Essay on The Ford Pinto Case

The moral issues about the Ford Pinto is that they take their profit is more important than human life. They also did not inform the consumer about the facts of the Pinto. Lastly, they also lobbied the safety of the car to lowest standard (Shaw, Barry & Sansbury 2009, pp 97-99).

The Ford automobile company began producing the Ford Pinto line up in 1968. The Chief Executive Officer (CEO) at the time of the pinto production was Lee Iacocca. The reason for the decision to mass produce the pinto in a short amount of time is because American automobiles were losing market share to smaller Japanese imports. Lee Iacocca wanted his engineers to design and manufacture a compact car that weighed less than 2,000 pounds and cost less than 2,000 dollars. Because of this monumental task from Lee Iacocca, that meant the ford pinto automobile would have to be built within 25 months instead of the typical 43 months. There are many safety test that is mandated by the National Highway Traffic Safety Administration before a vehicle

6. What responsibilities to its customers do you think Ford had? What are the most important moral rights, if any, operating in the Pinto case?

The customers (drivers of Ford) are the number one stakeholders that lost the most. They might not have lost much money or reputations, but they lost the one thing that you can never get back, their life.

There are many different cases where people have been critically injured or have died from burn-related injuries from the ruptured the Pino gas tank. This case study specifically discusses the 1978 untimely deaths of Lynn Marie Ulrich, Dana Ulrich, and Judy Ann. Between 1971 and 1978, the Pinto was responsible for a number of fire-related deaths. It was the death of these teenagers that lead brought the controversy of the Ford Pinto’s faulty gas tank placement to a climax resulting in criminal homicide charges for the automaker. Ford’s CEO Henry Ford II and Ford’s new president Lee Iacocca were responsible for the launch of the Ford Pinto. To stay ahead of the growing competition, The Pinto was not to weigh over 2,000 pounds and not costs not to exceed $2,000. Ford officials knew that the Pinto represented a serious fire issue when struck from the rear, but were desperate to expedite the vehicle’s release, the Pintos timing was set just under 25 months. Tooling has already been kicked off, so when crash tests revealed a serious defect in the gas tank, it was too late for any design modifications. The tooling was well underway. Therefore, Ford’s president decided it would be too costly to make changes in the Pinto’s gas tank location pushing ahead with the original design which went unchanged for six years. Any changes to the low-cost Ford Pinto would result in an increased price, thus possibly making it less desirable by small car buyers. Iacocca understood that people shopping for compact cars were watching every dollar, One Ford engineer explained, “the process of elasticity on these subcompacts is extremely tight. You can price yourself right out of the market by adding $25 to the production cost of the model”.

“Any customer can have a car painted any colour that he wants so long as it is black.” (Henry Ford). Henry Ford is one of the world’s most renowned leaders for the automobile industry. The son of a farmer, Ford has always been interested in how things worked. He has improved the models of his cars to make manufacturing them faster and more efficient by using assembly lines. He also set a balance between his employees’ wages and hours worked. Ford never stopped innovating and it is shown in his later Models of his car. Ford set standards for future motor companies and set standards for modern day manufacturing.

In 1908 Henry Ford had constructed the Model T; the time it took him to create this automobile was 13 days. Now eager to achieve more, Ford knew that he needed a place to construct these cars. He also knew that to sell mass amounts he would have to sell cheap, and buy parts and supplies even cheaper (Douglas, 25). The construction of the first Ford Motor plant used the world’s only conveyer belt. This was part of the Fords plan to build fast, when he constructed the assembly line cars were pumped out in as fast as 15 minuets, this was down from 19 days. Ford was able to make the automobile a car for everyman, a working man with a family.

There are a few concerns about harmful behavior of the FMC that should be discussed. A behavior is harmful when it wrongfully sets back the interest of others and has a high risk of harm. Obviously, the gravity of harm in this case is very high being that it is life threatening. Once a consumer has purchased the Pinto and drives it off the lot he is at risk to getting rear ended, and burned to death by a car fire or explosion. Since the weight of this harm is very severe, the low probability of the consumer having an accident doesn’t discount Ford’s unethical behavior. Indeed, driving a Ford Pinto would place a consumer’s life at risk. Also at stake are the interests of Pinto passengers and drivers of other vehicles who certainly are not willing to risk their lives so Ford can make an extra buck. Everyone has an interest in not getting injured or killed. Setting back the interest of consumers isn’t the only thing Ford Motor Company was responsible for.

Ford executives were under a great deal of pressure to produce a smaller, more gas efficient automobile. Japanese and German automobile sales were rapidly increasing. These competitive forces drove Ford’s executive team to respond by rushing the design process of the Ford Pinto. By 1973, the Pinto was well into production when engineers discovered a flaw in the gas tank, which was located just under the rear bumper. They discovered that if the vehicle suffered a rear-end collision over 20 mph, the gas tank could break and spill gasoline into the passenger compartment, potentially resulting in a fire. The remedy for the flaw was a part that cost $11.00 per vehicle. Executives at Ford knew the company had followed all safety standards and regulations. At that time, automobile safety standards only needed gas tanks to withstand a collision under 20 mph. An internal cost-benefit analysis revealed the costs would be substantially higher to fix the design flaw that the costs associated with any potential damages due to collisions and loss of life. The public remained unaware until Mother Jones journalist, Mark Dowie broke the story in 1977. Fueled by the media, what followed was a frenzy of public outcry and court trials.

The Elkhart County Grand Jury took up the matter and filed a charge of criminal homicide against Ford, the Automobile American Corporation that designed the Pinto car models. According to Elkhart County Grand prosecutor, Michael A. Cosentino, Ford was guilty of reckless homicide, because the company committed a conscious, plain, and unjustifiable neglect of harm that positioned the gas tank in the rear end of the car without proven protection. Besides, Ford engaged in negligence and substantial deviation from the acceptable standards of conduct. The major focus of the case entailed the expanding and assessment of acceptable standards the company violated in the process of manufacture of Pinto cars.

Ford has argued for over three decades that The Ford Motor Company is not at fault, but rather the other motorists who happened to rear end the Pinto drivers. Many accuse Ford of rushing the Pinto into production without proper testing leaving a faulty

The means were limited design time and reducing costs. By cutting costs, Ford knowingly created a product which could prove dangerous and fatal to its consumers. Does Ford’s ends justify its means? Ford did create a sub-compact that sold extremely well and competed fiercely with foreign imports. The goal of the Ford Pinto was met. The costs of this win were substantial however. The money that Ford tried to save by not recalling the vehicle was spent when Ford recalled the Pinto, and extra was spent in compensatory and punitive damages in lawsuits. So the costs that Ford tried to avoid were incurred anyway along with extra.

In Canada, individual regulating bodies are in place to licence and regulate practitioners in their respective professions. It is in the public’s best interest that these professionals are knowledgeable and driven to progress society in a responsible manner. This includes acting in an ethical manner that aligns with the personal and corporate standards expected of members in a particular profession. The Professional Engineers of Ontario (PEO) is in place to regulate such behavior among engineers and protect the common interest of the Ontario community. At the end of this paper it will be evident that public welfare is paramount. This will be shown by how it ought to be enforced under the PEO, and how failure of the Ford Pinto was fueled by

Ford Motor Company has tough competition with European and Japanese manufacturers, therefore the company did not respond well and suffered

The Ford Motor Company, founded in 1903 by Henry Ford, is synonymous with American innovation and capitalism. With iconic branding and revolutionary