Salinity Experiment Essay

because each of the objects displaced the water by 1 mL, their mass over that mL is their density.

Density is the amount of matter per unit of measurement (Merriam-Webster. Merriam-Webster, n.d. Web. 26 Aug. 2016.). If water has a density of 1.0 g/mL and you place a substance with a density of 1.8 g/mL the substance will sink because it is denser than water. Density is often measured in g/cm^3 or g/mL because the formula for density is D=m/v.

The purpose of this experiment was to determine the percent by mass in a hydrated salt, as well as to learn to handle laboratory apparatus without touching it. The hydrated salt, calcium carbonate, was heated with high temperature to release water molecules. Gravimetric analysis was used in this experiment to determine the percent by mass of water in a hydrated salt. The hypothesis of this experiment was accepted on the basis that the percent by mass of volatile water in the hydrated salt would be fewer than 30%. The percent by mass was determined by the mass of water loss devised by the mass of hydrated salt multiplied by total capacity

The purpose of this experiment was to see if a penny could hold more drops of salt water or tap water. It was found that a penny could hold an average of 22.3 drops of tap water and only 20.8 drops of salt water. These results are consistent with the hypothesis: If the salt concentration of water impacts the amount of water a penny holds, then the penny will hold less drops with salt water. While dropping the water onto the penny, it was observed that the water formed into a dome-like shape on the penny. It looked like the individual drops of water turned into one large drop of water. This was observed for both the tap and salt water. This happened due to the cohesion and surface tension of water. Cohesion simply means that water molecules are attracted to each other and want to cling together. Surface tension is the special term that is applied to the cohesion of water molecules.

Purpose: The purpose of this lab is to familiarize you with osmosis and, specifically, what happens to cells when they are exposed to solutions of differing tonicities.

Table 1 shows the contents of the bags and the content of the concentration it was submersed in. Bags 2-4 each contain a solution of both sucrose and water. These bags were each put into beakers containing hypertonic solution. These bags gained weight over time because the water moved from its high concentration inside the beaker to the low concentration inside the membrane of the artificial cell, the membrane being the bags that consisted of dialysis tubing. The

The purpose of this experiment was to find the amount and percent of water in a hydrated salt. Hydrated salt contains water molecules chemically bound to it while anhydrous salt is a substance that fire can readily remove the water molecules. Using the gravimetric analysis method, the sample salt was measured, heated, and was measured again after cooled down to room temperature; this procedure allowed the weight of water lost in the salt to be obtained. After two trials, the water in the salt was determined to have an average percent water of -35.04%. The null hypothesis, the heat will not affect the amount of water lost, was rejected ,however, the alternative hypothesis, the heat will allow for there to be water lost, was not supported.

To begin, did you know tin foil can float with pennies? Rapping tin foil like a boat and putting pennies in the boat. I can see how strong tin foil is and what brand is the best. Buoyancy the ability or tendency to float in water or air or some other fluid.

In Measuring and Understanding Density, several experiments were performed to find density of regularly shaped objects, irregularly shaped objects, liquids and gasses. An additional experiment was done to find the specific gravity of a sampling of liquids. The purpose of the experiment was to provide a better understanding of density and to be able to extrapolate unknowns based upon these calculations. The experiments yielded data in keeping with Kinetic-molecular theory in regards to the density of water versus its temperature. Key measurements and formulae were also used to determine densities of metal and plastic objects as well as irregularly shaped rocks. It is possible to find the density of an object (be it liquid, gas or

When salinity increases, warning signs appear in the landscapes of the affected areas. These warning signs include things like sick and/or dying trees, declining vegetation, colonisation of tolerant weed-like plants, bare patches where vegetation has died and saline pools in creek beds. These show that the ecosystem is being affected and at a high rate.

(Salton Sea Symposium, 1998) However , the condition of the Sea has drastically changed and so has the amount of healthy living organisms in the Sea. By the 1980�s the water level rose greatly and gave way to abandoned businesses, deteriorating structures and empty beaches. The above was due to the fact that evaporation is the only outlet to the Salton Sea , in fact 1.35 million acre feet of water is lost each year , thus increasing its salinity even more. The salinity of the Salton Sea has increased to 45,000 parts per thousand or 45 PPT; the Pacific Ocean is currently 35 PPT.

The following hypothesis was made in regard to effect of the concentration gradient on the rate of diffusion: The higher the concentration gradient, the faster the rate of diffusion.

1. What is the composition of seawater? The salinity of seawater ranges from 3.3 to 3.7%. When seawater evaporates it leaves behind sodium chloride, better known as table salt. The other components of seawater are acquired through various methods. One of which is weathering. Chemical weathering of rock releases soluble such as salts of sodium, potassium, and sulfur.

Osmosis is a special type of diffusion where water molecules move down a concentration gradient across a cell membrane. The solute (dissolved substance) concentration affects the rate of osmosis causing it either to speed the process up or slow it down. Based on this, how does different concentrations of sucrose affect the rate of osmosis? If sucrose concentration increases in the selectivity-permeable baggies, then the rate of osmosis will increase.

First I gather all my materials needed for the experiment (see materials list). Second I peel and slice potatoes weigh each potato in grams. Get these slices to weigh the same in mass because if they vary to much in mass that could affect the results of the experiment. Third I place each potato in its own beaker. Fourth once the potatoes are placed in beakers I make sure to place enough solution to fully cover the potato. Each beaker should have a different amount of