The slide was placed on top of the staining rack then over the small sink.

The purpose of this lab was to identify an unknown microorganism using lab techniques. The importance of identifying microorganisms is essential to the survival of humans, expansion of modern day medicine and improvement of quality of life. In 1884, Hans Christian Gram designed a differential staining technique to identify bacteria that would change the future of microbiology. He give rise to a staining process, known as the Gram stain to differentiate microorganisms into two groups between positive and negative gram staining microorganisms. The Gram stain is essential in a lab technique as it distinguishes the cells based on the physical properties of the individual cell walls, and is almost always the first test preformed to differentiate a microorganism. The identification of weather a microorganism is gram positive or negative can revel the bacteria’s virulence, cell wall structure, resistance to antibiotics, resistance to physical disruptions and so much more. In order to identify the unknown provided, unknown #27, the Gram stain was the first test preformed. After discovering that the unknown bacterium was indefinitely a gram positive microorganism, the vast possibilities were narrowed down. However, In order to more definitively identify the unknown, the next step was to preform biochemical tests. A biochemical test identifies metabolic

The unknown plate acted as the stock master plate, and was used to aseptically streak the unknown for isolation and was incubated at 37°C for 24 hours. After the incubation, a Gram stain was performed. Using an inoculating loop, a drop of DI water was placed on a clean slide, and a sample of bacteria was aseptically transferred and mixed in the DI water. The slide air dried for a couple of minutes, and was then heat fixed to keep the bacteria on the slide. Using a staining tray to hold the slide, 2 drops of crystal violet dye was placed on the dried bacteria and allowed to sit for 2 minutes (2). After the CV was set, DI water was used to rinse off any remaining dye. The smear was covered in Gram’s iodine for 1 minute. After a minute the iodine was rinsed off and the slide was tipped to the side to allow 2-3 drops of ethanol decolorizer to remove any remaining purple coloring. The slide was rinsed again, and the smear was covered with safranin for 30 seconds. After 30 seconds the slide was rinsed off and blotted dry with bibulous paper (2). The smear was then observed under a microscope to determine gram nature and

The bases of this experiment was to discover the identify of the unknown from three possible specimens: Klebsiella pneumonia, Escherichia coli, and Enterobacter aerogenes. Utilizaing the T streak technique, the bacteria was isolated into pure colonies for further study. The Gram Stain method was used to identity the morhphology of the bacteria such as the shape and whether the bacteria was Gram positive or Gram negative. Biochemical test were also used to help identify the unknown bacteria. The biochemical test used was the Triple Sugar Iron Agar, Sulfur Indole Motility test, Methyl Red test, Voges-Proskauer test, Citrate test, Urease test, and the Gelatin test. After observing the morphology of the bacteria using the Gram Stain method and utilizing all the possible biochemical test, the bacteria was identified to be Enterobacter aerogenes.

Plate B incubated at 25oC produced a white, opaque, waxy, and spreading bacteria colonies while plate A incubated at 37oC produced a white, thin spreading bacteria colonies (Figure 1.). Gram staining revealed that plate B contained a rod-shaped bacterium having partial pink and purple coloration with endospores. This suggests that the bacteria is a gram positive bacteria. Gram positive bacteria typically have a thick cell wall which traps the crystal violet making them appear purple. Conversely, plate A is a rod-shaped bacterium but with pink coloration.

A great deal of cultural tests and physiological procedures were performed on the unknown before the conclusion of P. aeruginosa was made. The first test preformed was Gram’s staining which involves the use of crystal violet, Gram’s Iodine, Ethyl Alcohol, and Safranin. Gram staining is known as a differentiating stain, since it can determine the presence or absence of peptidoglycan in the cell wall. The unknown bacteria were Gram stain negative. After that the motility of the cell was tested using a hanging drop slide. The slide was examined, but the results were inconclusive due to the inability to make a clear distinction between motility and Brownian motion. This test was not

We conducted this experiment to identify an unknown gram-negative bacteria, the potential unknowns are Escherichia coli, Enterobacter aerogenes, Klebsiella pneumoniae, Salmonella typhimurium and Proteus mirabilis. The unknown bacteria was analyzed with various biochemical test, which are the methyl red test, the citrate test, the gelatin hydrolysis test, the Voges-proskauer test, the urea hydrolysis test, the sulfur indole motility test and the triple sugar iron agar test. It was determined that the unknown bacteria was salmonella typhimurium.

The gram stain result showed that my unknown was a pink long individual rods this means that it is a gram negative bacilli. The growth on the agar of unknown appear off-white with straight growth and the broth growth was uniform fine turbidity. Uniform fine turbidity means there is cloudy growth throughout the test tube. As time progressed the broth appeared clear with some sediment. This could suggest that the bacterium is a slow grower or that the cells are older and dying. This can affect the results of testing. We did to place an agar slant and broth tube in the incubator for 48 hours at 25 degrees Celsius to see if the temperature affects the growth. The agar slant looked the same as agar slant that was grown at 37 degrees Celsius. The broth that was incubated for 48 hours at 25 degrees Celsius did suggest that it was able to grow better at this temperature being the growth in tube with the thick white clunks floating throughout and the uniform fine turbidity.

First presented in the 1960’s, Streptococcus algalactiae was originally found in bovine. (American Society for Biology, 2005) It is a Gram positive cocci bacterium that is often called Group B Strep. It is now more commonly found in humans than in bovine. According to the American Pregnancy Association, 1 in 4 women naturally have Group B Strep in their genitourinary and GI tract. (American Cancer Society, 2017.)