The Effect Of Low Ph On Enzyme Activity

Amylase experiment # 2 was done to see how the pH affected the efficacy of the enzyme. First we collected all of the materials that were necessary to make this experiment. We needed five clean test tubes, the following standard solutions, 1% Starch Solution pH 3,1% Starch Solution pH 5,1% Starch Solution pH 7,1% Starch Solution pH 9,1% Starch Solution pH 11

The practical was carried out to investigate the effect of pH on the reaction of the enzyme acid phosphatase.

These results shown from this experiment led us to conclude that enzymes work best at certain pH rates. For this particular enzyme, pH 7 worked best. When compared to high levels of pH, the lower levels worked better. The wrong level of pH can denature enzymes; therefore finding the right level is essential. The independent variable was the amount of pH, and the dependent being the rate of oxygen. The results are reliable as they are reinforced by the fact that enzymes typically work best at neutral pH

Background and Introduction: Enzymes are proteins that process substrates, which is the chemical molecule that enzymes work on to make products. Enzyme purpose is to increase the rate of activity and speed up chemical reaction in a form of biological catalysts. The enzymes specialize in lowering the activation energy to start the process. Enzymes are very specific in their process, each substrate is designed to fit with a specific substrate and the enzyme and substrate link at the active site. The binding of a substrate to the active site of an enzyme is a very specific interaction. Active sites are clefts or grooves on the surface of an enzyme, usually composed of amino acids from different parts of the polypeptide chain that are brought together in the tertiary structure of the folded protein. Substrates initially bind to the active site by noncovalent interactions, including hydrogen bonds, ionic bonds, and hydrophobic interactions. Once a substrate is bound to the active site of an enzyme, multiple mechanisms can accelerate its conversion to the product of the reaction. But sometimes, these enzymes fail or succeed to increase the rate of action because of various factors that limit the action. These factors can be known as temperature, acidity levels (pH), enzyme and/or substrate concentration, etc. In this experiment, it will be tested how much of an effect

Lab six requires students to observe the effects of pH and enzyme concentration on catecholase activity. Enzymes are organic catalysts that can affect the rate of a chemical reaction depending on the pH level and the concentration of the enzyme. As pH comes closer to a neutral pH the enzyme is at its greatest effectiveness. Also at the absorbance of a slope of 0.0122 the enzyme is affected greatly. The pH effect on enzymes can be tested by trying each pH level with a pH buffer of the same pH as labeled as the test tube and 1mL of potato juice, water, and catechol. This is all mixed together and put in the spectrophotometer to test how much is being absorbed at 420nm. As the effect on enzyme concentration can be tested almost the same way. This part of the exercise uses different amounts of pH 7-phosphate buffer and potato juice, and 1mL of catechol mixed together in a test tube. Each substance is put in the spectrophotometer at a wavelength set tot 420nm. The results are put down for every minute up to six minutes to see how enzyme concentration affects reaction rate. The results show that the pH 8 (0.494) affects the enzyme more than a pH of 4 (0.249), 6 (0.371), 7 (0.456), and 10 (0.126). Also the absorbance is greatest at a slope of 0.0122 with test tube C that has more effect on the reaction rate, than test tube A, B, and D.

The time in the water bath was also controlled to ensure that the enzymes were left to react for the same amount of time, making the experiment

pH levels are a factor, as most enzymes work in a alkaline environment ( Human body is alkaline based).

In part II of the lab six small glass tubes were obtained in a test tube rack. Ten drops of distilled water were then added to test tube 1, five drops to tubes 2-4, and no drops in tubes 5 and 6. Five drops of 0.1M HCl were added to test tube 5 and five drops of 0.1M NaOH to test tube 6. Five drops of enzyme were then added to all tubes except tube 1. Tube 3 was then placed in the ice bucket and tube 4 was placed in the hot bucket at 80-900C for five minutes, the remaining tubes were left in the test tube rack. After the five minutes five drops of 1% starch was added to every tube and left to sit for ten minutes. After ten minutes five drops of DNSA were then added to all the tubes. All the tubes were then taken and placed in the

Introduction: Enzymes are protein catalysts facilitating the conversion of substrates into products (Alexander and Peters, 2011). They go through a whole chemical reaction which starts off with the substrate and then ends up with a product. The only way this reaction can be adjusted or not even work is if they end up going through some sort of affect which only temperature and pH levels can do determining the environment. When enzymes are in an environment that is too acidic or alkaline, their chemical properties, sizes and shapes can become altered (Magher, 2015) Chemical modification of proteins is widely used as a too; to maintain a native conformation, improving stability (Rodriguez-Cabrera, Regalado, and Garcia-Almendarez, 2011) In this experiment, four trials were conducted and recorded every 15 seconds for 5 minutes in order to calculate the optimum levels and IRV.

Enzymes are high molecular weight molecules and are proteins in nature. Enzymes work as catalysts in biochemical reactions in living organisms. Enzyme Catecholase is found on in plants, animals as well as fungi and is responsible for the darkening of different fruits. In most cases enzymatic activities are influenced by a number of factors, among them is temperature, PH, enzyme concentration as well as substrate concentration (Silverthorn, 2004). In this experiment enzyme catecholase was used to investigate the effects of PH and enzyme concentration on it rate of reaction. A pH buffer was used to control the PH, potato juice was used as the substrate and water was used as a solvent.

In the exercise # 2 we observed the effect of substrate concentration, enzyme concentration, pH and temperature on enzyme activity. All the data showed that once potato extract was added to catechol and water the reaction varied dependent on the level of catechol. As in

Wear safety goggles to protect the eyes from any splashes and wearing gloves is recommended when handling acids and

Hypothesis: If we decrease the level of pH in the enzyme Amylase, it will not be able to denature the carbohydrates in the potato starch solution after 10 drops because enzymes are very sensitive to pH levels and lowering it too much will compromise its ability to break them down.

The objective of the lab was to examine the effects of environmental variables on the functions of an enzyme. To the point, an experiment was conducted to test the effect of pH on the function of the enzyme Amylase.

Amylase is an enzyme that is in human’s saliva as well as the pancreas. Enzymes are biological catalysts that speed up a chemical reaction. They break down complex molecules into simple ones. In this case, amylase converts starches (complex molecule) into simple sugars. That is why foods like potatoes for example, may taste sweet to us, because they contain starch. The optimum pH for pancreatic amylase is the pH of 7. In the experiment I have used buffer solutions with the pHs of 2.8, 4 and 6.5. I have also used iodine and starch. Normally, iodine is orange-yellow, however when you add starch to it, the solution will turn blue-black.