TLC Analysis of Analgesic Drugs

The goal of this experiment was to find out active chemical components in Anacin and Tylenol, using Thin Layer Chromatography technique. This technique uses the difference in the intermolecular forcer and polarity to separate mixtures. Comparing Rf values were then used to determine the active chemical components in the two analgesics. The overall result was that Acetaminophen exists in Tylenol and Acetylsalicylic Acid exists in Anacin.

Aspirin, Caffeine and Salicylamide were extracted from an over-the-counter pain reliever (BC Powder). These components were separated by manipulating their solubilities by adjusting the acidity and basicity of the solution. By doing this, the three components were forced into conjugate acid (or base) forms, causing selective solubility in either an aqueous or organic solvent. These layers were then separated by use of a separation funnel. Once separated, the components extracted were characterized by measuring the melting point and performing a TLC analysis. Also, the recovered aspirin from the first part of the experiment was recrystallized and compared to that of the

The unknown sample was identified to contain Acetaminophen, Aspirin, and caffeine based on comparison of known Rf values (Table 1). When comparing the traveled UV lit spots (figure 1), Aspirin and Ibuprofen traveled the same distance from the start line. Unknown sample 16 contains Aspirin not Ibuprofen, due to the intensity of the spot under UV light. Aspirin and the unknown shared that same intensity, whereas Ibuprofen did not share that same strength of brightness. The distance traveled by the samples was dependent upon their affinity for the mobile phase 200:1 ethyl acetate – acetic acid. The samples that traveled the furthest like the Aspirin and Ibuprofen were the most soluble in the mobile phase. The samples that traveled the shortest

Separation and Purification of the Components of an Analgesic Tablet. Cora Bruno, Lab Section E. Aspirin, Caffeine and Acetaminophen were separated from four analgesic tablets of Excedrin using extraction techniques. 5% wt/vol NaHCO3, 4M HCL, ethyl acetate and deionized water were used to separate the three active components. MgSO4 was used to dry each extraction. Aspirin was isolated using a hot water bath and weighed to determine the percent theoretical recovery and the actual percent recovery of aspirin. After separation, Aspirin (ASA), Caffeine (CAF), and Acetaminophen (ACE) were purified and identified using Thin Layer Chromatography (TLC). Standards and purified ASA, CAF, and ACE were spotted on the silica gel (stationary phase) of the

Discussion The third experiment of the semester involves identifying an unknown component of Panacetin, a common pain relief medication, separated and precipitated in the previous experiment. Although Panacetin’s label reports this third ingredient as Tylenol, there is controversy over the true classification of the third substance. This Panacetin label also reports that the unknown constituent makes up 50% of the composition of Panacetin, compared to aspirin’s 40% composition and sucrose’s 10% composition, meaning that it is currently unknown what half of the drug people ingest is identified as. Research results have failed to repeatedly show that the third component of Panacetin is Tylenol, which leads to the hypothesis

The purpose of this lab is to investigate the composition of a compound suspected to be Panacetin, a type of pain-killer. Panacetin is typically made up of sucrose, aspirin, and acetaminophen, but the third component in this experiment is unknown. The unknown component is suspected to be a chemical relative of acetaminophen, either acetanilide or phenacetin. Using techniques such as extraction, evaporation, and filtration, the three components will be isolated based on their solubilities and acid-base properties. Then, the percent composition of Panacetin can be deduced based on the masses of the three dried components. The

Pre-Lab: Analgesic drugs are known for reducing pain, while antiseptic drugs reduce symptoms such as fevers and swelling. However, some of these drugs can reduce both illnesses. To obtain a pure compound in these drugs, the scientist needs to separate the desired compound by taking advantage of the different physical and chemical properties. Such as; different boiling points, melting points and their solubility properties. To do this a chemist can also asses the differences between acidic and basic substances when they are added to water soluble mixtures. Within this current experiment I will asses the

The isolation of aspirin, acetaminophen, and caffeine from Excedrin utilized the differing acidities and polarities of the three compounds. Extraction involved separating the three components by reacting them with HCL and NaOH, while thin layer chromatography involved separating the isolated compounds on a TLC plate. The binder was the first component extracted; followed by aspirin, acetaminophen, and caffeine was extracted last since it is a neutral and polar compound. The entire process can be seen in figure 1. The most utilized methods of extraction were gravity filtration and vacuum filtration which are displayed in figures 3 and 4 respectively. These methods were utilized to separate compounds based upon their differing

In the first part, there may have been cross contamination of materials, especially since periods before us had already performed the experiment. During chromatography, our spot sizes were initially very varied, as we didn’t know exactly how much of each substance to place when we began. Thus, the substances in more abundance would have greater opportunity to travel up with the eluent, skewing the results. In the beginning, we even put 6-7 drops, causing some of the substances to mix together. Touching the TLC plate may also have disrupted some of the substances traveling up.

Components containing caffeine were composed into stock solutions. These solutions were diluted to 1: 10 substance: mobile phase. A stock solution of caffeine was diluted 1:50. A sequence of diluted caffeine solutions were prepared for use as a standard (ppm): 1, 2, 4, and 10. Solutions of acetaminophen, acetylsalicylic acid, and Goody’s Powder were developed to differentiate chromatographic peaks observed. These solutions were subjected to HPLC for examination of the observed peak area and retention time for the set of compounds. Comparison of retention time allowed for the differentiation of peaks observed. The peak area obtained was utilized to determine the relative concentration of caffeine present in Goody’s Powder based on the relationship obtained in the standard. The content of caffeine present in Goody’s Powder by percent weight was identified.

AIM: To extract codeine and paracetamol from its tablet by solvent extraction and tentatively identify in comparison to standards using Thin Layer Chromatography.

Alcohol plays a big part in prescription drugs because the person who is taking them may not get the "high" they want to achieve a better high then the last time. Some may decide to add alcohol in the mix. Alcohol is a legal drug within its self because the more the consumer drinks, their driving ability is impaired, it is hard to walk/talk, it can make the person sad or angry. The relationship between prescription painkillers and alcohol goes hand and hand because they both give you the same effect and can even lead to death.

Coal miners are affected as well since they will become injured, and most likely get addicted to the pain medication that is prescribed to them. According to the documentary, the prescription rate of painkillers is two times more than that in Miami or New York. While the norm in Appalachia is drug addiction, the majority of society “regard the consumption of too much of, or dependence on, a given substance a form of deviance” according to Goode (Goode, 179). Courtney’s mother explained that she took thirty to forty pain pills a day to properly function. Most people in society would refer to this as deviance. From drug addiction, there also comes physical characteristics that can change such as wrinkly skin, toothlessness, and anorexia that

Incorporation of assay controls included setting up a spectrophotomer and running the chart recorder with a full-scale deflection before the start of the assay. The set recorder had a corresponding value of 1 for the change in the absorbance. Therefore, prior testing was done to observe whether a change occurred in the readings. This helped to indicate that the results were valid, as they could have been affected by a fault during the setting up of the spectrophotometer. On the other hand this was considered as one of the controls for the experiment. Nevertheless, a new cuvette had to be used for each assay.

Microplate readers detect and process biological and chemical data using absorbance (ELISAs, enzyme activity, and nucleic acid and protein quantification), luminescence, and fluorescence detection modes, including intensity, TRF, and polarization. These lab workhorses are used in drug discovery, research, bioassay validation, and biopharmaceutical manufacturing.