Catechol Oxidase Lab Report

In this experiment, the 5mM catechol (substrate) reacted with catechol oxidase in the presence of 5 different pH buffers mentioned above. This experiment was used to measure the buildup of the colored product, benzoquinone, to observe the change in the absorbance of the mixture in a spectrophotometer at a wavelength of 486 nm. Ithypothesized that since each enzyme has an optimal pH and that the enzymes are proteins, the enzyme activity will increase with pH level and will be at its highest at pH 7, which is water. As seen in figure 1, absorbance is low pH 2 because catechol oxidase activity was minimal at low pH concentration due to the catechol oxidase denaturing in the acidic solution. The catechol oxidases also denatured at high pH concentration such as pH 11, which is a basic solution, lowering catechol oxidase activity and absorption. Catechol oxidase activity was highest at pH 8 making it an optimal pH for catechol oxidase to catalyze the reaction and create more product which in turn increased the absorption of blue

This experiment looked at how substrate concentration can affect enzyme activity. In this case the substrate was hydrogen peroxide and the enzyme was catalase. Pieces of meat providing the catalase were added to increasing concentrations of hydrogen peroxide in order to measure the effect of hydrogen peroxide concentrations on the enzyme’s activity. The variable measured was oxygen produced, as water would be too difficult to measure with basic equipment.

In the experiment we used Turnip, Hydrogen Peroxide, Distilled Water, and Guaiacol as my substances. On the first activity, Effect of Enzyme concentration of Reaction Rate for low enzyme concentration, we tested three concentrations of the turnip extract, and hydrogen peroxide. For the Turnip Extract I used 0.5 ml, 1.0 ml, and 2.0 ml. For hydrogen peroxide we used 0.1 ml, 0.2 ml, and 0.4 ml. We used a control to see the standard, and used a control for each enzyme concentration used. The control contains turnip extract and the color reagent, Guaiacol. We prepared my substrate tubes separately from the enzyme tubes. My substrate tube

The topic of this lab is on biochemistry.This experiment was conducted to show how cells prevent the build of hydrogen peroxide in tissues. My group consisted of Lekha, Ruth, and Jason. There were used two different concentrations of hydrogen peroxide through this experiment , 1.5% and 3%. By testing two different types it is easier to understand how the H2O2 and catalase react with one another. To do this both the yeast, which was our catalase, and H2O2 were mixed together in a beaker. Each concentration was tested out twice for more accurate results . 1.5% concentrated H2O2 had an average reaction rate of 10.5 seconds while 3% concentrated H2O2 had an average reaction rate of 7.5 seconds. From this experiment we learned that by increasing the concentration of H2O2 and chemically combining it with a catalase it will speed up the reaction. Enzymes speed up chemical reactions . The independent variable in this experiment was the concentration of the H2O2. Some key vocabulary words are Catalase, enzyme, hydrogen peroxide ( H2O2), and concentration.

The human body is an incredible system that is capable of working a multitude of diverse functions. Without the help of the many different protein molecules, the human body would not be able to function properly. One major group of proteins called enzymes are mandatory for essential life. These proteins are constantly at work assembling molecules, metabolizing energy, and fighting off infections. An enzyme is a macromolecule that acts as a catalyst that speeds up a chemical reaction without being consumed by the reaction. Without these proteins, these reactions would take place too slowly to keep us alive. Essential parts in your body like vitamins and minerals cannot do any work without

The role of an enzyme is to catalyse reactions within a cell. The enzyme present in a potato (Solanum Tuberosum) is catechol oxidase. In this experiment, the enzyme activity was tested under different temperature and pH conditions. The objective of this experiment was to determine the ideal conditions under which catechol oxidase catalyses reactions. In order to do this, catechol was catalyzed by catechol oxidase into benzoquinone at diverse temperatures and pH values. The enzyme was exposed to its new environment for 5 minutes before the absorbance of the catechol oxidase was measured at 420 nm using a spectrophotometer. The use of a spectrophotometer was crucial for the collection of data in this experiment. When exposed to hot and cold temperatures, some enzymes were found to denature causing the activity to decrease. Similarly, when the pH was too high or low, then the catechol oxidase enzyme experienced a significant decrease in activity. It can be concluded after completing this experiment that the optimal pH for catechol oxidase is 7 and that the prime temperature is 20º C. Due to the fact that the catechol oxidase was only tested under several different temperatures and pH values, it is always possible to get a more precise result by decreasing the increments between the test values. However, our experiment was able to produce accurate results as to the

Lab six requires students to observe the effects of pH and enzyme concentration on catecholase activity. Enzymes are organic catalysts that can affect the rate of a chemical reaction depending on the pH level and the concentration of the enzyme. As pH comes closer to a neutral pH the enzyme is at its greatest effectiveness. Also at the absorbance of a slope of 0.0122 the enzyme is affected greatly. The pH effect on enzymes can be tested by trying each pH level with a pH buffer of the same pH as labeled as the test tube and 1mL of potato juice, water, and catechol. This is all mixed together and put in the spectrophotometer to test how much is being absorbed at 420nm. As the effect on enzyme concentration can be tested almost the same way. This part of the exercise uses different amounts of pH 7-phosphate buffer and potato juice, and 1mL of catechol mixed together in a test tube. Each substance is put in the spectrophotometer at a wavelength set tot 420nm. The results are put down for every minute up to six minutes to see how enzyme concentration affects reaction rate. The results show that the pH 8 (0.494) affects the enzyme more than a pH of 4 (0.249), 6 (0.371), 7 (0.456), and 10 (0.126). Also the absorbance is greatest at a slope of 0.0122 with test tube C that has more effect on the reaction rate, than test tube A, B, and D.

Question: How does changing enzyme concentration or temperature affect the reaction time of enzyme activity?

If different amounts of enzyme solution are added to the hydrogen peroxide, then the highest amount of enzymes will have the greatest reaction rate because enzymes catalyze reactions, meaning more oxygen will be produced quicker.

There were three test tubes in which the experiment was held. A relatively equal sized portion of raw potato (this contained the enzyme [a biological catalyst] hydrogen peroxidase) was placed in each tube. Then, enough water to cover the potato was added. Proceeding this, each of the test tubes were assigned a temperature; cold, room temperature or warm (this was written on the tag so that they were not confused). The test tube destinated ‘cold’ was placed in a ice bath for five minutes. At the same time, the ‘hot’ test tube was placed in a hot water bath for five minutes. Meanwhile, the room temperature test tube sat at room temperature for five minutes. When the five minutes were over, the test tubes were returned to the rack (so that they were able to be observed). Then, the test tubes were allowed to sit at room temperature for five more minutes. Once that period of time was over, 2 ml of hydrogen peroxide (the substrate) was added to each tube.

Within the experiment, pure catechol was mixed with different concentrations of catechol oxidase and the rate at which each solution produced benzoquinone was measured. The amount of benzoquinone made throughout the trials was measured by using a colorimeter to measure the level of “brownness” of the liquid. The colorimeter worked by shining a light through the liquid and then measuring that light on the other side to see how much of it was absorbed. In this experiment, absorbance of blue light was measured because blue light is absorbed by the color brown. The amount of blue light absorbance was measured every 15 seconds for five minutes. Because enzymes speed up reactions, more enzymes would cause the reaction to be even faster.1

PURPOSE: Measure the effects of changes in catalase concentration, substrate concentration, and salinity on the reaction rates of an enzyme.

I forecast that the more concentrated the hydrogen peroxide is the higher the volume of

The experiments involved PH buffers of different pH were added to potato juice, water, and the enzyme catecholase. The mixture was then subjected to spectrophotometer at a wavelength of 420nm taking the absorbance readings. In the second experiment, a phosphate buffer of PH 7.0 was used in different measures together with different measurement of potato juice and the enzyme catecholase then subjected to the spectrophotometer at a wavelength of 420nm. The data collected inform of table and analyzed using descriptive statistics such as line graph and later interpreted, showing that PH and enzyme concentration do affect the rate of enzyme reaction

This investigation was conducted to answer the question: How will the concentration of enzyme affect the reaction? The enzyme used in this investigation was peroxidase. The enzyme concentration was changed by making the enzyme more concentrated than was it is.The effect of enzyme concentration on the reaction was measured by the color change per minute. The purpose was using the original procedure as the control group. The dependent variable was used by